International Edition---engineering Mechanics: Statics, 4th Edition
4th Edition
ISBN: 9781305501607
Author: Andrew Pytel And Jaan Kiusalaas
Publisher: CENGAGE L
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 8, Problem 8.121P
One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A force of 460 N is exerted on level AB as shown. The end B is connected to a piston which fits into a cylinder having a diameter of 60 mm. What force Fd acts on the larger piston, if the volume between C and D is filled with water?
If the base of the triangles is below the surface of 20 degrees Celsius of water determine the hydrostatic force in kilo- newton on one side of the gate. The base and height of the triangular gate is equal to 4m and 3m respectively.
A cargo truck with a weight of 325 kn was raised using a hydraulic press. If oil acts on a piston with 412 mm diameter. Determine the pressure in kpa under the piston.
Chapter 8 Solutions
International Edition---engineering Mechanics: Statics, 4th Edition
Ch. 8 - Use integration to determine the coordinates of...Ch. 8 - Use integration to determine the coordinates of...Ch. 8 - Use integration to determine the coordinates of...Ch. 8 - Use integration to determine the coordinates of...Ch. 8 - Use integration to determine the coordinates of...Ch. 8 - Use integration to determine the coordinates of...Ch. 8 - Using integration, locate the centroid of the area...Ch. 8 - Determine the y-coordinate of the centroid of the...Ch. 8 - Determine the y-coordinate 0f the centroid of the...Ch. 8 - Use integration to locate the centroid of the...
Ch. 8 - Locate the centroid of the parabola by...Ch. 8 - Use integration to locate the centroid of the...Ch. 8 - The parametric equations of the plane curve known...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - Use the method of composite areas to calculate the...Ch. 8 - The plane region is bounded by a semicircle of...Ch. 8 - The centroid of the plane region shown is at C....Ch. 8 - Compute the centroidal coordinates of the L-shaped...Ch. 8 - Find the centroidal coordinates of the plane...Ch. 8 - Using the method of composite areas, find the...Ch. 8 - Given that the centroid of the plane region is at...Ch. 8 - Using the method of composite curves, locate the...Ch. 8 - Using the method of composite curves, locate the...Ch. 8 - Using the method of composite curves, locate the...Ch. 8 - Using the method of composite curves, locate the...Ch. 8 - Using the method of composite curves, locate the...Ch. 8 - Using the method of composite curves, locate the...Ch. 8 - Determine the ratio a/b for which the centroid of...Ch. 8 - Use numerical integration to locate the centroid...Ch. 8 - Determine the centroidal coordinates of the plane...Ch. 8 - Compute the centroidal y-coordinate of the plane...Ch. 8 - The equation of the catenary shown is y = 100 cosh...Ch. 8 - Use integration to locate the centroid of the...Ch. 8 - By integration, find the centroid of the surface...Ch. 8 - Locate the centroid of the volume obtained by...Ch. 8 - Solve Prob. 8.41 assuming that the triangle is...Ch. 8 - Use integration to find the centroidal coordinates...Ch. 8 - Solve Prob. 8.43 assuming that the area is...Ch. 8 - Verify the centroidal z-coordinate of the pyramid...Ch. 8 - Use integration to compute the z-coordinate of the...Ch. 8 - Determine the centroidal z-coordinate of the...Ch. 8 - Prob. 8.48PCh. 8 - Locate the centroid of the volume between the...Ch. 8 - Prob. 8.50PCh. 8 - Prob. 8.51PCh. 8 - By the method of composite volumes, determine the...Ch. 8 - By the method of composite volumes, determine the...Ch. 8 - By the method of composite volumes, determine the...Ch. 8 - By the method of composite volumes, determine the...Ch. 8 - By the method of composite volumes, determine the...Ch. 8 - By the method of composite volumes, determine the...Ch. 8 - Use the method of composite volumes to determine...Ch. 8 - The cylindrical container will have maximum...Ch. 8 - Using the method of composite surfaces, locate the...Ch. 8 - Using the method of composite surfaces, locate the...Ch. 8 - Using the method of composite surfaces, locate the...Ch. 8 - Using the method of composite surfaces, locate the...Ch. 8 - Using the method of composite surfaces, locate the...Ch. 8 - Using the method of composite surfaces, locate the...Ch. 8 - The picture board and its triangular supporting...Ch. 8 - By the method of composite curves, locate the...Ch. 8 - By the method of composite curves, locate the...Ch. 8 - By the method of composite curves, locate the...Ch. 8 - Use numerical integration to find the centroid of...Ch. 8 - Prob. 8.71PCh. 8 - Locate the centroid of the volume generated by...Ch. 8 - Prob. 8.73PCh. 8 - Prob. 8.74PCh. 8 - Prob. 8.75PCh. 8 - A 6-in. diameter hole is drilled in the conical...Ch. 8 - A torus is formed by rotating the circle about the...Ch. 8 - A solid of revolution is formed by rotating the...Ch. 8 - Compute the volume of the spherical cap that is...Ch. 8 - Calculate the surface area of the truncated sphere...Ch. 8 - The rim of a steel V-belt pulley is formed by...Ch. 8 - Determine the volume of the machine part shown.Ch. 8 - A solid is generated by rotating the plane area...Ch. 8 - Prob. 8.84PCh. 8 - Find the surface area of the 90 duct elbow.Ch. 8 - Determine the volume of the concrete arch dam.Ch. 8 - (a) Find the volume of liquid contained in the...Ch. 8 - Compute the surface area of the axi-symmetric...Ch. 8 - The steel cylinder with a cylindrical hole is...Ch. 8 - The hemispherical glass bowl is filled with water....Ch. 8 - What is the ratio L/R for which the uniform wire...Ch. 8 - Small screws are used to fasten a piece of...Ch. 8 - Prob. 8.93PCh. 8 - 3.94 The aluminum cylinder is attached to the...Ch. 8 - Prob. 8.95PCh. 8 - Prob. 8.96PCh. 8 - Prob. 8.97PCh. 8 - Locate the center of gravity of the hammer if the...Ch. 8 - Prob. 8.99PCh. 8 - The cylindrical water tank with R = 10 ft and H =...Ch. 8 - Prob. 8.101PCh. 8 - Five 34-in. diameter holes are to be drilled in a...Ch. 8 - Wind pressure acting on a cylinder can be...Ch. 8 - Prob. 8.104PCh. 8 - The pressure acting on the square plate varies as...Ch. 8 - Prob. 8.106PCh. 8 - Prob. 8.107PCh. 8 - If the intensity of the line loading is...Ch. 8 - Prob. 8.109PCh. 8 - The intensity of the line loading acting on a...Ch. 8 - Determine the resultant force or resultant couple...Ch. 8 - The inside surface of each thin shell carries a...Ch. 8 - Calculate the resultant force caused by the water...Ch. 8 - Determine the resultant force acting on the elbow...Ch. 8 - Determine the smallest distance I) that would...Ch. 8 - Each of the three gates has a constant width 1:...Ch. 8 - The concrete dam shown in cross section holds back...Ch. 8 - A concrete seawater dam is shown in cross section....Ch. 8 - Determine the force F required to pull up the...Ch. 8 - The normal pressure acting on the triangular plate...Ch. 8 - One side of the container has a 03-m square door...Ch. 8 - The 12-ft wide quarter-circular gate AB is hinged...Ch. 8 - The center of gravity of the plane wire figure is...Ch. 8 - The 10-m wide gate restrains water at a depth of 6...Ch. 8 - Find the resultant of the line load shown.Ch. 8 - Prob. 8.126RPCh. 8 - Determine the centroidal coordinates of the volume...Ch. 8 - Prob. 8.128RPCh. 8 - Prob. 8.129RPCh. 8 - Prob. 8.130RPCh. 8 - Using the method of composite areas, find the...Ch. 8 - Find the centroid of the truncated parabolic...Ch. 8 - Prob. 8.133RPCh. 8 - A solid of revolution is formed by rotating the...Ch. 8 - Two hemispherical shells of inner diameter 1 m are...Ch. 8 - Calculate the area of the surface generated when...Ch. 8 - Determine the resultant of the line loading, given...Ch. 8 - Determine the centroidal coordinates of the plane...Ch. 8 - The sheet metal trough has a uniform wall...Ch. 8 - The trough is filled with water (=62.4lb/ft3)....Ch. 8 - The thin-walled cylindrical can with a spherical...Ch. 8 - Find the location of the centroid of the shaded...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate and the smooth surface at B due to water pressure acting on the gate. Use =62.4lb/ft3 for water.arrow_forwardThe cylindrical water tank with R = 10 ft and H = 1.6 ft has thin steel walls of uniform thickness and weighs 18000 lb when empty. Determine the depth of the water h for which the center of gravity G of the tank plus water will be located at the surface of the water. For water, use =62.4lb/ft3.arrow_forwardDetermine the volume of the concrete arch dam.arrow_forward
- The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.arrow_forwardEach of the three gates has a constant width 1: (perpendicular to the paper). Calculate the force P required to maintain each gate in the position shown. Express your answers in terms of b, c, h, and (the weight density of the fluid).arrow_forwardFind the elevation h (km) where the weight of an object is one-tenth its weight on the surface of the earth.arrow_forward
- The 0.5-m-radius semi-circular gate is hinged through the top edge AB. Find the required force to be applied at the center of gravity to keep the gate closed.arrow_forwardA barrel in the form of a frustum of a cone with a radius of 3m and 6m at the bottom and at the top respectively. It is 5m high and is 4/5 full of oil (0.83). Determine the a. Total hydrostatic force "F" acting on the wall of the barrel in kN and b. its line of action "s" from the bottomarrow_forwardThe water-gate articulated in point B and inclined at an alfa angle to the horizontal retains an H level of water. The gate is blocked by a cable which is anchored in the lower part of the dam. It is required to determine the force necessary to open the gate. The width of the water gate is 1 m.arrow_forward
- A rectangular parallelepiped tank measuring 40cm x 30cm x 20cm is filled with water. Determine the force acting on each face of the tank if (a) it is open at the top and (b) closed at the top.arrow_forwardIn this way, ignore the weight of the cover. The circular cover is 4m wide and is hinged from A. Determine the component of the hydrostatic pressure force on the cover and determine the force F by assuming that the cover is in balance.arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
- International Edition---engineering Mechanics: St...Mechanical EngineeringISBN:9781305501607Author:Andrew Pytel And Jaan KiusalaasPublisher:CENGAGE L
International Edition---engineering Mechanics: St...
Mechanical Engineering
ISBN:9781305501607
Author:Andrew Pytel And Jaan Kiusalaas
Publisher:CENGAGE L
Physics 33 - Fluid Statics (1 of 10) Pressure in a Fluid; Author: Michel van Biezen;https://www.youtube.com/watch?v=mzjlAla3H1Q;License: Standard YouTube License, CC-BY