Answered: Which is the example of heat sink?…

Engineering

Mechanical Engineering

Which is the example of heat sink? Select one: O a. combustion chamber O b. Boiler O c. river O d. Nuclear Reactor

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter31: Gas Heat

Section: Chapter Questions

Problem 2RQ: Describe the function of a multipoise or multipositional furnace.

See similar textbooks

Related questions

Q: Choose the valid statement about ideal vapor compression refrigeration cycle Select one: O a. Heat…

Q: A) A refrigerator that operates on the ideal vapor-compression cycle with refrigerant-134a is to…

A: A)Reasonable pressure for the evaporator and condenser :

Q: Explain in brief which refrigerant/s would you choose for each of the following applications and…

A: Refrigerant is fluid that carries heat in the refrigerator at low temperature and released the heat…

Q: Find the true order of the components of the refrigeration cycle? a)…

Q: What is a heat pump and how does it work?

A: Note- I only give one solution at one time for other question you will upload again.

Q: question 52 An ideal vapor-compression refrigeration cycle that uses refrigerant-134a as its…

Q: (a) the rate of heat addition, in kJ per kg of steam entering the first-stage turbine. (b) the…

A: Given: Reheat Rankine cycle. High pressure turbine inlet pressure = 12 MPa. High pressure turbine…

Q: question 51 An ideal vapor-compression refrigeration cycle that uses refrigerant-134a as its…

Q: Select a reasonable pressure for the evaporator and condenser in the following scenarios: A) A…

A: Given data:

Q: Describe the adiabatic process.

A: In a thermodynamic process when there is no exchange of heat between a system and its surrounding…

Q: Define the objective of a heat pump is to supply heat QH into the warmer space.

A: The heat pump is a device that is used to supply heat to the system at high temperatures known as…

Q: Hello Sir, Good Morning. I have a question in my homework related thermodynamics lesson. The…

A: To propose whether it is adequate to use water instead of refrigerant 134-1 as the working fluid.

Q: 1. Capacity of the cooling coil in tones of refrigeration; 2. The wet bulb temperature was leaving…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Task 3 An ideal vapor-compression refrigeration cycle that uses refrigerant-134a as its working…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: Differentiate boiler feed water and engine cooling water in terms of its characteristics including…

A: Boiler feedwater The boiler feed water has a very high-quality requirement. The operating life of…

Q: explain the dry steam and flash steam plants in geothermal energy conversion system.

Q: State how the boilers are classified ?

Q: In a two stage compression with intercooling and flash gas removal design, the evaporator pressure…

A: The intermediate pressure: Pintermediate = 500 kPa

Q: QUESTION 53 An ideal vapor-compression refrigeration cycle that uses refrigerant-134a as its…

Q: 17. i. Sketch and explain the working operation of a Dish type solar cooker? ii. With the help of a…

A: To determine: Working operation of dish or parabolic type solar cooker with the help of a sketch.…

Q: An air conditioner is used to cool a house. When the outside air temperature is 306K and the inside…

A: Given data: Outside air temperature is TH=306 K Room temperature is TL=295 K Cooling effect is 17 kW

Q: A 1-ton air conditioner is a unit that will remove the amount of heat neededto melt one ton of ice…

A: Given: Latent heat of fusion of ice=144Btu/lb

Q: 68. The change of enthalpy in a heating chamber of dryer is 25 Btu and the mass of air supplied is…

A: As per our guidelines we are supposed to solve only one question if multiple questions are asked .…

Q: create a diagram of the geothermal energy flow in a geothermal power plant.

A: Draw the block diagram of the geothermal energy flow in a geothermal power plant

Q: Modern (latest) innovation in domestic refrigerators and air conditioners.

A: given; Modern (latest) innovation in domestic refrigerators and air conditioners.

Q: The device that receives heat energy from source and that rejects heat into sink is known as a. Heat…

A: The device that receives heat energy from source and that rejects heat into sink is known as a. Heat…

Q: Problem 3 For the system to the right, why would we want to heat the hot water heater using the HVAC…

A: Heating, ventilation, and air conditioning (HVAC) are the three components of HVAC. Residential…

Q: Task 4 1. Assess the limiting factors that impact on the economics of heat pumps. As an example,…

Q: In a domestic vapour compression refrigerator, the refrigerant commonly used is, (A)…

A: Given: Refrigerant: This is the working fluid used in the refrigeration cycle , It undergoes the…

Q: Your answer is correct. Determine the rate of heat transfer, in Btu/h, to the working fluid passing…

A: The solution is attached

Q: steam consumption ?

A: Given; For an ideal rankine cycle operating between pressures of, P1=30 bar P2=0.04 barThe work…

Q: Task 2 Select a reasonable pressure for the evaporator and condenser in the following scenarios: A)…

A: Soon:- A evaporator takes heat from refrigerated space which is maintaine at -10 °c , for proper…

Q: An inventor has developed a refrigeration unit that maintains the cold space at 14°F while operating…

A: The given data in SI units is

Q: ifferentiate Refrigerator from Heat pumps in terms of: (a) Transfer of Heat, (b) Location of the…

A: Given Refrigerator Heat pump To find Differences

Q: Which one of the following types of geothermal power plant is suitable when fluid obtained from…

Q: What are the basic concepts to chose the number, type and location of feed water heaters in a…

A: A feedwater heater is used in the power plant to preheat the boiler feed water. The Source of the…

Q: QUESTION 54 An ideal vapor-compression refrigeration cycle that uses refrigerant-134a as its…

Q: 1- what's is the main benefit for the cooling tower packages.

A: The cooling tower packages, located between the water distribution level and the cooling water sump,…

Q: The figure shows a two-stage, vapor-compression refrigeration system with two evaporators and a…

A: Here, it is not mentioned that what is asked to determine.so we can calculate here work given to…

Q: 1- Why use waste heat in air conditioning system? 2- Why during winter season the temperature of…

A: Given Air condition To find Importance of waste heat in air conditioning system Temperature of…

Q: Describe the four processes, which occur in the vapor-compression-refrigeration cycle that you…

A: Compressor, condenser, expansion valve/throttle valve, and evaporator are the four components of…

Q: evaporator is at -20°C & 0.1 MPa and the discharge of the condenser is at 30°C & 1.0 MPa. Determine…

Q: Explain two technical points for direct and indirect fired heaters

A: Direct heater: A direct heater or direct fire heater is a type of heater in which a burner transfer…

Q: In the heat pump system, the heat is usually rejected by ______________ A. expansion device B.…

A: Heat Pumps: The devices that transfer heat from cold bodies to hot bodies are called heat pumps.…

Q: Differentiate refrigerator and heat pump

A: Both the refrigerator and the heat pumps carry the heat from low temperature reservoir or the sink…

Question

Which is the example of heat sink?
Select one:
O a. Combustion chamber
O b. Boiler
O .river
O d. Nuclear Reactor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a. Explain the principle of operation of geothermal heat pump depicted in the Figure below. Geothermal Heat Pump (heating, cooling. domestic hot water) Ground loop - plastic pipe in drill hole b. Explain how the solar water heater (s@ picture a) and the solar oven (see picture b) operate. Cool Collector Hot Hot water Warm water storage Cool Cold water a) b)
Module 4 Heating Effect of Electric CurrentHow long will it take to raise the temperature of 880 gm of water from 16ºC to boiling point ? The heater takes 2 amperes at 220 V and its efficiency is 90%.a.11.26 minc.13.08 min b.12.56 mind.14.05 min ____ 13. An electric kettle is required to raise the temperature of 2 kg of water from 20ºC to 100ºC in 15 minutes. Calculate the resistance of the heating element if the kettle is to be used on a 240 volts supply. Assume the efficiency of the kettle to be 80%.a.72 ohmsc.83 ohms b.62 ohmsd.93 ohms
What is the total required heating energy in raising the temperature of a given amount of water when the energy supplied is 1000 kwh with heat losses of 25% ?* Choice: A. 1000 B. 1500 C. 1333 D. 1250
Question 1 Benifits of Building Energy Management System (BEMS) Provide energy analysis and management information Optimise plant operations and services O All of the options O Monitor plant status and environmental conditions O Switch plant on and off automatically
Q3) give the short answer for the questions below; a) Growth the frost over evaporator surface lead to decrease freezer temperature. b) Using copper tube type-k in the shell and tube heat exchanger c) Make a vacuum pressure for the vapour compression cycle (refrigeration system) before charging with refrigerant (give the value of vacuum pressure) d) Age of compressor depending on the number of turn-on and turn- off, not depended on the working time. e) Skin type condenser favorite more than other type of static condenser in the chest freeze f) Draw the relationship between time and difference temperature for the conventional refrigerator cycle control and inverter refrigerator electrical behavior control.
principle of Inverter air conditioner and energy saving.
O a. None of these O b. Absolute pressures and heat capacity ratio O C. Absolute pressures and temperatures O d. Gauge pressures and temperatures In perfect gas law experiment, the pressure pump coupling is used to connect the vacuum vessel to the pump discharge connector. Select one: O a. False O b. True Which part in the mechanical heat pump is used to reduce the refrigerant pnessule? Select one:
I need help with some or all of this problem for thermo! thank you A heat engine with a thermal efficiency of 45% rejects 1000 kJ/kg of heat to a low temperature sink. a. How much heat does it receive (kJ/kg)? b. How much work does it produce (kJ/kg)? c. If the cycle operates between temperatures of 400°C and 50°C, what is the maximum amount of work that this cycle can produce (kJ/kg)? d. A Carnot heat pump operates between 273 K and 313 K, determine its Coefficient of Performance.
f) Differentiate Fire tube boilers and Water tube boilers.
Answer the following: A.) What is the significance of using multiple feedwater heaters? (Write your reference) B.)What is the difference of using multiple feedwater heaters and using only one feedwater heater with their efficiency of cycle? C.) State other things/ways to increase efficiency of a cycle, other than using multiple feedwater heaters.
1- What is the pressure at the Economizer (in bar)? 2- What is the pressure at the Evaporator (in bar)? 3- How much heat received by the Economizer (kW)? 4- How much heat received by the Evaporator (kW)? 5- How much heat received by the Superheater (kW)? 6- How much heat received by the FWH (KW)?.. 7- How much heat received from the fuel burning (kW)? 8- How much heat rejected at the chimney (kW)?. T=35 C From the Pump m-1.3 kg/s + Cpw=4.2 kJ/kg.C ****************** T=150 C, To the Turbine Cp 1.008kJ/kg.K T=400C 44 T=212.2 X=0.0 X=0.85 Chimney Hoo bou to Economizer Evaporator Super Heater -Air, m-4 kg/s, T=20 C P=5 bar, X=0.8, m=0.3 kg/s from FWH X=1 1 Fuel, T-20 C, m=0.2 kg/s, C.V=33.5 MJ/kg Bumer
What exists in a steam boiler operation?a. there is a local equilibriumb. convection heat exchange is the main mechanism of heat transferc. generation of kinetic energy of turbulence and rate of dissipation are not the samed. supersaturation temperature of water is achieved