The pressure at point m in the figure shown was increased from 85 kPa to 125 kPa. This causes the top level of mercury to move 28 mm in the sloping tube. (angle). What is the inclination Ans. = 34.932 0

The pressure at point m in the figure shown was increased from 85 kPa to 125 kPa. This causes the top level of mercury to move 28 mm in the sloping tube. (angle). What is the inclination Ans. = 34.932 0

Name: The pressure at point m in the figureshown was increased fromkPa. Thi
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: The pressure at point m in the figureshown was increased fromkPa. This causes the top level of mercuryto move28mm in the sloping tube.What is the inclination (angle ).Ans.85 kPa to 12534.9320XCwatermercury

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
PROBLEM 1- The pressure at point m in the figure shown was increased from 70 * kPa to 105 kPa. This causes the top level of mercury to move 20 mm in the sloping tube. What is the inclination,? m 3 degrees 13 degrees 23 degrees 33 degrees 43 degrees none of the above Hg S-B- 13.6 e
Find the capillary raise of the water in the tube of diameter 6mm, which is immersed vertically in the container. The surface tension of water is 0.07115 N/m. Take the angle of contact is = 00 The capillary raise of water in the tube is (unit in mm)= ______
If the Pressure in container A is 250 KPa, compute the Pressure in B. dto to 16 cm Hood - 8 cm To Water Oil, SG=0.8 Mercury hal 18 cm 22 cm Jos et tud inite di to
3- Find the total pressure and position of center of pressure FREE WATER SURFACE on a triangular plate of base 2 m and height 3 m which is 60 2.5 immersed in water in such a way that the plane of the plate h* -2 m makes an angle of 60 with the free surface of the water. 3 m YP The base of the plate is parallel to water surface and at a depth of 2.5 m from water surface.
4. Given the manometer set up, find the pressure difference between m and n in meter of oil and KPa oil (ap. gr=o.om) t.om 075m -13.4
Q:- Two water tanks are connected to each other through a mercury manometer with inclined tube as shown in Fig. If the pressure difference between the two tanks of (P, - P, = 20 kPa), determine the parameters a and 0. Water 26.8 em Water B 2a Mercuy
Caleulate the force F required to Keep the parabolic gate in static equilibrium as shown in the Fiqure. Consider width - 2m leaving the page, a=8.8m, b=4.8m and S6=8.4 of the fluid. Express the result in Newtons. Cwrite all required steps) Fluido SG
3_Calculate the volume if it is v1=1.5 L, P1= 100 Кра, р2- 50 kpa.
Q3/ Two pipes containing water are connected to a compound differential manometer as shown in Fig. Determine the pressure difference between the points at A and B when the specific gravities of mercury and oil are 13.6 and 0.9, respectively. 3366 Im Water S2=0.9 Oil (5091 15 m 03 m Water 0,4 m Mercury (S 13.61
Q3/Determine the height water will rise due to capillary action in a clean 0.25 in. diameter tube. What will be the height if the diameter is reduced to 0.01 in. Consider o= 5.03*10-3 lb/ft and y= 62.4 lb/ft³.
klindly give the complete solution where the ans. is 5.87 ft