(2.) Sketch a boiling temperature – mole fraction phase diagram for a mixture of A and B (A more volatile than B) showing positive deviations from Raoult's law, labelling the important regions on the diagram, including the azeotropic point. Use the Gibbs phase rule to calculate the number of degrees of freedom for the azeotropic mixture.

(2.) Sketch a boiling temperature – mole fraction phase diagram for a mixture of A and B (A more volatile than B) showing positive deviations from Raoult's law, labelling the important regions on the diagram, including the azeotropic point. Use the Gibbs phase rule to calculate the number of degrees of freedom for the azeotropic mixture.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter84: Fractional Distillation, Azeotropes

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

7.) Ethylene glycol [CH2(OH)CH2(OH)] is a common automobile antifreeze. It is water soluble and fairly nonvolatile (b.p. 197°C). Calculate (a) the freezing point and (b) the boiling point of a solution containing 685 g of ethylene glycol in 2075 g of water. AT, = Kpm and AT; = K;m, [1.5 pt.] %3D
Assuming the validity of Raoult's law, do the following calculations benzene (1) toluene (2) system: Species Benzene Toluene InPara A. B T(C))+C B 13.7819 2726.81 13.9320 3056.96 217.572 217.625 ! 2 and T-100 °C find x, and P (a) Given y, -0.33 (b) Given T-105°C and P 120 kPa, find x, and y₁ (c) For part (b), if the overall mole fraction of benzene is z₁ -0.33, what molar fraction of the two-phase system is vapor? - 120
The binary water-phenol diagram is given below, in molar fraction, under the total pressure Pt = 1 atm. 1) How many phases are there in the domain marked "I"? 2) From which temperature the mixture become miscible in all proportions? How do you call that temperature? 3) At a temperature T = 50 °C, in a controlled temperature container containing water. Phenol is then poured at the same temperature until the molar fraction of phenol in the mixture XC2H50H is equal to 0.05. Then, we continue to add the phenol gradually, at a constant temperature, to XC2H5OH of phenol in the mixture is XC2H5OH = 0.8. = 0.4. Then finally we stop adding phenol when the molar fraction a. How many phases are present at each one of the three mixture compositions in the container during the addition of the phenol? b. What is the composition of the phases when the fraction of phenol is XC2H5OH = 0.4? c. What is the proportions of the phases with respect to each other when XC2H5OH = 0.4? (Show your calculations)…
Part A Use Raoult's law to calculate vapour liquid equilibrium behaviour for a multicomponent mixture of hydrocarbons. n-pentene i-pentane 0.1 n-pentane cyclohexane Mole fraction in mixture 0.2 0.6 0.1 (a) Calculate the pressure for which the mixture boils at 40°C. (b) Calculate the boiling temperature at atmospheric pressure. (c) From part (b), calculate the composition of the vapour phase that fomms at the nomal boiling point of the mixture. 16 M. H. Khoshgoftar Manesh
Please indicate true (T) or false (F) as appropriate: Justify I) The vapor pressure of a solvent is reduced by the presence of a non-volatile solute II) In an ideal solution, the vapor pressure is increased by the presence of a solute Volatile. III) Sea water freezes at a lower temperature than sugar water. IV) In the laboratory, chemists use this effect to judge the purity of a component solid: if impurities are present, the freezing point of the compound is lower than the accepted value. A) TFTF B) TTFT C) FTFF D) TTTT
Partial molar volumes of acetone and chloroform in their equimolar (0.5/0.5 molar fractions) mixture are 74.2 cm3mol-1 and 80.2 cm3mol-1. What is density of this solution?
What is the partial pressure of methane needed to dissolve 21mg of the gas in 100g of benzene at 25 degrees Celsius, knowing that Henry's law constant for methane is worth 5.69x104kPa? (M metano - 16,04g mol-1 , M benzeno - 78,11g mol-1).
Chloroform (1)/methyl ethyl ketone (2) form a solution in vapor liquid equilibrium at 330 K 1) The chloroform concentration in the liquid phase is x1 = 0.55. Assuming an ideal gas and an ideal solutionof liquids, what are y1 and P (in kPa), to 3 significant figures? 2) Was the “ideal solution of liquids” an accurate assumption in part (a.)? Clearly state Yes/No and explain 1-2 sentences
7.The diagram below is an example of Undistillable Mixtures (T vs Mole Fraction).How many degrees of freedom at the vapor phase,liquid phase and at azeotropic point? Undistillable Mixtures – Azeotropes T= T These types of mixtures cannot be separated using simple distillation processes, because the composition of the liquid phase at the azeotropic point is the same as that of their vapor composition. Vapor Phase T=T T This type of azeotropic phenomenon is the high - boiling azeotropism. This happens when A and B have strong attractive interaction. Liquid Phase Zazeotrope
When 127. mg of a certain molecular compound X are dissolved in 55.0 g of dibenzyl ether point of the solution is measured to be 1.6 °C. Calculate the molar mass of X. If you need any additional information on dibenzyl ether, use only what you find in the ALEKS Data resource. Also, be sure your answer has a unit symbol, and is rounded to the correct number of significant digits. ((C6H₂CH₂)₂0), 2 the freezing OO B olo Xu
1. Ideal solution composition of A and B liquids at 80°C is 100 (for A) and 600 (for B) mmHg, respectively. (a) Construct the P-x phase diagram by calculating the compositions of the liquid and vapor phases. (b) 1.0 mole of solution with ZB= 0.60 at 80°C is in an open container and is evaporated until the total vapor pressure decreases by 20%. Calculate the number of moles of the liquid and vapor phases using the leverage rule.
= The vapor pressure of component A'is 300.3 torr, and that of component B is 70 torr at 35 °C. A Solution of A and B at 35 °C with x = 0.300 has a vapor pressure of 70.3 torr and a vapor composition of x = 0.275. (i) Calculate yand a, for component A and for component B in this solution. %3D -tin. (ii) Calculate u - Hi for each component of this solution. (iii) Calculate AG for the mixing of 0.200 mole of liquid component B and 0.800 mole of liquid chloroform at 35 "c. (iv) Calculate AGmix for the corresponding ideal solution.