An electric power transmission cable weighing 2.5 lb/ft is supported by towers on two sides of a river val- Design specifications require that the maximum tension in the cable be less than 12,000 lb ley as shown in Fig. and that the minimum clearance above the river be at least 75 ft. Determine the minimum allowable height of tower B. -2000 ft B. 200 ft 75 t 10ft 30 ft

An electric power transmission cable weighing 2.5 lb/ft is supported by towers on two sides of a river val- Design specifications require that the maximum tension in the cable be less than 12,000 lb ley as shown in Fig. and that the minimum clearance above the river be at least 75 ft. Determine the minimum allowable height of tower B. -2000 ft B. 200 ft 75 t 10ft 30 ft

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
Q2. A symmetrical n-network has a resistance of 7502 in the series arm and 2502 at each shunt arm. a) Calculate the open and short circuit impedances. b) Calculate the characteristic impedance. c) Calculate the propagation constant. d) Find its equivalent T-network.
A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.12 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 135KV. Find the Voltage distribution across each unit and the String Efficiency
q) 150 kv single core cable has a radius of cable of 5cm. The insulation martial has two layers. The relative permittivity of the first and second layers are 6 and 3 respectively. If the minimum electric stress of the first and second layers are 30 kv/cm and 20 kv/cm respectively. Find the maximum electric stress of the first layer.note : subject is : power - underground cabel
In a string of suspension insulator with three units,the line unit has 12k and k=0.15. The voltage across string is and the efficiency is .?: a. 41.6kV & 69.4kV b. 33.62kV & 74.7% C. 29.52kV & 82% d. 36.9kV & 82%
In an outdoor substation the three bus-bar conductors are supported by units of post type insulators. Each unit consists of a stack of 3 pin type insulators fixed one on the top of the other. The voltage across the lowest insulator is 15kV and that across the next unit is 12kV. Estimate: ratio of mutual to self-capacitance i. the bus-bar voltage of the substation. Efficiency across the string of insulators ii. iii.
Q2. For the same maximum demand, if load factor is decreased, the cost generation will Oremain unchanged increase Odecrease ONone of the above Q3. The material generally used for armouring of high voltage cables is
Hw2.1-4: Draw the phasor diagram for the following cases: Exact equivalent circuit with lagging load and Vị reference.
1/ Suppose that there are two types of H.V.T.Ls operating at the same voltage and carrying the same current, but one of them with smooth shapewhile the other with standard shape. Which of them, you will choose? a. choosing the smooth one. b. choosing the standard one. c. choosing the one with hollow construction shape. d. all these answers are wrong. 2/ As the ambient temperature in crease the disruptive critical voltage of coron a is: a. Decreased b. Increased c. No effect d. All these answers are wrong. 3/ Using HV underground cable improvevoltageprofile and power factor in any loaded inductive electrical grid because. a. Due to its inductive power effect. b. Due to resistive Effect. c. Due to its capacitive power effect. d. All of the above answers are wrong.
For the circuit shown in Figure 2.1, write down the nodal equations for the circuit and solve for V2 and V3if both VS1 and VS2 are 15V. Show all the calculations involved
A string of suspension insulators consists of three units. The capacitance between each link pin and earth is one-sixth of the self-capacitance of each unit. If the maximum voltage per unit is not to exceed 35 kV, determine the maximum voltage that the string can withstand. Also calculate the string efficiency. [84-7 kV; 80-67%]
Answer the following quastion * 150 kv single core cable has a radius of cable of 5cm. The insulation martial has two layers. The relative permittivity of the first and second layers are 6 and 3 respectively. If the minimum electric stress of the first and second layers are 30 kv/cm and 20 kv/cm respectively. Find the maximum electric stress of the first layer