Would the following procedural errors result in an incorrectly high or low calculated percent NaOCl in the commercial bleaching solution? Briefly explain. a) A student failed to allow the volumetric pipet to drain completely when transferring commercial bleaching solution to the volumetric flask. b) A student blew the last drops of bleaching solution from the pipet into the Erlenmeyer flask when transferring diluted bleaching solution to the flask. c) A student began a titration with an air bubble in the buret tip. The bubble remained in the buret tip during the first titration, but it came out of the tip with the titrant released during the second titration. d) A student added diluted bleaching solution and HCI solution to aqueous KI solution in Erlenmeyer flasks 1 and 2 before beginning the titration in Erlenmeyer flask 1.

Would the following procedural errors result in an incorrectly high or low calculated percent NaOCl in the commercial bleaching solution? Briefly explain. a) A student failed to allow the volumetric pipet to drain completely when transferring commercial bleaching solution to the volumetric flask. b) A student blew the last drops of bleaching solution from the pipet into the Erlenmeyer flask when transferring diluted bleaching solution to the flask. c) A student began a titration with an air bubble in the buret tip. The bubble remained in the buret tip during the first titration, but it came out of the tip with the titrant released during the second titration. d) A student added diluted bleaching solution and HCI solution to aqueous KI solution in Erlenmeyer flasks 1 and 2 before beginning the titration in Erlenmeyer flask 1.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter8: Sampling, Standardization, And Calibration

Section: Chapter Questions

Problem 8.14QAP

See similar textbooks

Similar questions

The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 mL volumetric flask and filling to the mark with D water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. Which of the following technique can be used to determine the amount of mercury in the undiluted sample of river water? O A. IR spectroscopy O B. Cold vapor atomic absorption OC. Hydride generation atomic absorption OD. Electrothermal atomic absorption
The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 mL volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. What is the corrected absorbance of both solution A and B? OA. Solution A: 0.123 Solution B: 0.463 O B. Solution A: 0.463 Solution B: 0.234 O C. Solution A: 0.123 Solution B: 0.234 O D. Solution A: 0.234 Solution B: 0.463
Q1: What is the density (g/ml) of a 3.6M Sulfuric acid solution that is 29% H,So, by mass (Mwt. = 98)? Q2: Fill the blanks with suitable answers 1: The is the thing being dissolved. ......... 2: The branches of quantitative analysis are and 3. The filterability of the precipitate depend on the of practices. Q3: Which one is correct? 1. Molality changes with temperatures. 2. Molality does not change with temperatures. 3. Molarity changes with temperatures. 4. Normality changes with temperatures. Q4: What weight of pyrite ore (impure FeS,) must be taken for analysis so that the BaSO, precipitate weight obtained will be equal to one-half that of the percent S in the sample? Note: Mwt. of Ba =32, Mwt. of BaSo4 =233, Mwt. of FeS, =119
The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 mL volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. What is the corrected absorbance of both solution A and B? O A. Solution A: 0.123 Solution B: 0.463 O B. Solution A: 0.463 Solution B: 0.234 O C. Solution A: 0.123 O D. Solution A: 0.234 Solution B: 0.234 Solution B: 0.463
Come up with a dilution scheme starting from 1000 μg/mL Mn stock solution so that the concentration of permanganate in the solutions just prior to measurement (after Step B.6.) are: 7.5, 15.0, 22.5, 30.0 and 37.5 μg/mL MnO4-. Carefully read the units!
A solution of HCl was titrated against sodium carbonate. What is the average normality of acid in the given data? (MW Na₂CO3 = 106) T2 0.3479 0.3562 0.3042 Weight (g) Initial V (ml) 0.80 1.60 35.20 36.70 39.80 Final V (mL) Vol HCl used (mL) 35.10 39.40 N of HCl (eq/L) 0.1954 0.1870 Average N of HCl (eq/L)
A 1.59 g sample containing KI was analyzed gravimetrically and 0.0538g of Barium Iodate was recovered... express the results of this analysis as percent posassium iodide.
4. A fat sample with combination of acids contain standard hydrochloric acid for blank and sample with 8mL and 5mL respectively. The normality of the standard hydrochloric acid is 0.93N and the weight of the sample is 3 grams. Calculate the saponification value.
THE QUESTION IS AT THE PICTURE... 2 QUESTIONS ONLY.. AND THE GIVEN PROBLEMS IS THE ONE I TYPED........ATTACHED PHOTO IS MY ANSWER BUT PLEASE CORRECT ME IF I AM WRONGA. Concentration1. Place 3 mL each of 6N, 3N, & 1.5N hydrochloric acid in separate test tubes.2. Drop simultaneously equal lengths (about 1cm) of magnesium ribbon and note thetime it takes for the magnesium to dissolve in each use.B. Surface Area1. Weigh a small iron nail to the nearest hundredths of a gram and weigh an equalamount of iron fillings.2. Place them in a separate test tubes.3. Add simultaneously 3 mL of 3N hydrochloric acid and compare the rates of reaction.C. Temperature1. Place 5 mL each of 0.1N sodium thiosulfate solution into 5 test tubes.2. Place all five test tubes in the water bath and let it stand for 1 minute.3. Record the temperature of the water bath. Remove the first test tube from thewater bath and place it in the test tube rack.4. Add 1 mL of 0.1M sulfuric acid and stir with a glass rod.…
The air in a recently used classroom 9m x 7m x 9m tested 0.12% carbon dioxide. How many cubic meters of fresh air must be admitted per minute in order that 10 minutes later it shall contain not over 0.06% carbon dioxide. Fresh air contains 0.04% carbon dioxide. Assumeimmediate mixing of fresh with stale air. (A) 14 (B) 11 (C) 15 (D) 19 (E) 17
THE QUESTION IS AT THE PICTURE... 2 QUESTIONS ONLY.. AND THE GIVEN PROBLEMS IS THE ONE I TYPED............. PLEASE TYPE YOUR ANSWER PLEASE....A. Concentration1. Place 3 mL each of 6N, 3N, & 1.5N hydrochloric acid in separate test tubes.2. Drop simultaneously equal lengths (about 1cm) of magnesium ribbon and note thetime it takes for the magnesium to dissolve in each use.B. Surface Area1. Weigh a small iron nail to the nearest hundredths of a gram and weigh an equalamount of iron fillings.2. Place them in a separate test tubes.3. Add simultaneously 3 mL of 3N hydrochloric acid and compare the rates of reaction.C. Temperature1. Place 5 mL each of 0.1N sodium thiosulfate solution into 5 test tubes.2. Place all five test tubes in the water bath and let it stand for 1 minute.3. Record the temperature of the water bath. Remove the first test tube from thewater bath and place it in the test tube rack.4. Add 1 mL of 0.1M sulfuric acid and stir with a glass rod. Record the time it takes…
The Common App... An experiment was conducted using KNO3. The table below shows the data obtained after dissolving different masses of KNO3 in 10 ml of deionized water and then cooling to determine the temperature at which the different concentration of salts begin to recrystallize Concentration of KNO3 Saturation temperature(°C) 2g/10 ml 52.5 4g/10 ml 54.7 6g/10 ml 66.7 8g/10 ml 80.2 If a student dissolve 24g of KNO3 in 120 ml of deionized, at what temperature do you expect to see recrystallization O 52.5 degree celsius O 66.7 degree celsius 0:54.7degrce celsius O100.2 degree celsius