Tutorials in Introductory Physics
1st Edition
ISBN: 9780130970695
Author: Peter S. Shaffer, Lillian C. McDermott
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 12.2, Problem 4bT
A second block, B,of the same size and shape as A but slightly greater mass is released from rest at the center of the beaker. The final position ofthis block is shown at right.
How does the buoyant force on block B compare Lo the buoyant force onblock A:
•at the instant they are released? Explain.
• at their final positions? Explain.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A cylindrical steel tank with a diameter of 20.0 cm, a length of 150.0 cm, and an overall mass of 150.0 kg is accidently dropped into a lake. What is the cylinder's density in g/cm3? Will it sink or float? Pure water has a density of 1 g/cm3. Show your work.
In (Figure 1), how much force does the fluid exert on the end of the cylinder at A? How much force does the fluid exert on the end of the cylinder at B?
Show your complete solution and round-off your finalanswer in the nearest thousandths (3 decimals).a. How much pressure will be measure at the bottom of thewater tank with a height of ℎ = 2? and a cross sectionalarea of ? = 785.398 ??2?b. How much pressure will be measure at the middle of thewater tank with a height of ℎ = 2? and a cross sectionalarea of ? = 785.398 ??2?c. If the diameter of the tank in the previous questions wereincreased twice but it height remain the same, what willhappen to pressure (a) at the middle of the tank and (b) atthe bottom of the tank?
Chapter 12 Solutions
Tutorials in Introductory Physics
Ch. 12.1 - For each layer, draw a free-body diagram in the...Ch. 12.1 - Imagine that a small hole is opened in the...Ch. 12.1 - Prob. 2aTCh. 12.1 - Suppose you wanted to determine the pressure at...Ch. 12.1 - Prob. 2cTCh. 12.1 - Prob. 2dTCh. 12.1 - Draw a freebody diagram for the small voulme of...Ch. 12.1 - Prob. 3bTCh. 12.1 - Use your answer to part B to compare the pressures...Ch. 12.1 - Prob. 3dT
Ch. 12.1 - Consider the following student dialogue: Student...Ch. 12.1 - Prob. 4aTCh. 12.1 - The right end of the tube is now scaled with a...Ch. 12.1 - A syringe is used to remove some water from the...Ch. 12.2 - A cubical block is observed to float in a beaker...Ch. 12.2 - Prob. 1bTCh. 12.2 - Imagine that you were to release the block from...Ch. 12.2 - In general, does the buoyant force on an object...Ch. 12.2 - By how much does the volume reading increase when...Ch. 12.2 - Does the volume of water displaced by a completely...Ch. 12.2 - Consider the following statement made by a...Ch. 12.2 - A rectangular block, A, is released from rest at...Ch. 12.2 - A second block, B,of the same size and shape as A...Ch. 12.2 - A third block, C, of the same size and shape as A...
Additional Science Textbook Solutions
Find more solutions based on key concepts
Your band needs a new guitar amplifier, and the available models range from 25 W to 250 W of audio power. Will ...
Essential University Physics (3rd Edition)
What is the role of “loose” electrons in heat conductors?
Conceptual Physics (12th Edition)
What is the greatest average speed of blood flow at 37° C in an artery of radius 2.00 mm if the flow is to rema...
College Physics
3. What is free-fall, and why does it make you weightless? Briefly describe why astronauts are weightless in th...
The Cosmic Perspective
16.What is the basic metric unit of weight?
Applied Physics (11th Edition)
The distance in terms of A when the mass moves in time T .
Physics (5th Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- In the diagram, 1. Why pressure at A is greater than the pressure at B? 2. Why the pressure in liquid at C is greater than the pressure in liquid at B? Explain in detail.arrow_forwardThe graduated cylinders shown here contain equal amounts of the different plant oils. Identical metal spheres were dropped at the same time into each of the tubes, and a brief moment later, the spheres had fallen to the heights indicated in the illustration. Rank the plant oils in order of increasing viscosity (lowest to highest), and explain your reasoning.arrow_forwardSolve the following problems. Show your complete solution and box your final answer. What is the absolute pressure, in SI unit, of a fluid at a gauge pressure of 1.5bar if atmospheric pressure is 1.01 bar?arrow_forward
- show all work in logical, detailed form and box in numerical answers. Include a diagram wherever possible. On any problem where an FBD is appropriate, it must be included for maximum credit. All numerical results should be stated to 3.00 or 4.000 significant figures and in mks units unless otherwise noted. Q: Estimate the buoyant force that you are experiencing, right now. You must do this quantitatively, so please use estimations about our size and shape that are reasonable for humans. Justify your choices diagrammatically. The density of air in your room is approximately 1.29 kg/m' and vou may ignore any variations due to temperature. Hint: pick a simple shape, or shapes, to represent you. (Vsphere = 4/3 r, Verldinder= Tr°h, and Vcube = laharrow_forwardImagine two blocks as shown in Figure 10A-1. The two blocks, with the same size bases, are resting on the horizontal surface of a table. Each block pushes down on the underlying surface with a force (weight) that is ______ the downward force exerted by the other block.a.different fromb.equal toc.twice By definition, pressure is the amount of force acting on an area of surface. Pressure is calculated by dividing the force exerted on a surface by the area over which the force is applied. The blocks weigh the same and their bases have the same area, so the two blocks exert ______ pressure on the underlying surface.a.half theb.the samec.twice thearrow_forwardA large tank has a tube coming out of it like a straw, as shown in the picture below. The tube of water is entirely full and closed at the end on the right, while the tank is open to the air. Rank the pressures at points N, U, C, L, E, A, and R (using <, >, and =). Explain your reasoning. How does the pressure at point R compare with the atmospheric pressure immediately outside of the straw? Explain your reasoning. Describe what would happen if you held the right end of the straw (near point R) in place and poked a hole in the end of it. (This is how a siphon works.) Explain your reasoning. (A video of you doing this experiment yourself could be submitted as evidence of your reasoning.)arrow_forward
- Which one of the entries below describe Torricelli's experiment ? Please choose one: a.Take two hemispheres of identical dimension, with leak proof flanges on the rim, close them onto each other and evacuate the air inside. Then apply a gradually increasing force to open and record the magnitude of the force that overcomes the atmospheric pressure and opens the hemispheres apart. b.Fill a bowl with mercury, dip a glass pipe into it while holding it vertical and measure the height of mecrury column starting from the bottom of the bowl. c.Fill a glass tube of length about a meter completely with mercury, close the tip with a finger, turn it upside down and dip the open end into a bowl of mercury. Then remove the finger, while keeping the pipe vertical and measure the distance between the surface of the mercury in the bowl and the top of the mercury column inside the tube. d.Take a vertical cylinder of about 20 cm diameter and 1 meter length, bottom end closed and fit a piston to it which…arrow_forwardPLEASE EXPLAIN CLEAR AND ELABORATELY. Figure 1: What have you noticed with the Buoyant Force and Object weight? Figure 2: What should be the relationship between the object density and fluid density in order for the object to sink?arrow_forwardPlease write neatly and make it readable. Do not type. At a depth of 10.9 km, the Challenger Deep in the Marianas Trench of the Pacific Ocean is the deepest site in any ocean. Yet, in 1960, Donald Walsh and Jacques Piccard reached the Challenger Deep in the bathyscaph Trieste. Assuming that seawater has a uniform density of 1024 kg/m3, a. approximate the hydrostatic pressure (in atmospheres) that the Trieste had to withstand. b. What is the absolute pressure on that depth (in kPa(a))?arrow_forward
- An object floats in water with 3/4 of its volume submerged. What is the ratio of the density of the object to that of water? Show your work. (a) 5/8 (b) 3/4 (c) 4/3 (d) 8/5 (e) None of the above.arrow_forwardPlease help me: Part (a) If the pressure is measured in compartment C at PC = 1.69 atm and compartment A is open to the atmosphere, what is the height difference H2, in centimeters, in the manometer between B and C? Part (b) What is the pressure in compartment D, in atm? Part (c) If we were to replace compartment C and the manometers around it with a single manometer that went right from compartments B to D, what would the height difference be in this new manometer?arrow_forwardObjects A, B, and C as shown have the same volume. Rank in order, from largest to smallest, the sizes of the buoyant forces FA , FB , and FC on A, B, and C. Explain.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSONIntroduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningLecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-WesleyCollege Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
University Physics (14th Edition)
Physics
ISBN:9780133969290
Author:Hugh D. Young, Roger A. Freedman
Publisher:PEARSON
Introduction To Quantum Mechanics
Physics
ISBN:9781107189638
Author:Griffiths, David J., Schroeter, Darrell F.
Publisher:Cambridge University Press
Physics for Scientists and Engineers
Physics
ISBN:9781337553278
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Lecture- Tutorials for Introductory Astronomy
Physics
ISBN:9780321820464
Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden
Publisher:Addison-Wesley
College Physics: A Strategic Approach (4th Editio...
Physics
ISBN:9780134609034
Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field
Publisher:PEARSON
The Laws of Thermodynamics, Entropy, and Gibbs Free Energy; Author: Professor Dave Explains;https://www.youtube.com/watch?v=8N1BxHgsoOw;License: Standard YouTube License, CC-BY