When 20.00 ml of sulfuric acid of unknown concentration is titrated with 0.1249 M NaOH,  32.50 ml of titrant are needed to reach the end point.  What is the molarity of the sulfuric acid?  (Give both the calculator answer and the significant figure answer).

Q: If 20.88 mL of acetic acid are used in a titration and the molarity of the acetic acid is 0.0985,…

A: The number of moles of acetic acid can be calculated as, Molarity = No. of moles/Volume (L) No. of…

Q: An aqueous solution of hydrochloric acid is standardized by titration with a 0.156 solution of…

A: Note: Barium hydroxide, Ba(OH)2 is a base. Hydrochloric acid, HCl is a acid. Given, Barium hydroxide…

Q: 17.5 milliliters of a  0.496 M RbOH   solution are required to titrate 52.1 milliliters of a H3PO4…

A:

Q: Your lab assignment presentation involves putting together a presentation to show other students on…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Suppose that extra volume (more than the actual volume) of 0.2 M NaOH solution was used to reach the…

A: fullscreen

Q: A student titrates samples of a base with a standardised acid. The titration values obtained for…

A: Given that,   Student titrates samples of a base with a standardised acid The titration values…

Q: Suppose you are titrating a sulfuric acid solution of unknown concentration with a sodium hydroxide…

A: The balanced reaction taking place is given as, => H2SO4 + 2 NaOH ------> Na2SO4 + 2 H2O Given…

Q: Suppose you are titrating an acid of unknown concentration with a standardized base. At the…

A:

Q: A 30.00 ml sample of sulfuric acid is titrated to the endpoint with a 0.1000 M lithium hydroxide…

A:

Q: Suppose you are titrating an acid of unknown concentration with a standardized base. At the…

A: Acid + Base ---------> Salt + waterIt is a neutralization reaction where base present in the…

Q: [Review Topics] [References] Use the References to access important values if needed for this…

A: The reaction taking place is  2 HCl + Ba(OH)2 ----> BaCl2 + 2 H2O  Hence from the above reaction…

Q: Would the following procedural errors result in an incorrectly high or low calculated percent NaOCl…

A: The explanation of the experiment is given below

Q: units in the first column. Tablet identity (brand) Tums Titration Tablet 1 Mass of tablet/sample (g)…

A: Volume of NaOH = final reading - initial reading                             = 48.7 - 30.3…

Q: What was the concentration of the weak acid?

A: Titration is the process of adding a measured volume of an acid or base of known molarity to an acid…

Q: Suppose you are titrating an acid of unknown concentration with a standardized base. At the…

A: Initial volume reading of the burette = 2.31 mL Final volume reading of the burette = 22.53 mL…

Q: A 27.00 mL sample of sodium hydroxide was titrated (neutralized) with 31.7 mL of 0.150 M sulfuric…

A: In an acid-base neutralization reaction, the H+ ions of the acid neutralized by equal moles of OH-…

Q: a) A titration is a method of analysis in which the result is achieved by the measurement of volume.…

A: A titration is a quantitative technique where the concentration of an unknown solution is determined…

Q: Given the following information, what is the molar mass of an unknown monoprotic acid? (titration)…

A:

Q: A titration experiment between barium oxalate and HCl was done, with HCl as the titrant. The barium…

A: 10 mL aliquot of barium oxalate is titrated with 10.70 mL of 0.000560 M HCl solution.2 moles of…

Q: Use the References to access important values if needed for this question. An aqueous solution of…

A: Given : molarity of Ba(OH)2= 0.186 M Volume of HCl solution = 20.3 mL And volume of Ba(OH)2 solution…

Q: An aqueous solution of hydrochloric acid is standardized by titration with a 0.163 M solution of…

A: Recall the measurements, Molarity of Barium hydroxide=0.163 M, Volume=15.2 ml Molarity of…

Q: Suppose you are titrating an acid of unknown concentration with a standardized base. At the…

A: Acid-base titration: Titration is a method to determine the concentration of unknown acid by using…

Q: how would this affect the calculated concentration of the standardized NaOH solution?

A: We have to tell affect the calculated concentration of the standardized NaOH solution

Q: Suppose you are titrating an acid of unknown concentration with a standardized base. At the…

A: Acid-base titration: Titration is a method to determine the concentration of unknown acid by using…

Q: 21. When 20.00 ml of sulfuric acid of unknown concentration is titrated with 0.1249 M NaOH, 32.50 ml…

A:

Q: 1. If 2.50 ml of vinegar requires 34.90 ml of 0.0960 M NaOH to reach the equivalence point in a…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: You titrated HCl with 0.866 M NaOH and you wrote the initial and final volume of NaOH used in the…

A: For the neutralization of NaOH by HCl: MNaOH x VNaOH = MHCl x VHCl

Q: student is asked to standardize a solution of barium hydroxide. He weighs out 0.952 g potassium…

A: Given that:  Mass of potassium hydrogen phthalate(KHP) = 0.952g  Molar mass of KHP = 204.2 g/mol…

Q: If the initial volume reading for the first titration was 2.78 mL and the final volume reading was…

A: Initial reading=2.78 mLfinal volume reading=8.36 mL

Q: Suppose in a titration of a monoprotic acid a student needed 31.36 mL of 0.1105 M NaOH to reach the…

A: Answer :- 60.87 g/mol  The Molar Mass of unknow monoprotic acid = 60.87 g/mol…

Q: Suppose you are titrating an acid of unknown concentration with a standardized base. At the…

A: In this titration, base is taken in the burette. Base is added from the burette.  To measure the…

Q: If the initial volume reading for the first titration was 0.32 mL and the final volume reading was…

A: Volume used in titration = Final volume - Initial volume                            . . . (1)

Q: San Pellegrino mineral water is 208 mg of calcium per liter according to the FDA. A. What is the…

A: The presence of calcium and magnesium in water results in the hardness of water. The concentration…

Q: Consider a titration where 0.215 M potassium hydroxide is added from a burette to 10.00 mL of…

A: The titration between a strong base, KOH, and a strong acid, HCl results in the formation of a…

Q: Use some or all the data below to calculate the concentration of acetic acid (in M) in the Walmart…

A: The titration of acetic acid (vinegar) by NaOH takes place as,…

Q: The student weighs out 0.18 g of a diprotic unknown acid and dissolves it in approximately 50 mL of…

A: Since the acid is diprotic  hence moles of NaOH required to reach end point = moles of acid X 2…

Q: To do a titration (neutralization), a student started with 18.25 ml NaOH in a buret with a…

A:

Q: Suppose you are titrating a sulfuric acid solution of unknown concentration with a sodium hydroxide…

A:

Q: Suppose in a titration of a diprotic acid a student needed 31.84 mL of 0.1105 M NaOH to reach the…

A:

Q: You determine the molarity of an unknown acid by titrating it with 0.38 M KOH. You use a 73.08 mL…

A: The required reaction is given by, M1V1=M2V2 where M is the molarity and V is the volume.

Q: If 21 mL of 3.2 x 10–5 M magnesium chloride and 15 mL of 1.5 x 10–4 M sodium fluoride are mixed,…

A: Volume of Magnesium Chloride solution = V1 = 21 mL = 0.021 LVolume of odium Flouride solution = V2 =…

Q: the buret to an initial volume of 1.42 mL.  When the reaction is complete, you note the final volume…

A: The neutalization reaction between HCl and calcium hydroxide is given below-  Ca(OH)2 + 2HCl…

Q: Volume of sulfuric acid in sample (ml) Initial burette reading (ml) Final burette reading (ml) Total…

A: Using the stoichiometric ratio of KOH and H2SO4 , average volume of KOH, and average volume of H2SO4…

Q: If the initial volume reading for the second titration was 0.76 mL and the final volume reading was…

A: Interpretation-  To determine the volume of iodine solution which is used in the second titration (…

Q: 5. A student prepared and standardized a NaOH solution. He then used this NaOH solution to determine…

A: Molarity is defined as the number moles of solute present in one liter of solution. The instrument…

Q: Suppose you are titrating a sulfuric acid solution of unknown concentration with a sodium hydroxide…

A: Given :-H2SO4+ Na2SO4If 26.63 mL of 0.910 M NaOH solution isrequired to titrate 180.9 mL of H2SO4…

Q: Suppose in a titration of a diprotic acid a student needed 25.64 mL of 0.1105 M NaOH to reach the…

A:

Q: In an experiment to determine the content of acetylsalicylic acid in an aspirin tablet, the result…

A: Answer: Given- the calculated mass of acetylsalicylic acid was much higher than the indicated amount…

Q: A student performed a titration on a commercial acid certified to be 0.500 M. Using her data from…

A: The percent error is calculated by the formula, Percentage error=Measured balue-True valueTrue…

Q: Why can't the 250-mL Erlenmeyer flask be used to measure the vinegar needed in the titration?…

A: The titration is used to determine the concentration of an unknown acid/base solution using the…

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.