Modern Physics
3rd Edition
ISBN: 9781111794378
Author: Raymond A. Serway, Clement J. Moses, Curt A. Moyer
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 7, Problem 5Q
To determine
The process how a barrier whose width is
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A hydrogen atom (with the Bohr radius of half an angstrom) is situated between two metal plates 1 mm apart, which are connected to opposite terminals of a 500 V battery. What fraction of the atomic radius does the separation distance d amount to, roughly? Estimate the voltage you would need with this apparatus to ionize the atom.
d) Show that the resistivity canbe expressed (via the familiar notation) as,
m
p=
net
here m is the electronmass; † is the period of time that elapses between two
subsequent collisions, the electron undergoes with copper nuclei throughout
its chaotic motion in the body of copper (supposing that the current carrying
cable is made of copper). Hint: Write F=eE, i.e. the electric force reigning on
the electron. Write also the acceleration a=F/m, an electron is subject to,
based on the Newton's law ofmotion.
The induced electron flow in Situation A would be ___.The induced electron flow in SItuation B would be ____.
Knowledge Booster
Similar questions
- Explain what is meant by a hole in a semi-conductor, and why the effective mass of a hole can be negative.arrow_forwardsolve this Q step by step.arrow_forwardAn electron is moving in a piece of very lightly doped silicon under an applied fieldsuch that its drift velocity is one-tenth of its thermal velocity. Calculate the averagenumber of collisions it will experience in traversing by drift a region 1 μm long. Whatis the voltage across this region? Temperature= 300°Karrow_forward
- Consider two straight wires lying on the x-axis, separated by a gap of 4 nm. The potential energy in the gap is about 3 eV higher than the energy of a conduction electron in either wire. What is the probability that a conduction electron in one wire arriving at the gap will pass through the gap into the other wire? [Hint: Assume that the gap is very wide. Then, a right-moving electron incoming on the gap partially passes through the left edge of the gap and loses its amplitude exponentially fast. By the time it reaches the right edge, its reflection from the right edge can be neglected. Most of the particle wave at that point simply comes out of the gap and arries on in the second wire.]arrow_forward(a). A Si bar 0.1 um long and 100 u,m2 in cross-sectional area is doped with1017 cm- 3 phosphorus. Find the current at 300 K with 10 V applied.Repeat for a Si bar 1 fjun long,?(b). How long does it take an average electron to drift 1 |xm in pure Si at anelectric field of 100 V/cm? Repeat for 105 V/cm.?arrow_forwardYou put a diode in a microelectronic circuit to protect the system in case an untrained person installs the battery backward. In the correct forward-bias situation, the current is 200 mA with a potential difference of 100 mV across the diode at room temperature (300 K). If the battery were reversed, so that the potential difference across the diode is still 100 mV but with the opposite sign, what would be the magnitude of the current in the diode?arrow_forward
- (a) For indium phosphide (InP) at room temperature, calculate the electron and hole mobilities for the following cases : For intrinsic InP, the electrical conductivity, the number of electrons per cubic meter and the number of holes per cubic meter are 2.5 x 10-6 (22m)¹, 3× 10¹3 m -3 and 3 x 1013 m3, respectively. Similarly, for n-type extrinsic InP, the electrical conductivity, the number of electrons per cubic meter and the number of cubic meter holes per 3-6x 10-6 (2m), 4.5 × 10¹3-3 2 x 10¹3 m³, respectively. are andarrow_forwardGermanium doped with 1024 m Al atoms is a semi-conductor at room temperature and each Al atom creates a charge carrier. Calculate the electrical conductivity of this material at room temperature, considering that the electron and hole mobilities are respectively 0.1 and 0.05 m/V.s.arrow_forwardCheck Your Understanding If a=3+4i , what is the product a* a?arrow_forward
- Calculate the drift current in silicon at room temperature. If the intrinsic carrier concentration of (1x1016electron/m?) with the doping concentration of (2x1016atoms/m³) of the phosphorus and (1×1016atoms/m³) of Boron. Given the mobility for the electrons (0.15m2/V.s), the mobility for the holes (0.05m2/V.s), the electric field (100V/m), and the cross section area is 1mm?.arrow_forwardO:22) Use fermi approximation to determine the number of softballs that can fit in a 1 meter cube. Calculate the free space in a 1 meter cube box that is filled with softballs. State all assumptions.arrow_forwardb) What is the probability that a state 0.1 eV above the Fermi level is occupied by an electron at room temperature ? What is the same probability if that state is 1 eV above the Fermi level ?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Modern PhysicsPhysicsISBN:9781111794378Author:Raymond A. Serway, Clement J. Moses, Curt A. MoyerPublisher:Cengage Learning
University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStax
Modern Physics
Physics
ISBN:9781111794378
Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer
Publisher:Cengage Learning
University Physics Volume 3
Physics
ISBN:9781938168185
Author:William Moebs, Jeff Sanny
Publisher:OpenStax