Q1: Train industry company has been tested their train, the velocity of one of these trains was given by the equation: v = 0.1 (3t^2 + 8t) m/s. Calculate the position of this train (in km) as well as its acceleration after 5 minutes of the test, if you know that the initial time and the initial position are zero.

Q1: Train industry company has been tested their train, the velocity of one of these trains was given by the equation: v = 0.1 (3t^2 + 8t) m/s. Calculate the position of this train (in km) as well as its acceleration after 5 minutes of the test, if you know that the initial time and the initial position are zero.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 5RQ: What are interpoles, and what is their purpose?

See similar textbooks

Similar questions

A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The two machines operate in parallel in a power station. What is the equivalent. H constant for the two, relative to a 100 MVA base?
Two cities A and B are connected by a 200km long train line. A train leaves A for B at 20 km / h at the same time as another train leaves B for A at 5 km / h. In the samemoment a fly leaves from A to B following the train line. The fly flies at 40 km / h until it collides with train B. At that moment it returns instantly and follows the train line until it collides with train A. At that moment it returns instantly and follows the line of the train. train until it collides with train B. The fly continues this process, traveling ever smaller distances until the two trains meet. (It is an ideal problem and the fly does not get squashed by the trains).What is the total distance traveled by the fly?
A generator operating at 50 Hz delivers 1 p.u. power to an infinite bus through a transmission circuit in which resistance is ignored. A fault takes place reducing the maximum power transferable to 0.5 p.u. Where as before the fault, this power was 2.5 p.u. and after the clearance of the fault, it is 2 p.u. The value of 8 is max
What are interpoles, and what is their purpose?
7. One joule is the same as a. 10power8 ergs b. 10power7 ergs 8. Static friction is c. 10power6 ergs d. 10power5 ergs a. always greater than the dynamic friction b. always less than the dynamic friction c. always equal to the dynamic friction d. either greater or more than the dynamic friction 9. The curve of a catenary by nature is a. ellipse b. circular c. hyperbolic d. parabolic 10. A block A when dropped down a smooth inclined plane, at the same time another identical block B i released for free fall from the same height, the a. both will hit the ground simultaneously b. block A will have higher velocity than block B while hitting the ground c. block A will hit the ground earlier d. block B will hit the ground earlier
(a) For the system shown in figure find steady state error for (i) Unit step input 10 (ii) Unit Ramp input B)
Driving-point admittance The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is of O 6000 VA O 8000 VA O2000 VA 4000 VA Jump to ncements MacBook Air DD DII F10 F9 F8 000 F7 F6
Wind mill with 2 m diameter works on the principle of converting kinetic energy of the wind in to mechanical energy. If air density = 1.225 Kg. / m°wind speed 20 m/sec then power available from wind mill is 30787.6 w 30787.1 w 30787.3 w
Two identical synchronous machines having same inertia constant are connected in parallel and swinging together. The effective inertia constant is 4 MJ/MVA. Then each machine has an inertia constant of (a) 2 MJ/MVA (b) 4 MJ/MVA (c) 8 MJ/MVA (d) 16 MJ/MVA
What are two ways of reducing Z0? (last part of the question)
10: The value of B at H-0 in a Hysteresis curve is called A) Remanence. B) Coercivity. C) Magnetization. D) Porosity 11: Ferrites are a sub-group of A) Non-magnetic materials, B) Ferro-magnetic materials, C) Paramagnetic materials, D) Ferri-magnetic materials. . 12: Find the true statement. A) Most of the substances show ferromagnetism, B) The magnetic susceptibility of diamagnetic substances are temperature independent, C) Water is paramagnetic in nature, D) Typical domain size of a ferromagnetic material is I nm. 13: Mutual inductance between two magnetically coupled coils depends on A) Permeability of the core material, B) Number of turns of the coils C) Cross sectional area of their common core, D) All of the above. 14: Which of the following circuit elements will oppose the change in circuit current? A)Capacitance. B) Inductance, C) Resistance, D) All of the above. 15: If the current in one coil is steady, what happens to the mutual inductance? A) Zero, B) Infinity. C) Doubles, D)…
Please Asap for like this please fast Please