To assess photosynthesis, we relied heavily on a spectrophotometer to measure the color intensity of DCPIP in our solution. We set the spectrophotometer at wavelengths in the visible spectrum. What is the approximate wavelength range (in nm) for the visible spectrum? For example, the ultraviolet spectrum wavelength range is approximately 10-400 nm

To assess photosynthesis, we relied heavily on a spectrophotometer to measure the color intensity of DCPIP in our solution. We set the spectrophotometer at wavelengths in the visible spectrum. What is the approximate wavelength range (in nm) for the visible spectrum? For example, the ultraviolet spectrum wavelength range is approximately 10-400 nm

Biomedical Instrumentation Systems

1st Edition

ISBN:9781133478294

Author:Chatterjee

Publisher:Chatterjee

Chapter16: Fiber Optics And Lasers In Bioinstrumentation

Section: Chapter Questions

Problem 7P

See similar textbooks

Similar questions

At your work station, you have a spectrophotometer set at 600 nm to measure DCIP absorbance and four (4) test tubes containing different solutions. One of the test tubes is labelled “0” to blank/zero the spectrophotometer. The other three (3) test tubes contain a reaction mixture from a Hill reaction experiment using isolated chloroplasts and DCIP as an electron acceptor. DCIP is present in the oxidized state and exhibits a blue color with an absorbance at 600 nm. Upon receiving the electrons, DCIP is reduced to form DCIP-H2 that is colorless. These three (3) tubes, labelled “A”, “B”, and “C” were exposed to different light conditions during the Hill reaction. The Light conditions were random, including No light, Red light, and Green light. Please note that chlorophyll preferentially absorbs the light with wavelength of 660 nm (red) when compared to that of 520 nm (green). Your mission is to determine which Tube came from which experimental light condition. Tube: Tube…
100- 50- 400 450 500 550 600 650 700 Wavelength (nm) In the absorption spectrum shown above, what wavelength ranges are not efficiently absorbed by this photopigment? 400-450nm 450-700nm 450-650nm 650-700nm
At the beginning of the light reaction, light excites electrons. Explain.
DCPIP (2,6-dichlorophenol-indophenol), a blue dye, can act as an electron acceptor and becomes colorless when reduced. A suspension of chloroplasts is prepared, and DCPIP is added to the suspension. The sample is split into two test tubes. One test tube is exposed to light and the other is wrapped in foil (dark control). What would you observe over time comparing the light exposed and the dark control test tubes? A. The sample exposed to light stays blue. The sample kept in the dark turns colorless. B. The sample exposed to light turns colorless. The sample wrapped in foil stays blue. C. Both samples stay blue. D. Both samples turn colorless.
THE LIGHT DEPENDEN REACTION MUST OCCUR BEFORE THE LIGHT INDEPENDENT REACTION TRUE OR FALSE?
(g) The figure given below represents an experiment to demonstrate a particular aspect of photosynthesis. The alphabet 'A' represents a certain condition inside the flask. 2 КОН (i) What is the aim of the experiment ? (ii) Identify the special condition inside the flask. (iii) Name an alternative chemical that can be used instead of KOH. (iv) In what manner do the leaves 1 and 2 differ at the end of the starch test ?
List four products of the light reactions.
You will create a slide show/ Canva/ Website on the flow chart of photosynthesis phases .Your poster should include, but is not limited to:○ The overall equation is at the top.○ A diagram of a chloroplast which indicates where each reactant is used and whereeach product is synthesized. ○ All intermediary steps were studied in the light-dependent reactions and light-independent reactions, in the form of a flow chart(try to add details around them), using appropriate terminology. ● You will also submit a detailed explanation of your flow chart, using appropriateterminology.
Cyclic photophosphorylation uses two photons to generate one ATP. If the AG of ATP hydrolysis is -50 kj/mol. What is the percent efficiency of cyclic photophosphorylation? F =96.5 kj/mol*V. Use c AG = -nFAV ⒸShow Transcribed Text to solve.
Why do the reaction centers have different pigments rather than only the chlorophyls? quantitatively increasing the absorption photons narrowing coverage of the visible spectrum light increasing coverage of the visible spectrum light arranging light-harvesting complexe compensating for the high density of chlorophyll
An experiment was done to determine how color of light and distance affects photosynthetic activity of the pond weed. Pond weed was placed in a test tube containing a solution of sodium hydrogen carbonate, and had its end cut; light was placed 50 cm away and four colors were tested (clear, red, blue, and green). After placing the light, the pondweed was given a certain amount of time to adjust before counting the bubbles, bubbles were counted for 1, 3, and 5 minutes. Only the bubbles that came out of the cut end was counted to represent the rate of photosynthesis. Below is the tabulated results. What are the possible factors or errors that could have affected clear/white light to have lower photosynthetic activity? In theory this should have the highest rate.
In a photosynthetic investigation, a student measured the following pH of the stroma and the inner thylakoid compartments of spinach leaf cells at the conclusion of the experiment. Source of Fluid pH (mean) Standard Error of Mean (SEM) Stroma 8.2 0.75 Inner compartment of thylakoid 5.6 0.35 Explain the reason for the differences in pH between the stroma and the thylakoid lumen.