Tutorials in Introductory Physics
1st Edition
ISBN: 9780130970695
Author: Peter S. Shaffer, Lillian C. McDermott
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 13.1, Problem 2bT
To determine
The variable which is constant, and which are allowed to change in part A.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
For Part C, how do you express that answer in Degrees?
For the question below, it will help if you
draw a figure and put in it all the given
information.
At one point during the Oman bicycle race, three racers are riding along a straigh
section of road. The velocity of racer Arelative to racer B is VAB, the velocity of
is VAC and the velocity of C relative to B is yCB. If VAB = +6.0 m/s, and yac= +2.
VCB?
a) +2.0 m/s
b) +4.0 m/s
c) +8.0 m/s
d) -4.0 m/s
e) -2.0 m/s
а. (а)
b. (b)
с. (с)
d. (d)
е. (е)
A mole of a certain ideal gas was inside a container. The gas has temperature of 70°F and pressure of 20 psi. Find the volume of the gas in m3.
***Provide the given parameters, schematic diagram or free body diagram of the system if applicable, required parameter/s and the solution. Show pertinent solution and conversion of units.***
***Do not round off in between calculations. Express your final answer in 2 decimal places. ***
Chapter 13 Solutions
Tutorials in Introductory Physics
Ch. 13.1 - Prob. 1aTCh. 13.1 - In the space provided, draw an arrow to indicate...Ch. 13.1 - Prob. 1cTCh. 13.1 - Prob. 1dTCh. 13.1 - Prob. 1eTCh. 13.1 - Prob. 2aTCh. 13.1 - Prob. 2bTCh. 13.1 - Consider the following student dialogue. Student...Ch. 13.1 - Sketch the process described in section II on the...Ch. 13.1 - Prob. 3bT
Ch. 13.1 - Prob. 4aTCh. 13.1 - A student looks up the molar masses and finds the...Ch. 13.1 - Prob. 4cTCh. 13.2 - Recall the definition of work done on an object by...Ch. 13.2 - Prob. 1bTCh. 13.2 - Prob. 1cTCh. 13.2 - Prob. 2aTCh. 13.2 - Does the internal energy of a gas in an insulated...Ch. 13.2 - Two students are discussing process 1: Student 1:...Ch. 13.2 - Imagine that the cylinder from section II is no...Ch. 13.2 - In process 2, is the heat transfer to the gas...Ch. 13.2 - Prob. 3cTCh. 13.2 - Prob. 4aTCh. 13.2 - In process 1 (section II) you did not need to...Ch. 13.2 - In process 2 (section III) you did not need to...Ch. 13.2 - Prob. 4dTCh. 13.2 - How does the compression in process 3 differ from...Ch. 13.2 - A student is considering process 3: “The...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Direction: Solve the following problems. Please box your final answer and write your solution clearly. A A cargo ship has tanks for carrying fuel oil. The oil is measured in barrels, while the tank dimensions are in meters, 1m x 5m x 15m. How many barrels does the tank hold? How many gallons? (42 gal = 1 barrel) A gas is contained in a cylinder with a moveable piston on which a heavy block is placed. Suppose the region outside the chamber is evacuated and the total mass of the block and the movable piston is 102 kg. When 2140 J of heat flows into the gas, the internal energy of the gas increases by 1580 J. what is the distance through which the piston rises?arrow_forwardTwo kids decided to play with their toys, balls. The first kid is on the ground (0.00 meter), whereas the second kid is on top of a 10.00-meter tall building. The second kid threw his ball at the same time that the first kid throws another ball upward. At the time that the first kid’s ball reaches its maximum height, the two balls will collide. i.) Compute for the initial speed of the first kid’s ball. ii.) Determine at what time and at what height the two balls will collide.arrow_forwardQuick description In this lab you will study two-dimensional motion, specifically projectile motion. You will roll a ball down an inclined plane (a track with one end propped). The ball will fly off the end of the inclined plane and undergo projectile motion until it hits the ground. At the moment the ball is leaving the inclined plane, a photogate detector measures the time the ball takes to pass through the gate. Using the diameter f the ball and the photogate time, you can calculate the speed of the ball when it passed through the photogate. Based on the angle of the inclined plane, the initial speed for the projectile motion, and the distance the ball falls (Ay in figure), you should be able to predict the horizontal distance (Ax in figure) and compare it to your measured horizontal distance. 41cm Ball 121cm Inced Plane Table Inclined plane angle = sin ^-1 (41cm/121 cm) = 19.81° Ball diameter = 0.013 m Delta Y= 76 cm=0.76 m Time (s) Velocity (m/s) Delta X (m) 0.00707 0.184 0.654…arrow_forward
- Part C: Density of Water In this part, we will try to measure or calculate the density of water. As we have learnedin the lecture, the density of any matter will be the ratio of the mass of the given matterand the volume of the matter. We will have to obtain the data for the mass and the volumeof that given amount of water. We will use a rectangle container for this purpose. If we measurethe length, the width of the container, and if we pour the water in the container, we can calculatethe volume of the water. To get the mass of the water, we will measure the mass of the emptycontainer first, we will then measure the mass of the container with the water inside. The differenceof this two mass will be the net mass of the water that we are interested. We will do three trials. We will just put different amount of water in the container. Different amount of water will give you different height, but the length and the width of the container is the same. Since this…arrow_forwardThe relationship between the length of a pendulum L and the time T for one complete oscillation can be determined from the data in the table to the right. a. Find the least squares line equation and graph it simultaneously with the data points, with L as the horizontal axis and T as the vertical axis. Does it seem to fit the data? b. Find the correlation coefficient and interpret it. Does it confirm your answer to part a? L (ft) T (sec) 1.0 1.13 1.5 1.36 2.0 1.57 2.5 1.76 3.0 1.92 3.5 2.08 4.0 2.22arrow_forwardA cargo barge is loaded in a saltwater harbor for a trip up a freshwater river. Part A If the rectangular barge is 3.5 m by 24.0 m and sits 0.90 m deep in the harbor, how deep will it sit in the river? Express your answer using two significant figures. h =____ marrow_forward
- A water droplet evaporates before they reach the ground. ond ord Figure 1: Water droplets [source] In this situation, a few assumptions are made: a) At initial point, a typical water droplet is in sphere shape with radius r and remain spherical while evaporating. b) The rate of evaporation (when it loses mass (m)) is proportional to the surface area, S. There is no air-resistance and downward direction is the positive direction. quat To describe this problem, given that p is the mass density of water, rois the radius of water before it drops, m is the water mass, V is the water volume andk is the constant of proportionality. QUESTION: (1) From assumption (b), show that the radius of the water droplet at time t is or r(t) = (=)t+ro- %3D (Hint: m = pV,V =tr³, S = 4nr²). 4 TTr 3arrow_forwardBriefly explain the difference between block and random practice, applicable to designing a practice session. Edit View Insert Format Tools Table 12pt v Paragraph v BIUAvev T?v :arrow_forwardB. What is the mean (average ) length of a glass bead ? 1. There are five numbered glass beads in your container . 2. Measure the length of each glass bead at its longest point to the nearest tenth of a centimeter . Convert your measurements to millimeters . 3 Record your data in Table 1 below and divide the total by 5 to obtain the mean length of your glass beads in cm and . 4. Put your mean results on the board and then find the mean of the class data . Table 1. Length Measurement Data Glass Bead 1 2 3 4 5 Total Mean mm 5. What is the mean length of a glass bead as measured by your class ? cm ווarrow_forward
- The mechanism shown in (Figure 1) is used in a riveting machine. It consists of a driving piston A, three links, and a riveter which is attached to the slider block D Part A Determine the x and y components of the velocity of D at the instant shown, when the piston at A is traveling at vA = 12 m/s Express your answers using three significant figures separated by a comma. VO AEo n vec (vD)z, (vD)y = m/s Submit Request Answer Figure > 45° 300 mm 150 mm 45 200 mm 30 60 45°arrow_forwardA gallon of gas contains about 1.3 x 108 J of chemical potential energy. Determine how many joules of chemical potential energy are stored in each litre of gas (3.79 L = 1 gallon). Calculate the height that the amount of chemical potential energy in 1 L of gas could raise all the students in your class if it was all converted to gravitational potential energy. You will have to make assumptions about the mass of the students. State your assumptions and show your calculations.arrow_forwardPart C At 7 s? Express your answer with the appropriate units. ► View Available Hint(s) (Fnet).x = HÅ Value Ć Units ?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning