Which solvent mixture is more polar: the 50:50 mixture or the 25:75 mixture? Explain briefly What would happen to the Rf of the spots in solvent #2 compared to solvent #1? Why?
Q: How do we keep relative supersaturation low by controlling temperature? temperature should be…
A: Relative supersaturation is ratio os supersaturation for improving the relative supersaturation we…
Q: In an IR spectrum ,a peak between 2000 - 2500 cm should correspond to a functional group?
A: In IR spectroscopy we measure where molecules absorb photons of IR radiation. The peaks in an IR…
Q: Quinine 0.07 0.26 0.19 Codeine 0.16 0.53 0.38 Cocaine 0.65 0.90 0.73 Strychnine 0.28…
A: Rf value: It is the ratio of distance travelled by solute to distance travelled by solvent.…
Q: p-dihydroxybenzene and o-dihydroxybenzene can be separated by TLC using a solvent of medium…
A: We know that in a TLC plate if we are using the non-polar solvent then it can form bonds (…
Q: Here is an IR of another monoterpene, this one isolated from steam distillation of marjoram. Which…
A: Characteristic peaks for OH str in IR = 3300-2500 cm-1 Characteristic peak for C=O str in IR = 1700…
Q: The red line shows the average total charge on each molecule in solution (right axis), while the…
A:
Q: Which combination cannot be used as mobile phase in RPLC? A. Water-acetonitrile B.…
A: Which combination cannot be used as mobile phase in RPLC? The combination is given below.
Q: On the following TLC plate Compounds 1 and 3 are pure compounds. Compound 2 is a unknown mixture.…
A:
Q: Qs4. This is a TLC analysis of 3 individual compounds. The plate was run in 20 % ethyl acetate, 80%…
A:
Q: cold dilute KMNO4 А Ch H2 O3 В Ni uv Zn/CH3COOH hot KMNO4 OH
A:
Q: CI но. он HO,
A: THE HYDROGEN BOND EXIST BETWEEN hydrogens connected to three electronegative elements like…
Q: Solvent A gives Rf values for the two unknown dyes of 0.28 and 0.67. Solvent B gives Rf values for…
A:
Q: 3412.60 1419.25 1362.72 1221.21 1092.92 763.42 702.30 600.37 529 52
A: For interpretation of an IR spectra of a molecule we have to first look for some special frequency…
Q: Problem attached
A: The absorption of ultraviolet radiations in the UV-visible spectroscopy results in the excitation…
Q: Briefly explain what you would expect the result to be of the following scenario: You have two…
A:
Q: Can we use Niacinamide toner before use 0.5% Bakuchiol?
A: Yes we can use there is no any side effects.
Q: 2873 32 1739.51 1465.18 1387.71 1366.42 1171.25 1054 72 961.35
A: Given: Infrared spectrum of an unknown compound To find: To identify the unknown compound by using…
Q: A fresh TLC plate is spotted with compound A,B and C, but with methylene chloride as a solvent. How…
A: The solution is given below -
Q: IR- analysis- Complete the following
A: Ir spectroscopy is used to identify the functional group present in an organic compound.
Q: Shich will have no effect on an Rf value in TCL?
A: We have to tell which option is correct from given choices of options
Q: The absorbance (A) of a solution is related to its concentration (C) according to the Beer-Lambert…
A: Lambert Beer's law gives the relation of concentration with respect to absorbance as; A=εC where A…
Q: The crocodile, which can remain under water without breathing for up to 1 h, drowns its…
A: When crocodile spends a lot pf time in underwater the concentration level of CO2 in its body…
Q: The true structure was revealed when she followed a colleague’s suggestion: to dissolve the compound…
A: A question based on intermolecular force of attraction, which is to be accomplished.
Q: The random letter labels in this diagram of allylcyanide are to be associated with the corresponding…
A: Given, Compound : Allylcyanide
Q: The mixture below is seperated using HPLC with a octadecylsiloxane (nonpolar) stationary phase and a…
A: In HPLC, the components are separated on the basis physicochemical interactions. If the solute is…
Q: Which compound will have the largest Rf value on a TLC plate using 10% ethyl acetate/hexane as a…
A: Retention factor is also called Rf value. In thin layer chromatography (TLC) Rf value is the measure…
Q: HBr excess or HBr excess
A:
Q: Calculate the % ee of a mixture containing 80% of one enantiomer and 20% of the other? A. 80 B. 120…
A: % ee = % of major enantiomer - % of minor…
Q: Assume you are running a forensic laboratory. Using the table of Rf values below, determine which…
A: Here we are required to find the solvent best suitable for separation of 3 drug sample
Q: IR Spectrum for your banana oil product LOD 4000 3000 2000 1500 1000 500 HAVENUMB ERI -l
A:
Q: 12. To see plant pigment extracts or pigments such as carotene on the TLC plate: a. One has to use…
A: Thin-layer chromatography is used to identify the product formed during the reaction or check the…
Q: I need to get the rf valuse from a made up value and draw a tlc plate of 30% ethyl actate and 70%…
A: TLC can easily tell whether a reaction is complete or not. On a TLC plate, a polar compound takes…
Q: What is the result when alcohol is mix with vegetable oil? 2. what is the result when acetone is…
A:
Q: a.) Calculate the Rf value: If the unknown pigment has travelled a distance of 0.25 cm and the…
A: ( a) part Pigments are dissolved in a solvent and then allowed to run on a special paper. Then the…
Q: Which will have the highest Rf value from a normal phase TLC? O chlorophyll O B-carotene O…
A:
Q: Why do polar solvents obliterate the fine spectral structures in an absorption band?
A: Polar solvents obliterate the fine spectral structures in an absorption band.
Q: General procedure A mixture of 4-hydroxycoumarin (1 mmol), aromatic aldehyde (1 mmol), methyl…
A:
Q: quartet Off-resonance-decoupled singlet CDCI, (solvent) 200 150 100 50
A: The question is based on the concept of Spectroscopy. we have to interpret the spectra provided and…
Q: Which layer was the ether layer in the simulator? NB: ether is shorthand for diethyl ether.…
A: Ether is organic solvent. And has less density than water that's why it floats on the water. So,…
Q: Chemistry 1.Predict the IR signal in the 1-bromo-3-ethylbenzene. (Approximate wave number for each…
A:
Q: g) HOT h) OH Br 1) 2) CI CI CI DMAP 1) Mg(0), dry ether 2) Å 3) NH4CI, H₂O , Et3N Na₂Cr₂O7 H₂SO4,…
A: I have given the answer in the explanation section. Hope you will understand that.
Q: compare the infrared spectra of acetone and dibenzalacetone and explain the changes in functional…
A: The IR spectra given are
Q: Which of the following carotenoid structures below would you expect to have the lowest RF in a…
A: Given compounds are: Lycopene: It is the red color hydrocarbon found in tomatoes and in all red…
Q: Starting with [Pt(NH3)4]2+ or [PtCl4]2- and using the trans effect sequence, devise a rational…
A: To synthesis [Pt(py)(NH3)(NO2)Cl] with py and Cl at trans using the trans effect sequence from…
Q: stability COLUMN I COLUMN II p-cyanophenoxy m-cyanophenoxy anion anion
A:
Q: Compare acetanilide, which was in the recrystallization lab and acetaminophen (2) shown below. Which…
A: Comparison of Rf values between acetanilide and Acetaminophen
Q: - What patterns do you see in all of the compound models?
A: Pattern seen in formation of MgO
Q: 3. Ethyne HCECH does not show IR absorption in the region 2000-2500 cm because.
A: Hey, since there are multiple questions requested, we will answer first question. If you want any…
Q: Sodium acetate has a strong, sharp IR peak appearing at 1569 cm-1, as shown in the spectrum here. To…
A: The kind of stretching mode associated with the strong , sharp IR peak for sodium acetate in given…
Solvent #1 is a 50:50 mixture of hexane and ethyl acetate and solvent #2 is 25% hexane.
Which solvent mixture is more polar: the 50:50 mixture or the 25:75 mixture? Explain briefly
What would happen to the Rf of the spots in solvent #2 compared to solvent #1? Why?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- Ethyl alcohol and water in liquid form are also an azeotropic mixture. Why is that?What is the main concern with trying to distill azeotropic mixtures? options: 1- Specialized equipment is required, making separation expensive 2- There are no major concerns with distilling azeotropic mixtures. 3-The components become explosive at high temperature, making separation unsafe. 4- The boiling points of the components are too similar, making separation impractical. 5-The mixture will distill at a single temperature with a constant composition, making separation impossibleWhat trend is there as you increase the water content of the solvent system in an SN1reaction? Explain.
- The position of the phases in the separatory funnel (whether the top or bottom phase) is dependent on the relative densities of the solvents. Complete table 1 to indicate whether each of the solvents will be on the top or bottom layer. Table 1. Solubility properties of common organic solvents. Solubility in H20 (g/L, 20-25°C) 9.5 x 10-3 1.79 8.09 17.5 Solubility of H20 (g/L, 20-25°C) 0.31 Phase layer Density (g/mL, 25°C) 0.661 Liquid hexane benzene chloroform 0.76 0.87 1.76 15 170 0.877 dichloromethane diethyl ether 1-butanol 60.5 73 0.3 1.489 1.327 0.713 0.81 0.83 1-octanol 49 ethyl acetate 83 33 0.902A sample of naphthalene is contamined with a small amount of anthracene. The melting point would be about the sample as the pure sample higher and the range broader than the pure sample lower and the range more narrow than the pure sample lower and the range broader than the pure sample higher and the range more narrow than the pure sampleSuppose you wanted to prepare a eutectic mixture of naphthalene and diphenylamine.Determine the masses of each naphthalene and diphenylamine required to make 6.000 gof a mixture at the eutectic composition.
- in fractional distillation, how do you tell which liquid is in which fraction and which fraction has a mix of liquids if you are trying to seperate cyclohexane and toluene?? what would the density and boiling point of the first fraction bePhNH2 10 mol% Til (NMe2)2(dpma) + n-Bu + -Bu-NC `Bu' tol. 100 °C, 48 h, 77% n-Buс. D. = Е. О ..... HI (2 eq.) Solvent HCOO ОН Br + ОН "Br
- 1. Write three major criteria of forming a Hydrogen bond in bullet points with example. 2. Certain amount of pure charcoal (carbon) has to be burnt with supplied natural air. Process engineer allowed the exact amount of air required to burn the entire charcoal completely to carbon dioxide. Carbon has no reaction with nitrogen gas present in the air. In the reaction outlet if 5 kg of nitrogen gas was found, calculate the amount of charcoal used. (12C, 16O, 14N)Suppose you want to determine the eutectic melting point of a eutectic mixture of adipic acid (literature MP 153 degree C) and salicylic acid (literature MP 158 degree C) .What would you do and what would expect to observe? Be sure to include a very specific detailed plan that any inexperienced organic chemistry lab student could follow if they were to use your procedure.Naphthalene, C10H8 is insoluble in water but sublimes easily when heated. How could you separate a mixture of naphthalene and NaCl? Suggest two different methods. asap