What is the mass, in ounce mass, of the object below? Hint: A and B are parallels respectively.  (Symmetrical | Unit: Inches | Physical Material: Aluminum |

Q: *) Determine the force in members ab,dh,dg, eg, hi,hj, & hk of truss shown in figure?

A:

Q: 2. Consider a regenerative vapor power cycle with one open feedwater heater. Steam enters the…

A:

Q: Convert the reading of pressure to kpa.

A: Given data; Borometer reads =760 mm of Hg Convert 80 cm of Hg into kpa ?

Q: An ideal gas whose R = 25.8 ft-lbf/lbm-R and k = 1.09 was cooled from 636 R to 565 R at constant…

A: T1 = 636 R T2 = 565 R R = 25.8 ft-lbf/lbm-R k = 1.09

Q: Problem 4: A cast iron shaft, ASTM-25 with an ultimate tensile strength of 25,000 psi, is subjected…

A:

Q: What are the reaction forces?

A: we have to determine the reaction forces

Q: 3- The following rod rotates about AB axis. If the angular velocity and acceleration are…

A: Given: Let us consider the given, angular velocity ω= 6 rads The angular acceleration, α=-25 rads2…

Q: The cylinder in Fig . 2-11 is used to raise the weight 9 in. If the bore of the cylinder is 21/2 in.…

A:

Q: What is the mass, in grams, of the object below? (Symmetrical | Unit: Millimeters | Physical…

A:

Q: Determine the phase of a substance: Water at 2000C and 10MPa

A:

Q: 20 kN/m Determine reactions in A and tension in cable as shown in fig 300 kN 30 kN/m Cable

A:

Q: A sab Later, one thickness is maint oined at surfaces is in veched to. increased to 50°C. 20°C…

A: Given : To find : Temperature distribution

Q: Ax 60° 384 100 luo 100kN Upt God

A:

Q: A Carnot engine operates between the temperature limits of 501.85°C and 31.85°C while producing 54 x…

A:

Q: A one-ton car is initially travelling at 10 kph when it combusts 50 grams of fuel with calorific…

A: Given data v1=10 kphCV=15000 kJm=1000 kg Here, m is the mass of the car and CV is the calorific…

Q: 11. Air enters a 10 m long section of a rectangular duct of cross section 25 cm x 16 cm made of…

A:

Q: Superheated steam at 652 psia and 608 F is generated in an Oil-fired boiler at the rate of 100,000…

A: Write the enthalpy of the superheated steam. hg=1290.72 Btu/lb Write the enthalpy of the feed water.…

Q: Q3. The inclined beam is suffered by king eat (1) vollar alf). Dettimine the load at (land() and B…

A: Given: The load, P = 500 N

Q: Explain the following motion for Planar Kinematics of Rigid Bodies a) Translation b) Rotation c)…

A: Given question: Explain the following motion for Planar Kinematics of Rigid Bodies a) Translation b)…

Q: B looks 50 g 66° t's C 80° Yo 4ft 36 38 66 2ft E

A:

Q: ) Determine reactions in A and tension in cable as shown in figure? 300 KN 30 kN/m 20 kN/m 4m 8m T…

A:

Q: A 10-inch waterwheel were spinning by the weight of flowing water at one liter per second. If the…

A:

Q: T3.2.1The bracket shown below is to support a total load (equally divided between the two sides) of…

A: Given data as per the question safety factor = 3 Calculations T=F2(55+x)=30×103(55+22.5)=2.325×106…

Q: Air enters the compressor of an ideal Brayton refrigeration cycle at 100 kPa, 300 K, with a…

A:

Q: Q2: The 5.5-kg lever OA with 250-mm radius of gyration about O is initially at rest in the vertical…

A: Introduction: Energy is defined as the ability to work. Potential energy, kinetic energy, thermal…

Q: Q10: Windmills slow the air and cause it to fill a larger channel as it passes through the blades.…

A: In the fluid mechanics the ratio between the mass of the fluid to the volume of that fluid is known…

Q: Convert the reading of pressure to kpa.

A:

Q: A stone is dropped from a deck above a lake strikes the water after 9 seconds. Use acceleration due…

A:

Q: What is the acceleration of the body that increases in velocity from 20 m/s to 40 m/s in 3 seconds?…

A:

Q: Given: Compression Ignition Cycle with the following data: compression ratio - 20 cut off ratio-2…

A:

Q: A composite 3-layered wall is formed of a 0.5 cm thick aluminium plate of thermal conductivity 249…

A:

Q: A wide-flange shape column AB carries a centric load P of magnitude 60 kN. Cables BC and BD are taut…

A:

Q: reversible cycle executed by 1 mol of an ideal gas for which Cp = (5/2)R and Cv = (3/2)R  consists…

A:

Q: 1) Select the lightest W-shaped section that can safely support the load. The beam is made of steel…

A:

Q: A refrigerator used to cool a computer requires 1.2 kW of electrical power and has a COP of 1.8.…

A: Electrical power input, W=1.2 kW COP=1.8

Q: Knowing that at the instant shown the rod attached at A has an angular velocity of 5 rad/s…

A:

Q: Determine the acceleration of the shaft B for 0=600 if the crank OA has an angular acceleration 8…

A:

Q: 4) Weights of bodies M& N are 1000 and 750 kN respectively. Determine all reactions on smooth…

A:

Q: 20 kN/m 6m Determine reactions in A and tension in cable as shown in figure? 300 kN 30 kN/m B 8 m…

A:

Q: A piston-cylinder assembly with a linear spring acting on the piston as shown below contains the…

A: as per guideline i have to solve only three subpart of your question

Q: 4. In Figure S6.4, four particles of masses 1kg, 2kg, 3kg and 4kg are at the vertices of a rhombus…

A: Given: a=2m and b=2m Because angle of b from the horizontal is not given: So we can assume that…

Q: a projectile is fired from the origin at t 0 with a positive v component, the maximum Hight h can be…

A:

Q: c) The population of a city is 800000 and it is to be supplied with water from a reservoir 6.4 km…

A: Find , Diameter of the pipe.

Q: A cylinder consists of an outer tube of internal and external diameters of 16 cm and 18 cm…

A: We know that a cylinder is made up of an outer tube with internal and external diameters of 16 cm…

Q: A 1 mm thick cylindrical tube, 100 mm in diameter, is orthogonally turned such that the entire wall…

A:

Q: 3 The press shown below has a rated load of 25 kN The twin screws have Acme threads, a diameter of…

A: Introduction: In this task, we will compute the velocity of the press head as well as the rated…

Q: Compute the overall efficiency of a hydraulic motor that operates at a pre ssure of 2500 lbf/in. ",…

A:

Q: pring 2020) In a vibratory system below with the mass unbalance of 0.2 kg, if 1 and m10 kg with the…

A: Ans- Option (a) is correct. 20 cm

Q: Q2 The bracket BCD is hinged atc and attach and to eable at B determing Theload inting (e - 240~…

A:

Q: Design a Knuckle joint to transmit 173 kN, Allowable stresses in tension, shear and compression are…

A:

Basic Terminology in Mechanics

The area of science and mathematics concerned the motion of the objects, the relation between the force matter, and motion if specified. Forces exerted over the objects result in displacements or changes in the position of an object concerning its environment. This branch of physics keeps its roots in Ancient Greece in the form of the scripts of Aristotle and Archimedes.