Chemical Principles in the Laboratory
11th Edition
ISBN: 9781305264434
Author: Emil Slowinski, Wayne C. Wolsey, Robert Rossi
Publisher: Brooks Cole
expand_more
expand_more
format_list_bulleted
Question
Chapter 2, Problem 4ASA
Interpretation Introduction
Interpretation:
The total micrograms of
Concept introduction:
Chromatography is the technique used to identify the components of a mixture. The chromatography technique has the efficiency to segregate the mixture containing the different components. Every component has different polarity. The separation of mixture is based upon the polarity of the components present in the mixture.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
If this lab’s procedure were carried out using 28.06 mL each of 0.385 M K2CrO4 and 0.161 M Pb(NO3)2. How many mmol of K2CrO4 were present in the reagent solution
mix 500 ml of 0.1 M HCl solution with 300 ml of 2 M Ba (OH) 2 solution
a) indicate the environment of the solution after mixing
b) What color will the detectors, phenophthalein and litmus get?
You are given a solution that contains a mixture of the following cations: Ag+, Ba2+, Mn2+ and Cu2+.
Draw a flow chart to show how these cations are separated and indicate specific reagents used in each separation step.
Chapter 2 Solutions
Chemical Principles in the Laboratory
Knowledge Booster
Similar questions
- 1.50 mL of 0.15M Fe2(SO4)3 is diluted with deionized water to 25.00 mL in a volumetric flask. What is the concentration (in mg/mL) of iron (not Fe2(SO4)3) in the diluted sample? Please note that the units in this question are different than presented in the lab manual to avoid issues with exponents in a numerical answer. Of course if the units were in micrograms/g the results would be * 103 or (1000 times bigger).arrow_forwardThe voltage measured by the pH meter is linearly proportional to the "H+ concentration" of the analyte solution. True or false? Is H+ concentration correct?arrow_forward6. Given that the concentration of ascorbic acid is ~0.001 M in lemon juice, is this error significant? Why or why not?arrow_forward
- A water sample was analyzed for Fe content using the iron- phenanthroline method. The following data were obtained from the analysis: Reagent Blank Absorbance Absorbance (au) Reagent Blank Absorbance 0.003 Concentration of Stock Solution: 10 ppm Volume of Stock Solution (mL) Total Volume of Standard Solution Concentration of Standard Solution (ppm) Absorbance (au) (mL) 0.50 10.00 0.012 1.00 10.00 0.132 2.00 10.00 0.267 3.00 10.00 0.349 4.00 10.00 0.428 5.00 10.00 0.560 Volume of Unknown Solution Total Volume of Unknown Solution Trial Absorbance (au) (mL) (mL) 1 5.00 10.00 0.289 2 5.00 10.00 0.296 3 5.00 10.00 0.281 Determine the value of the slope (m), y-intercept (b), and the coefficient of determination (r²) A m = 0.1128; b = -4.0 x 10-5; r2 = 0.9880 B m = 0.1128; b = -4.0 x 10-5; r² = 0.9762 C) m = 0.1128; b = -3.0 x 10-³; r² = 0.9880 D m = 0.1128; b = -3.0 x 10-³; r² = 0.9762arrow_forward2+ as (6) A sample of an ore was analyzed for Cu* follows. A 1.25 g sample of the ore was dissolved in acid and diluted to volume in a 250 mL volumetric flask. A 20 mL portion of the resulting solution was transferred by pipet to a 50 ml volumetric flask and diluted to volume. An analysis showed that the concentration of 2+ Cu* in the final solution was 4.62 ppm. What is the weight percent of Cu in the original ore?arrow_forward1) Listen The Ksp value for calcium sulfate [CaSO4] is 2.40 X 10-5 so if a professor made 1825 mL of a CaSO4(ag) solution then how many grams of calcium (Ca2+) ion would be present in this solution. 0.3948 gram Ca2+ ion 0.4965 gram Ca2+ ion 0.2527 gram Ca2+ ion 0.4747 gram Ca2+ ion 0.3396 gram Ca2+ ion 0.2943 gram Ca2+ ion 1591.docx LAB EXP. #3 -.docx Show Allarrow_forward
- The thiourea (NH2)2CS in a 1.600 g sample of an unknown organic material was extracted into a dilute acid solution and was titrated with 42.50 mL of 0.0010 M Hg2+. Equation: 4 (NH2)2CS + Hg2+ → [(NH2)2CS]4Hg2+ Find the percentage thiourea present in the sample.arrow_forwardWhat is the difference between qualitative and quantitative analysis?arrow_forwardYou took 25.00 mL of unknown water solution and titrated it with EDTA. The EDTA solution molarity was 0.01 M, and it took 16.50 mL to reach the end point. With the blank it took only 0.98 mL to reach end point. 15.52 mL of EDTA solution were used to titrate hardness that actually came from the unknown 1.552×10−4 moles of EDTA reacted with hardness-causing ions from the unknown sample 1.552×10−4 moles of hardness-causing ions were present in the unknown sample A) Assuming that the total hardness of water is due to CaCO3, how many grams CaCO3 does it correspond to? B) What is the total hardness of the unknown water in ppm CaCO3?arrow_forward
- Question 4. New December 18, 2020. The nitrite in a series of standard solutions (mg/L, n = 5) are converted to azo dye and the slope of the calibration curve is 2.0 ppm1. A 10.00-mL mineral water sample is treated in the same way as standards and diluted to a final volume of 100.00-mL. It gives an absorbance of 0.80. The absorbance of blank solution under the same conditions is 0.10. Calculate ppm (mg/L) of NO, (46 g/mol) and the molarity of NaNO2 (69 g/mol) in the original sample В ENG 10:23 PM UK 5/5/2021arrow_forward4. The bicinchoninic acid (BCA) assay is a non-specific assay that measures the quantity of protein in a sample. BCA functions as what type of reagent in the assay? buffering reagent colorimetric reagent oxidizing agent, reducing agentarrow_forwardO Macmillan Learning Na₂CO3 is used to standardize a solution of HC1. What is the concentration of HCl if 0.1970 g of pure Na₂CO3 dissolved in 50.00 mL of water took 29.41 mL of HCl to reach the end point in the titration? Next, 0.4242 g of an unknown sample containing Na2CO3 was dissolved in 50.00 mL of water. It took 18.92 mL of the standardized HCl solution to reach the end point in the titration of the unknown sample. What is the wt% of Na₂CO3 in the unknown? M HCI wt % Na₂CO3arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
