Answered: What do you understand by Isocratic and…

Science

Chemistry

What do you understand by Isocratic and Gradient elution?

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter7: Equilibria In Multiple-component Systems

Section: Chapter Questions

Problem 7.81E

See similar textbooks

Related questions

Q: sely proportional to the column efficiency irectly proportional to the selectivity factor not…

A: B option is correct. Inversely proportional to column efficiency. Band-broadening is a general term…

Q: Data Report Sheet: Spectrophotometric Determination of an Equilibrium Constant. Part A:…

A: Determination of K

Q: A solution of potassium permanganate of unknown concentration was analyzed against a standard of…

A: To calculate the value of unknown concentration, we must generate a calibration curve in which known…

Q: Why is gradient elution used

A: In this elution process, mobile phase strength is changed during the separation process.

Q: Data for the Concentration of the KMnO4 Unknown Solution. Abs of Unknown Solution is 0.362…

Q: Report the y-Intercept of the best-fit line for the Calibration Curve Report the R2 value of the…

A: The best fit-line given is as shown below,

Q: For the thermoeter correction

A: Correction factor for thermometer is basically calculated by subtracting the value observed from its…

Q: Dye 1 Dye 2 Run 1 Run 2 Run 3 Run 1 Run 2 Run 3 Start of Band (mL} 1.1 1.1 1.2 2.2 2.2 2.3 End of…

A: Retention Volume : It is the volume of the mobile phase which is required to elute out a particular…

Q: I Data Report Sheet: Spectrophotemetric Determination of an Equilibrium Constant, Part A:…

A: Equation of the calibration curve is y = 4339.8x + 0.0258 where y = Absorbance x = [FeSCN2+]…

Q: 4. The best answer to report for 352.94 - 36.0342 is. (can you explain where the decimal for…

A: We have to substract the given digits- ( 362.94 -36.0342 ) and signifaicant figures of the answer is…

Q: Please draw a calibration curve from these numbers and get the epselon(molar absorptivity) and…

A: The concentration v/s absorbance data given is,

Q: Time (min) Which separation is better? What can cause this behaviour (if all other conditions are…

A: To explain which separation is better.

Q: The interaction between a basic analyte and the residual silanol groups of the stationary phase is…

A: When pH of mobile phase is equal to pKa of silanol then its proton will get deprotonated and basic…

Q: What type of plot is shown below? 12 000 10 00- 8000 B000 4.000 - 2000 O 00 00 10.0 200 30.0 400 a.…

Q: The following information have been obtained from a chromato of GC with standard concentration of…

A: Given standard concentration of component 1 and component 2 = 50 ppb Since peak width and heights…

Q: Find the weighted adjacency matrix of the following direted graph and represent that as a CSR-marix.

A: Weighted Adjacency Matrix: It is 2-D array which represents a data structure which can say that…

Q: List the advantages and any disadvantages of SFE compared to liquid-liquid extractions.

A: Advantages of SFE(super critical fluid extraction) over liquid-liquid extraction Speedy process…

Q: How would i perform a serial dilution of 1/2 and 1/4 if i have 7.5mL of an unknown protein, the…

A: The molarity of a solution is the number of moles of solute in the solvent. Molarity varies with the…

Q: Standard Tubes Volume of 0.1 Hydroxamate standard Tubes Optical Density (OD) Concentration 0.061…

A: Interpretation: To write the conclusion of the result given.

Q: What is the difference between isocratic and gradient elution?

Q: Q) Calculate the “Chlorine Demand of Water”, if “addition of (i.e. Chlorine added)” 200 kg/d of…

Q: the following data were the results from six replicate determinations of iron in aqueous samples of…

Q: Why does the efficiency (decreased plate height) of liquid chromatography increase as the stationary…

A: to improve resolution in HPLC by Increasing column length. by Decreasing particle size. by…

Q: If 250 mL of a 1:800 (v/v) solution were diluted to 1000 mL, what should be the ratio strength? The…

Q: 100.0 cm3 of a 1.234 mol.dm-3 solution of nickel(II) nitrate was added to 150.0 cm3 of a 1.178…

A: Nickel Nitrate:- Ni(NO3)2 Sodium Carbonate:- Na2CO3 1cm3 = 1ml 1dm3 = 1L Limiting reagent:- It is…

Q: At what stage was the internal standard added to the prepartions, in the protocol of this…

A: Step : 1 The required answer for the above question is follows as :

Q: Paraxylene, styrene, toluene, and benzene are to be separated with the array of distillation columns…

A: Accordingto the given Diagram, where F, D, B, D1, B1, D2 and B2 are the molar flow rates in…

Q: Comment on the procedural differences of the gravimetric and volumetric analysis

Q: ION EXTRACELLULAR FLUID (mM) IN TRACELLULAR FLUID (mM) Eion AT 37 C K* 5 mM (normal range: 3.5-5)…

A: Given, Ion Extra cellular Fluid (mM) Intra cellular Fluid (mM)…

Q: Molar absorptivity is a constant dependent on the following except: a. wavelength. b. solvent. c.…

Q: Describe the components of a filter fluorometer and a spectrofluorometer. Why are fluorometers…

Q: explain importance of Gravimetric Analysis when it comes to operation/s of each procedure/method?…

A: Gravimetric analysis is a process or method to determine the quantity of analyte on the basis of…

Q: Is it possible for a single molecule to test true positive in all the qualitative assays? Why or why…

A: A question based on qualitative analysis, which is to be accomplished.

Q: For SFE, differentiate between (a) on-line and off-line processes. (b) static and dynamic…

A: SFE is denoted for supercritical fluid extraction and is a type of an analytical technique, in which…

Q: what can be an analyte for using internal standard? sample: vegetable oil containing ethyl oleate,…

A: In the analytical techniques, such as gas chromatography or HPLC, standardization of the sample…

Q: Let the retention factor of species A be 0.2 while the retention factor of species B be 0.4. If…

A: The factor reflecting the dissolving/soluble capacity of any pigment in known solvent is designated…

Q: hi, expert please help me with this problem.. i need it before 5 pm thank you As part of a lab…

A: When a solute at constant temperature is added to 2 immisicible solvent in contact with each other.…

Q: Compare gradient and isocratic mode in HPLC.

A: Gradient and isocratic mode in HPLC are the two different modes of operating condition in HPLC.

Q: Predict the order of elution of the following substances on a reverse phase column, starting from…

A: The order of elution can be determined on the basis of polarity of the substance. Lesser is the…

Q: Why internal standard solutions are better and why we get a more uncertain result with other…

A: Internal standard: It is the chemical substance that is used in the analysis of compounds and this…

Q: During Buchner filtrati on a portion of the filtrate isused for swirling the resi due into the…

A: SOLUTION: Step 1: A Buchner funnel is a piece of laboratory equipment used in filtration. It is a…

Q: How do electrogravimetric and coulometric methods differ from potentiometric methods? Consider…

A: The potentiometric method of analysis is simply based on measuring the potential (or voltage) of the…

Q: A water sample was analyzed for Fe content using the iron-phenanthroline method. The following data…

A: Volume of Stock Solution (mL) Total Volume of Standard Solution (mL) Concentration of Standard…

Q: In the context of chromatographic separation, discuss Eddy diffusion, longitudinal diffusion, and…

Q: A silver-30%gold alloy sample (cylindrical with 1 cm diameter and 0.3 cm height) is subjected to a…

A: The time can be calculated by Faraday's law, m = EitFm: mass of silveri: current (Ampere)F:…

Q: -forming density gradients in respect of the following: I. Type of gradient material used. II. The…

A: Rate-zonal separation and isopycnic separation will be the two primary forms of density gradient…

Question

What do you understand by Isocratic and Gradient elution?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

van hoff factor for trial 1 is 1.79 and trial 2 is 1.99
Compute for the numerical value of the gravimetric factor required to convert the given precipitate into the desired analyte. 1. Magnesium ammonium phosphate (MgNH4PO4) precipitate into phosphorous (as diphosphorous pentoxide, P2O5). 2. Magnesium ammonium phosphate hexahydrate (MgNH4PO4.6H2O) precipitate into nitrogen.
tion 2 3 5 8 9 10 11 12 13 14 15 16 17 18 19 20 The end point and the equivalence point are always equal. O True O False 事 4.
StatisticalAnalysis of Data. Provide what isasked. a.Mean values of ppm Ca and ppm Mg .b.Median values of ppm Ca and ppm Mg. c.Std. dev. of ppm Ca and ppm Mg.
Note: Derive the expression relating the two kinetic constants first before plugging the values. please do not use excel. show all the necessary step/solutions. please answer all.
In the standardization of HCl against pure anhydrous Na2CO3, 1mL was found to be equivalent to 0.05g of the primary standard. Compute for the normality.
4. A new method for the determination of mercury in fish was tested against a N.I.S.T. standard to determine if there was any bias (determinate error) in the new technique. The N.I.S.T. standard fish sample was certified to contain 13.55 ppm Hg. The results of six analyses by the new method gave a mean value of 14.15 ppm and s.d. = 0.42 ppm. Does the new method give accurate results at the 95% confidence level?
In the below problem I converted 50g of HCl to 1.37mol. But I'm not sure what do with that bumber and the q_system value of 670 that I got.
the linear trendline equation y= 4.7033x + 0.0045
Why is it important that the pressure is very low in EI-MS but much higher in CI-MS?
120=233k×5 Find the value of k.
Extintion coeficient for Y is 1280