l cyal ce When two immiscible liquids A and B are poured into a cylindrical container, then these separate out into two distinct layers of different heights as shown in the following figure. The specific gravity of liquid A is thrice that of the liquid B. If the ratio h, h, is 2:1, then the ratio of the mass of the liquid A to the mass of the liquid B in the container is

l cyal ce When two immiscible liquids A and B are poured into a cylindrical container, then these separate out into two distinct layers of different heights as shown in the following figure. The specific gravity of liquid A is thrice that of the liquid B. If the ratio h, h, is 2:1, then the ratio of the mass of the liquid A to the mass of the liquid B in the container is

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Similar questions

(a) Find the volume of liquid contained in the ï¬‚ask when it is filled to the full mark. (b) Determine the elevation h of the half full mark.
The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate and the smooth surface at B due to water pressure acting on the gate. Use =62.4lb/ft3 for water.
One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
A person weighs 30 lb on the moon, where g=5.32ft/s2. Determine (a) the mass of the person; and (b) the weight of the person on earth.
Find the elevation h (km) where the weight of an object is one-tenth its weight on the surface of the earth.
Question No. 6 The fraction of a floating body of volume V. and density d, above the surface of a liquid of density d will be - d. do do d. d-do d. d. d- do SAVE AND NE YT CLEAR O O
In a stationary fluid, The pressure inside the fluid with respect to the depth. O increases decreases equal O increases as well as decreases
If the density of fluid is 2000 kg/m3 , the specific volume of the fluid is ?m3/kg
2. A circular ring (radius = 5.0 cm) is used to determine the surface tension of a liquid. The plane of the ring is positioned so that it is parallel to the surface of the liquid. The ring is immersed in the liquid and then pulled upward, so a film is formed between the ring and the liquid. In addition to the ring's weight, an upward force of 3.6 x 10 N is required to lift the ring to the point where it just breaks free of the surface. What is the surface tension of the liquid?
Determine the weight of the air in Newton contained in a room whose dimensions are 6 ft x 6 yards x 8 m. Assume the density of the air is 1.16 x 10-5 kg/in3
Two chambers with the same fluid at their base are separated by a 30-cm-diameter piston whose weight is 25 N, as shown in the figure. Calculate the gage pressure (in kPa) in chamber A. Round your answer to 2 decimal places.
the bottomless conical container shown is on a table. The edges of the container are tightly fitted to the surface of the container. After the liquid level reaches the height h, the water pressure causes the container to rise. The radius of the bottom base of the container (which is larger) is equal to R, the angle between the generatrix of the cone and the vertical is A, the weight of the container is P, and the height of the cone is b. Express the density of the liquid as a function of the given data.