Answered: Which type of Insulator used for LOW…

Which type of Insulator used for LOW Voltage transmission line at dead-end tower: a. Pin Insulator O b. Strain Insulator O c. Suspension Insulator O d. Shackle Insulator

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter10: Contactors, Relays, And Overloads

Section: Chapter Questions

Problem 25RQ

See similar textbooks

Related questions

Q: A transmission line conductor at the water crossing was supported by two towers of height 35 m and…

Q: 2-IS there a relationship between the fault bending & fault connection points in optical fiber?

A: Fault connection: Sudden load increase in optical fiber will lead to fault connection, and fault…

Q: Type UF cable shall not be used where subject to physical damage. A. True B. False

A: Generated power needs to be distributed to different loads. Cables are used for transferring power…

Q: Explain this diagram for dummy

A: The given circuit is as shown below,

Q: List down the different types of Cables.

A: Dependig on the purpose of use cables are classified in to five types1)Shielded cables2)Fibre optic…

Q: Why make two wire, three wire or four wire connection in RTD connection

A: Why make two wire, three wire or four wire connection in RTD connection?

Q: The grounded circuit (system) conductor is generally not permitted to be used to ground equipment on…

A: Given, The grounded circuit (system) conductor is generally not permitted to be used to ground…

Q: A bolted line to line short circuit is used to determine the thermal withstand rating of the cables…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 2. Identify and explain the safety procedures and precautions when working with tools and…

A: Electrical cables are used for sending signals and also for long distance communication. There are…

Q: 17. In an air compressor system, the distribution piping can be bonded using the A. equipment…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Service-lateral conductors are required to be insulated except for the grounded neutral conductor…

A: According to NEC 230.30 (A), underground service conductors are insulated for the applied voltage.

Q: 2. What is type of Ring counter Explain them?

A: A ring counter is a composed of flip-flops connected into a shift register, with the output of the…

Q: 1-DO you need a repeater station if we used optical cable under the sea level? And why?

A: If we used optical cable under sea level then there is a chance that it lose or reduce its signal.…

Q: 8. You've just completed a large structured cabling installation and notice that in a bundle of…

A: According to NEC (National electrical code) , in the installation of cable structure , unmarked and…

Q: 10. Which of the following statements about ground faults is true? A. They usually occur between any…

A: Ground faults: It happens when an energized conductor develops an accidental contact with the…

Q: c) Explain what happens when a switched is closed for transmission line terminated in an open.

Q: 3. All exposed noncurrent-carrying metal parts of an information technology system shall be to the…

A: All the exposed noncurrent carrying metal parts of an information technology system shall be bonded…

Q: Please answer the question full sentence 5. Identify the minimum distance requirements between…

A: The minimum distance between the network cable and power sources is 50 millimeter or 2 inches.

Q: Which type of conductor is not used in cables for Transmission Lines? О А. Соррer O B. Aluminium O…

A: A conductor is the most important component of a transmission line. A good conductor should have the…

Q: Which of the following statements about equipment grounding conductors is true? A. Unacceptable…

A: Correct option is B that is ELECTRIC GROUND CONDUCTORS must be capable of withstanding the higher…

Q: Identify and describe the step-by-step process used to install cable in the NCT Colledge buildings?…

A: According to the question we need to Identify and Identify and describe the step-by-step process…

Q: 14.a. Section 250.94 requires that an IBT be accessible for inspection and termination and have the…

A: 14.a. IBT stands for Intersystem Bonding Terminal. According to NEC Section 250.94 (B) An IBT be…

Q: Explain the two main testing process used in testing transmission cables.

A: Fiber optics is a technology that is connected with the transmission of information as light rays…

Q: What's the required bend radius for three-conductor, 3/0 AWG service entrance cable that's…

A: Given, Three-conductor, 3/0 AWG service entrance cable that's approximately 1 inch in diameter.

Q: 0.2. Find and mention the type of cable for the given example/ applications in the table below. (#…

A: Telephone and modem lines Classification of cable: Insulated copper wire is used. Type of cable:…

Q: How many conductor volume allowances should be applied for the equipment grounding conductors in the…

A: We need to answer how many conductor volume allowances should be applied for the equipment grounding…

Q: Discuss Suspension insulators are recommended in high voltage transmission lines.

A: Pin encasings become excessively cumbersome an uneconomical past 33 kV. Thus, for voltages higher…

Q: Determine the Primary Conductor Size (include the AWG size number), Secondary Conductor Size…

A: P= 90 KVA Three phase transformer 400/230 V

Q: g) How do voids in the insulation cause breakdown of the cable?

A: As per our policy, i have attempted 1 question How do voids in the insulation cause breakdown of the…

Q: Difference between Mailbox and Queue

A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static in…

Q: . A grounded circuit conductor and the equipment grounding conductor should always be joined at the…

A: Choose the correct option A grounded circuit conductor and the equipment grounding conductor should…

Q: NO. 3 In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A: We have to describe the OIL CIRCUIT BREAKER with proper schematic diagram. First we can discuss…

Q: list the material required for overhead service connection

A: Various Types of Electrical service connections - Overhead Underground Majorly overhead is…

Q: 6. Which type of transmission technique is employed by paging system?

A: The solution is provided in the following section.

Q: State the types of transmission lines.

A: Types of transmission lines are as follows 1. Co-axial line 2. Two wire line 3. Optical fiber…

Q: The cost of insulation for underground cable is less than the cost of insulation for TRUE / FAL…

Q: Write all information about cable of extra super voltage?

Q: In the conduit diagram shown in attached picture, determine how many wires are in each conduit…

A: The circuit is shown below: Between the three-phase line and the disconnect switch. The switch is…

Q: Explain the working of LVDT with neat diagram.

A: LVDT : LVDT is divice which translates linear motion into electrical signal

Q: What is the box fill volume allowance for each conductor originating outside and terminating inside…

A: We need to answer what is the box fill volume allowance for each conductor originating outside and…

Q: What is grading of cables, explain.

A: Grading is defined as the process of equalizing the stress in the dielectric of the cable.…

Q: Identify and describe the step-by-step process used to install cable in the NCT Colledge buildings

A: according to question, Identify and describe the step-by-step process used to install cable in the…

Q: What Cable Color-Coding is typically used for the Earth Wire in the Sultanate of Oman? A. GREEN AND…

A: Sultanate of Oman the following colour coding is used

Q: what is the voltage between neutral and protective earth conductor in the TN-S earthing schemes…

A: In TN-S earthing scheme, T stands for solid earthing, N denotes the presence of the conductor having…

Q: A? Conductor is defined in NEC 240.2 as a conductor, other than a service conductor, having…

A: The article 240.2 determine the current limiting of the over current protective device is used to…

Q: A two conductor street main AB, 500 meters in length is fed from both end at 250 volts. Load of 50A,…

A: The solution can be achieved as follows.

Q: The copper line with a total length of 20 meters operates in the 220 volt city network. If three…

Q: 4.a. An intersystem bonding termination will typically be used as a ground junction for a/an A.…

A: Answer 4.(a) According to 214 NEC, Intersystem bonding method is only one bonding method permitted…

Q: On a 120/240 V, single-phase, three-wire system, identify the following: a. Voltage between one…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

Which type of Insulator used for LOW Voltage transmission line at dead-end tower:
a. Pin Insulator
O b. Strain Insulator
O c. Suspension Insulator
O d. Shackle Insulator

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is the code of installation (single core single wire) cable? Tesisat kablosunun kodu aşağıdakilerden hangisidir? A) YW (NYY) B) NV (NYA) C) NYCY (YVMV) O D) NVV (NYM) E) NYMHY (H05VV-F)
4. What can installation records be used to determine while servicing equipment?A. Broken connectors in a cable linkB. Problems due to aging during operationC. Broken fiberD. Decreased bending radius during operation
The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station.
3. The three bus-bar conductors in an outdoor sub-station are supplied by units ofpost insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station. [38-8 kV]
3. The zero sequence current is times the current in neutral wire.
2. What's the primary instrument for locating a break in a cable during emergency maintenance?A. OSAB. OTDRC. MultimeterD. Power meter
Work Breakdown Structure for electrical bus
12 - Due to the effect of the resistance of the cable connected to RTD, two-wire cables up to ……. meters and three-wire cables up to ……... meters are used in standard designs. A) 10-150B) 40-500C) 50-195D) 30-230E) 200-1000
c.1. Which of the following is one of the three essential functions of an equipment grounding conductor?A. Provide an arc-fault current pathB. Establish groundingC. Establish bondingD. Ensure the system is groundedc.2. What's another name for the three-point method of Earth resistance testing?A. Fall-of-potentialB. Line surgeC. Spatial shieldingD. Leakage current c.3. If the National Electrical Code provides a requirement to ground equipment, it generally implies thatthere will be a direct connection to the Earth of a connection through a/anA. grounding electrode conductor.B. equipment grounding conductor.C. equipotential bonding conductor.D. bonding conductor.
Which of the following Surge Diverter use non-linear resistances in its fabrication? Rod - Gape SD. Lightning Arrester SD. Expulsion Tube SD. O All of the above.
"The arc across the contacts of circuit breaker will re-strike, if the rate of rise of re-striking voltage is greater than the rate of rise of dielectric strength between the contacts? " True False
What are the possible faults in underground cables. Illustrate the methods of fault localization.