Compare the detection ranges of the two 3 cm radars above for a 10 ml target using a single  pulse. Assume both radars have a mean noise level of =131 dB W, have losses of - 5 dB and  require a SNR of 13 dB for reliable detection. The marine radar has a peak transmitter power  of 25 kW, but the airfield control radar is more powerful with a peak power of 55 kW.

Q: A 20ohm resistor is connected in parallel with an inductive reactance of 15ohm across a 60V, 1 kHz…

A:

Q: B. Find the value of x for which Inx + (Inx)2 + (Inx)3 + (lnx) += 9

A: Step 2: Step 3: Step 4:

Q: Write, if the shown statements are true or false, (Hint: you will lose points for each incorrect…

A: Step 1: Step 2: Step 3: Step 4:

Q: x(t)=cos(2*\pi *15t) a signal defined in the form of a signal is introduced into a system whose…

A:

Q: Evaluate the circuit behavior for t<0 and t> 0 to determine the expression some incorrect I…

A:

Q: Which element affects the inductance of a coil of wire: Select one: RC time constant. number of…

A: As we increases the number of turns the inductance of the coil will be increased .we know that…

Q: Please answer in typing format

A: The circuit consists of two NOT gates connected in a loop. Each NOT gate inverts its input signal.…

Q: 5. For the circuit depicted in the following figure, determine the voltage labeled v₁ across the 3…

A:

Q: A steel bar with modulus of elasticity 200 GPa and diameter 10 mm is loaded in tension with an axial…

A:

Q: The field strength of an electromagnet: Select one: remains constant as voltage across the coil…

A: This is explained by the Ampere's Law, which states that magnetic field strength is directly…

Q: please show the full solution

A: ANSWER : ( a ) ​​  ANSWER : ( b ) ​​

Q: Get the electromechanical analog model (torque-voltage or torque-current) of the system. With all…

A: Step 1:Γ=kΘ+BΘ'+JΘ''is equation of Rotational mechanical system. Where Tau = Torque,J =Moment of…

Q: 5.10 A sequential circuit has two JK flip-flops A and B, two inputs x and y, and one output z. The…

A: (a)(b)(c)

Q: Table 4.1 shows the experimentally measured frequency response of an open-loop process plant G(s).…

A: Given:open loop transfer function of a control system, we need to do:a)  Bode plot of given transfer…

Q: I need the expert's solution in handwriting and clear.

A: Step 1:Step 2:Step 3: Step 4:

Q: For the circuit shown, select the best expression for vo(t) when i(0) = 5 A and vt) = 0. redraw…

A:

Q: NO AI, ANSWER STEP BY STEP PLZ

A: Step 1:PLEASE VOTE UP IF YOU LIKE THE SOLUTIONTHANK YOU

Q: Determine the value of a capacitor that has the reactance provided at the given frequency at 1.56…

A: Capacitive reactance, X=1/(wC) = 1/(2πfC) wheref= frequencyC= capacitance

Q: For the given LTI system: y[n] = x[n + 5] + 2y[n-1], find the impulse response. Is the system…

A: Check for causual or non-causal:Check for stability:          If you are having doubt in any step…

Q: A thermal bimorph can be used as an actuator. In this problem, you will use the principles of…

A: The objective of this question is to design a process and mask set for creating a silicon-based…

Q: Q6. Find vi(t), i₁(t), and i2(t). 1 mH i2(t) 2 sin(1kt) V ↑. 0.25 mF (t) 202 + V₁(t) 42 42 cos(2kt)…

A: Step 1: we have two sources in the circuit. so we apply superposition theorem. we find v1, i1, i2…

Q: 1. Write the required rotation Angle/s to approach the following coordinates starting from the…

A:

Q: Good afternoon, Having some diffculity with this E&M example. Thanks!

A: Step 1:Step 2:Step 3:

Q: In a source free RL circuit containing an inductor initially charged to a current lo, how many time…

A: Option aOnce the current reaches this maximum steady state value at 5τ, the inductance of the coil…

Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai i definitely upvote you be…

A: Step 1: if you like the solution please upvoteif you have any doubt comment herethank you

Q: For the circuit below:  (a) Find impedance Zt at resonance (b) Circuit voltage at resonance (c)…

A: The objective of the question is to find the total impedance at resonance, the circuit voltage at…

Q: A single-phase half-bridge inverter has R-2.502 and the DC input voltage is 50V. Determine: • The…

A: Step 1: Circuit diagram, waveforms are shown below:

Q: 2. We found the following specifications of an RTD temperature sensor from the datasheet: The…

A: Step 1:To find the transfer function of the RTD (Resistance Temperature Detector), we can use the…

Q: Need Help with this homewok

A: 1. Gather Information:Column dimensions: You'll need the width (b) and depth (h) of the column…

Q: Q21 Given the ·Sequence xen)=16-n) [mens_un_6]] compute and sketch the following sequin a)…

A:

Q: How can V1 and V2 be found using the Node Voltage Method so that V1 is 100 V and V2 is 20 V,…

A:

Q: A source-free RC contains an initially charged capacitor with voltage Vo. What is the voltage across…

A:

Q: please show best and easy way/working to solve for boundary conditions, odes, and general solutions…

A:

Q: I need help on this question, As for measure resistor value, Rmeasure = 991ohms

A: Step 1:

Q: Q6. (A Criteria 3.2,3.6) A circuit is required to convert a DC supply voltage of 12 Volts to 5 volts…

A: The objective of the question is to design a voltage regulator circuit using a Zener diode that…

Q: नत Series RL Circuit Find i(t) for to Given i(o) = 4A, V(0)=8V Redraw circuit in s-domain -34 352 m…

A: Step 1:Step 2:Step 3:Step 4:

Q: Please answer in typing format

A: The function of each block and how this 3-bit binary ripple counter circuit works: JK Flip-Flops:The…

Q: given two discrete sequences Xch) and hen) de fined as 2n=0 x[n]= [] -2 n = 0,1,2 and hen= -1=1,2 n…

A:

Q: As a capacitor charges, the current through it: Select one rises according to the time constant.…

A:

Q: Use servo motor to be rotates to right from 10 to 150 degrees with step of an angle of 10 degrees,…

A: Given:Servo motor to be rotates to right from 10 to 150 degrees with step of an angle of 10 degrees,…

Q: , three Stay Connected induction motor. has the standstill Resistance and Reactance/per phase as…

A:

Q: An iron ring has a tightly wound coil with 1500 turns. The inner and outer radii of the iron core…

A:

Q: The switch in the figure has been in position A for a long time. Assume the switch moves…

A:

Q: Could you help show all work

A: Step 1: Step 2: Step 3: Step 4:

Q: Determine the frequency where the stated component has the given reactance at 20 μF Capacitor with…

A: To determine the frequency at which each component has the specified reactance, we can use the…

Q: Determine the Fourier series of the sawtooth waveform in Fig. 17.9. FLO) 4 -2 -1 0 1 2 31

A: From the sawtooth wave form, we have to determine the fourier series,Fourier series representation…

Q: This is a practice question from the Signal and Systems course of my Electrical Engineering Program.…

A: Step 1:Step 2:

Q: 3.5.54 Use Thévenin's theorem to find V, in the circuit in Fig. P3.5.54. 4 mA 12 V 1 ΚΩ ww 1ΚΩ ww 1…

A: Step 1:Step 2:

Q: 5. For the following circuit with ideal OPAM and positive saturation voltage Vsat+ = 9V and negative…

A: a. Bipolar Junction Transistor (BJT) in its different operating regions: cut-off, saturation, and…

Q: Construct a truth table to design an automated watering system controlled by soil moisture, rain…

A: To design the truth table for the automated watering system controlled by three inputs: soil…

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.