A series of six solutions was prepared at the given concentrations.SampleAB CDEFConcentration (mM)50 100 | 150 | 200 300 400The absorbance of each solution was then measured using a colorimeter.SampleABCDEFAbsorbance0.250.500.751.001.502.00What is the concentration of the solution with an absorbance of 1.50?C =mM What is the absorbance of a 50 mM solution?A =As the concentration of the solution increases, the absorbance of the solutionstays the same.increases.decreases.

According to Beer Lambert law , the absorbance of the solution is directly proportional to the…

Answered: What is the absorbance of a 50 mM…

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter8: Sampling, Standardization, And Calibration

Section: Chapter Questions

Problem 8.1QAP

See similar textbooks

Similar questions

A colored solution of concentration 0.0344 mol/L has an absorbance of 0.481. What is the concentration a solution of the same solute with an absorbance of 0.651? Assume that the same sample celf is used for both readings. Report your answer to 3 significant figures.
this type of analysis refers to the determination of the identity of the analyte in the sample
The Kjeldahl method was used to determine the nitrogen content of a protein. A 275 µL aliquot of a 47.0 mg/mL protein solution was digested in boiling sulfuric acid. The solution was made basic and the liberated NH, was collected in 5.00 mL of 0.0512 M HCl. A volume of 7.00 mL of 0.0174 M NaOH was required to react with the excess HCl. Calculate the weight percent of nitrogen in the protein. weight percent: wt% N
You were assigned to assay a product sample of milk of magnesia. A 0.600-g sample was reacted with 25.00 mL 0.10590 N H2SO4 . The excess unreacted acid in the solution required 13.00 mL of 0.09500 N NaOH when titrated to reach the methyl red end point. Determine the dosage strength of the product in terms of % Mg(OH)2 content. Type your answer in 2 decimal places, numbers only.
d) please see attached question concentration KOH=20.8325mL pH solution=2.9 beginning of the titration, Vbase = 0.00 mL
A water sample was analyzed for Fe content using the iron- phenanthroline method. The following data were obtained from the analysis: Reagent Blank Absorbance Absorbance (au) Reagent Blank Absorbance 0.003 Concentration of Stock Solution: 10 ppm Volume of Stock Solution (mL) Total Volume of Standard Solution Concentration of Standard Solution (ppm) Absorbance (au) (mL) 0.50 10.00 0.012 1.00 10.00 0.132 2.00 10.00 0.267 3.00 10.00 0.349 4.00 10.00 0.428 5.00 10.00 0.560 Volume of Unknown Solution Total Volume of Unknown Solution Trial Absorbance (au) (mL) (mL) 1 5.00 10.00 0.289 2 5.00 10.00 0.296 3 5.00 10.00 0.281 Determine the value of the slope (m), y-intercept (b), and the coefficient of determination (r²) A m = 0.1128; b = -4.0 x 10-5; r2 = 0.9880 B m = 0.1128; b = -4.0 x 10-5; r² = 0.9762 C) m = 0.1128; b = -3.0 x 10-³; r² = 0.9880 D m = 0.1128; b = -3.0 x 10-³; r² = 0.9762
Determinati an 25 ml by dissolving 110n (111) per 1 This (as ml 750ml experiment Solution The to of was The a and process Q on added The portion layer taken 1 volumetric diluted Litre Colution Two These of in diluted ml soo 1% ETA of Question A. reaction an Solution 0₁ 446 9 of A. R. hydrated sulphate, (NH4) Fe (504) ₂ · 12H₂0 2 of distilled then of wertel) 0,0446 g/L of lion Absorbance was 250 ml in to ·layers frask was Is 2. 3. Was Chlore form and were 5 ml, 10 ml, 15 ml por tions 4. Iron • iron (111) four oxine it mixture the done. (111) seperatory conducted Volume SMT as 10 ml 15 ml 20 ml Plo + absorbance formed readings a (A.R) Jayer measured the por tions Solution was Water diluted out 20 ml were then Each of these mark against funnel as was after with for 8- ity droxy quinolate. follows. to iron (111) solution was prepared of then Calibration was ) 10 obtain collected. ammonium F. W-481,979 then these Absorbance 0,076 0,169 9185 0₁234. Shook. the shaking added portions…
The table below describes a procedure in preparing standard solutions of a protein sample with different concentrations. (A) Determine the concentrations of each tube if the starting concentration of the protein is 500 mg mL (B) Determine the equation of the line if the concentration (x-axis) was plotted vs the absorbance (y-axis). (C) What is the concentration, in mg mL, of the diluted unknown protein sample if the absorbance at 595 nm is 0.333? L-1. Tube Volume of protein, Volume of water, Final concentration, Absorbance #3 mL mL (at 595 nm) mg mL-1 0.00 5.00 0.113 12 0.70 4.30 0.184 3 1.40 3.60 0.251 14 2.10 2.90 0.329 15 2.80 2.20 0.385 3.50 1.50 0.454 17 4.20 0.80 0.503 8 5.00 0.00 0.577 Suppose that the unknown protein (diluted) sample in 4.C was diluted from a protein stock solution. Determine the concentration of the original unknown protein stock solution if 2.00 mL of the protein solution was mixed with 8.00 mL of water to create the unknown protein (diluted) sample in 4.C.
It is a solution of unknown concentration in which a solution of accurately known concentration is gradually added until the reaction is complete. Analyte Endpoint Indicator Titrant
Treatment of ammonia with phenol in the presence of hypochlorite yields indophenol, a blue product that absrobs light at 625 nm, which çan be used for the spectrophotometric determination of ammonia. gan OCF OH + NH3 indophenol anion To determinè the ammonia concentration in a sample of lake water, three samples are prepared. In sample A, 10.0 mL of lake water is mixed with 5 mL of phenol solution and 2 mL of sodium hypochlorite solution, and diluted to 25.0 mL in a volumetric flask. In sample B, 10.0 mL of lake water is mixed with 5 mL of phenol solution, 2 mL of sodium hypochlorite solution, and 2.50 mL of a 5.50 x 10-4 M ammonia solution, and diluted to 25.0 mL. Sample C is a reagent blank. It contains 10.0 mL of distilled water, 5 mL of phenol solution, and 2 mL of sodium hypochlorite solution, diluted to 25.0 mL. The absorbance of the three samples is then measured at 625 nm in a 1.00 cm cuvette. The results are shown in the table. Sample Absorbance (625 nm) A 0.361 B 0.608 C…
An unknown sample of Cu2+gave an absorbance of 0.262. Then 1.00 mL of solution containing 100 ppm (ug/mL)Cu2+was mixed with 95.0 mL of the unknown and the mixture was diluted to 100 mL in a volumetric flask with deionized water. The absorbanceof the new solution was 0.500. a.Denoting the initial unknown concentrationas [Cu2+]i,write an expression for the final concentrationafter dilution [Cu2+] b.Find [Cu2+]in the unknown.
C70 lll ll ... اجابة قصيرة A solution of Al2 (S04) 3 at a concentration of 0.3 N , What is the volume needed to prepare a solution at a concentratio 0.04 M in a volume of 150 ml of distilled water إجابتك كتب إجابتك.

SEE MORE QUESTIONS

Recommended textbooks for you

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

SEE MORE TEXTBOOKS

What is the absorbance of a 50 mM solution? A = As the concentration of the solution increases, the absorbance of the solution stays the same. increases. decreases.