Which component of the HFC is the point of conversion from optical to electrical and vice versa? O Directional coupler O Power Supply Power inserter O Node

Q: For the following networks determine V. ID.PD.VR and PR.

A: The required parameters can be calculated by using the state of the diode and the drop across the…

Q: Q2-A-For VCO-LO that represent FM-TX if frequency of the carrier signal at -5 volt. Calculate the…

A: It is given that:

Q: B) Determine the internal optical power of the double hetetostructure LED has 85% quantum efficiency…

A:

Q: 50kVA 2300/230 V single-phase transformer has following test results:OC test: 230 V, 2 A, 359WSC…

A: A single phase transformer input and the output is a single phase AC. It has two parts magnetic and…

Q: A 208-V, two-pole, 60-Hz Y-connected wound-rotor induction motor is rated at 15 hp. Its equivalent…

A: Given data, V=208 V, f = 60 HzR1=0.2 Ω, R2=0.120 ΩX1=0.410 Ω, X2=0.410 Ω, XM=15 ΩPF&W=250 W,…

Q: R1 R2 010v @ @

A:

Q: 16.0V 12 ** 10.0 0.592 7.82 1.5 2 4.0 V 0.22 어디스 2 3 92

A:

Q: The reactance data for the power system shown in Figur in per unit on a common base is as follows:…

A: Positive-sequence impedance network for Problem-   The positive-sequence impedance network is…

Q: output is a type of output structure used to connect one side of the device to ground.

A: In the fields of electronics & electrical engineering, a point in a circuit is referred to as a…

Q: 16. You have a tuned circuit with a resonant frequency of 3.7 MHz and a quality factor (Q) of 250.…

A: Given: In a tuned circuit, Resonant frequency, fr=3.7 MHz Quality factor, Q=250

Q: 2. Create a Sum of Products expression D A B IDO Å Å

A: Given circuit,

Q: A 470 ohm resistor has 18.8 volts across it. What is the power consumed by that resistor? Enter your…

A: Given, Resistance, R = 470 ohm Voltage across it, V = 18.8 volts

Q: Simplify the following Boolean functions by first finding the essential prime implicants: F (A, B,…

A: Given data :  Boolean functions : F (A, B, C, D)=Σ(0, 2, 3, 5, 7, 8, 10, 11, 14, 15)

Q: Q3) In a long-shunt compund generator, the terminal voltage is 230 V, when it delivers 150 A. The…

A:

Q: A) Define the following: 1. Optoelectronics. 2. LASER. 3. Optical Detector. 4. External quantum…

A: 1. Optoelectronics: It is the study of electronic devices and systems that find, detect and control…

Q: Choose the correct answer: a) the purpose of multistage amp 1. Impedance matching. 2. Increase the…

A: In this question we will error about Multistage amplifier....

Q: 1. Find the total charge inside each of the volumes indicated: a) pv = 10z²e0.1xsinπy, -1≤x≤ 2/3,…

A: As per our guidelines we are supposed to be the first question only. Kindly repost the other…

Q: Consider the given circuit shown below and find its cutoff frequency (in KHz) 22k 22k V₁-WWW 330pF…

A: Given circuit, R1=R2=22 kΩC1=C2=330 pF

Q: Q2. Using Kirchhoff's voltage law, find the unknown voltages for the configurations in Figure 2 10 V…

A: Given circuit:

Q: Define the carry propagate and carry generate for a lookahead carry generator asP i = A i + B i G i…

A: The first stage of a parallel adder is given by,

Q: 3.In ASK modulation, the modulated wave A) has frequency changes B) is pulsating (appears as…

A: We need to select correct option for given ASK .

Q: Draw a logic diagram constructing a 3 × 8 decoder with active-low enable, using a pair of 2 × 4…

A: A circuit device that changes a code into a set of signals, know as decoder. It is a just reverse of…

Q: In the signed-2’s-complement system, negate the number 710, represented with 8 bits.

A: A 2's compliment is used for the encoding of the positive or the negative number into a binary…

Q: The outputs of two CMOS inverters are accidentally tied together, as shown in Figure below. What is…

A: CMOS : CMOS also known as complementary metal-oxide semiconductor It is a combination of PMOS device…

Q: Q4) Consider three-stage space-division switch using CLOS criteria with N=450. 2. Calculate the…

A: The ingress stage, the middle stage, and the egress stage are the three stages of CLOS network. Each…

Q: Q3- Using the voltage divider rule, find the indicated voltages in Figure 3 www 1.5 Ω 0.72 V + 4.…

A: Given circuit:

Q: Implement the Boolean function F ( A , B , C ) = Σ ( 3 , 5 , 6 , 7) with a multiplexer.

A: Multiplexer: It is a sequential circuit. It is also known as many to one because it has many inputs…

Q: Find the currents I0

A:

Q: Write a continuous assignment statement that describes Y in the logic diagram in Fig. PE3.12, where…

A: The given logic diagram is shown below:

Q: For the single phase fully controlled bridge is connected to RLE load. The source voltage is 230 V,…

A:

Q: Determine the remaining intensity of the light leaving through 8.3Km optical fiber if the…

A:

Q: 7) For the sequence {1, 0, 1, 0}, IDFT will be None of the above {0.5, 0, 0.5, 0} {1, 1, 0, 1} {0.5,…

A: Given data, Yk=1,0,1,0 Length of the sequence N=4

Q: Design the circuit of a source follower JFET amplifier biasing circuit with load R₂ and input…

A:

Q: a) List the main factor in determining the value of the reverse saturation current in the diode.…

A: a) Answer: Temperature (and minority charge carriers concentration)

Q: TTL uses field-effect transistors. O True O False

A: TTL stands for transistor transistor logic . Name tells that transistors are used for building any…

Q: Simplify the following functions, and implement them with two level NOR gate circuits:…

A: Given expression: F=wx'+y'z'+w'yz'

Q: 1. A test device is a linear time-invariant system, and its transfer function is H(s)=1/(0.007s +1).…

A:

Q: 8) A 230 V fed single quadrant chopper has a 40% duty cycle. A separately excited DC motor is…

A: It is given that: Vs=230 VD=0.4km=0.5 VradsRa=2 ΩN=1400 rpm

Q: The power spectral density function of a stochastic process X(t) is given by: SXX(f) = 6250 [5² +…

A: "According to the Company's policy we will solve first three parts". Given the power spectral…

Q: A balanced star load with impedances of 6∟45o ohms is connected to a three-phase, four-wire, 208…

A: Given data, Load impedance Zph=6∠450 Ω Line voltage, VL=208 V

Q: Determine IB, IC & VCE for a base biased transistor circuit with the following values: βdc = 90, VCC…

A: We need to find out the current and voltage for given circuit

Q: Convert the number 1100000 from binary to decimal, show your work. Answer:

A: Given data, Binary number is 11000002

Q: Using mesh analysis, find 1₁ and 12 from the circuit given below, where Vs1 = 66/30° V. j10 Ω 40 Ω…

A: Given circuit:

Q: The following digital IC is: TTL AND gate OTTL NOT gate CMOS NAND gate TTL NAND gate OCMOS AND gate…

A: Given, Digital IC (integrated Chip ) is SN 7400 N

Q: What is the output F of the following circuit? +2.5 V OVO 1₁. Mp1 MNI +2.5 V Mp2 F MN2 Hi

A:

Q: Determine Vo2 A) -1.0 V B) -2.4 V C) -6.6 V -9.0 V -10 Vo Ge Si KK I 1.2kQ 3.3 K2

A:

Q: Three identical impedances of 10∟53.1o ohms are connected in delta to a three-phase three-wire 240…

A: In this question,  We need to determine the line current and total power?  We know line current I=…

Q: Find VH, VL, VREF, and DeltaV for the ECL gate shown below. Q3 -1.3 V VOLO 13 R VBE3 Rc iB3 UCI · 42…

A: The given circuit diagram is shown below:

Q: Q3: The response of a pressure sensor is determined experimentally and given in the table below. A…

A: Given data, Pressure(kPa) 10 20 30 40 50 60 Voltage(V) 0.3 0.3 0.4 0.6 0.8 1

Q: 3. Use figure 2 for answering questions a-f. a) b) c) d) 115 V rms 60 Hz Vpis 10:1 eeeee 00000 Dis…

A: For the given figure answer the following question: PIV for each diode. Average output Voltage,…