Answered: Water flows at a rate of 800 cm3/min in…

Water flows at a rate of 800 cm3/min in a pipe of varying cross-sectional areas. Calculate the velocity of the water at the section where: (a) the radius is 3.0 cm; and (b) the radius is 5.0 cm

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 75P: What is the average flow rate in cm3/s of gasoline to the engine of a car traveling at 100 km/h if...

See similar textbooks

Related questions

Q: Water is flowing in a pipe of varying cross-sectional area, and at all points the water completely…

A: Given: The cross-section area of section 1 is 0.0831 m2. The speed of the water flow at section 1 is…

Q: Water flows through a horizontal pipe of varying cross-section at the rate of 10m3/min. Determine…

A: Equation of continuity says that,

Q: A large storage tank, open to the atmosphere at the top and filled with water, develops a small hole…

A: Following values are given in this question: The hole is having depth = 16 m Now, Using the…

Q: When is the flow considered Laminar? A B D Re = 4000 Re = 2000 Re 4000

A: Let's check each option one by one 1. Re = 4000 Incorrect option If Re = 4000 then the flow is…

Q: Water is being poured at the rate of 27 m' /min into an inverted conical tank that is 12-meter deep…

Q: An oil gusher shoots crude oil 25.0 m into the air through a pipe with a 0.100-m diameter.…

A: Given: Pipe diameter = 0.100 m Length of the pipe = 50 m

Q: The L-shaped fish tank is filled with water and is open at the top. If d = 5.0 m, what is the…

A: Given , d = 5.0 m Area of face A is given by Area1 = d2…

Q: A thin stream of water flows smoothly from a faucet and falls straight down. At one point, the water…

A: Given:density of the water, ρ = 1000 kg/m3at location 1velocity of the water, v1 = 1.07 m/sat…

Q: A horizontal pipe narrows from a radius of 0.220 m to 0.110 m. If the speed of the water is 1.50 m/s…

A: Given data: Radius of Larger pipe (r1) = 0.220 m Radius of smaller pipe (r2) = 0.110 m Speed of…

Q: A large storage tank, open to the atmosphere at the top and filled with water, develops a small hole…

A: Depth below the water level, h = 13.4 mFlow rate, Q = 2.9×10-3 m3/minAcceleration due to gravity, g…

Q: An ideal incompressible fluid flows at 12m/s in a horizontal pipe. If pipe widens to twice its…

Q: Length and dia. Of pipe 1 are 2000m and 1m while the second pipe is 2000m and dia. Of 0.8m .Find the…

A: This equation mainly used when there are pipe related problems. Pipe of finite length and diameter…

Q: A horizontal pipe narrows from a radius of 0.300 m to 0.150 m. If the speed of the water is 2.00 m/s…

A: Radius, R = 0.3 m radius, r = 0.15 m Velocity, V = 2m/s

Q: Calculate the Reynolds numbers for the flow of water through (a) a nozzle with a radius of 0.250 cm…

A: a) It is given that,

Q: In regions far from the entrance, fluid flow througha circular pipe is one dimensional, and the…

Q: Water is flowing in a pipe of varying cross-sectional area, and at all points the water completely…

Q: What should be the flow rate (L/s) exiting a gardening hose ejecting water inclined 30 degrees from…

A: As the Water hose is inclined 30 deg with the y axis. Let the required flow rate be Q L/s. The…

Q: Verify that the flow of oil is laminar for an oil gusher that shoots crude oil 25.0 m into the air…

A: To determine: To verify the flow of oil is laminar for an oil gusher that shoots the crude oil into…

Q: The pipe flow in Fig. P3.12 fills a cylindrical surge tank as shown. At time t = 0, the water depth…

Q: A vertical dam has a semicircular gate as shown in the figure. The total depth d of the figure is 36…

Q: Water , flows at 12 m/s in a horizontal pipe with a pressure of 2.0×10^5pa .if the pipe widens to…

Q: Water is flowing at 8 m/s in a circular pipe. If the diameter of the pipe decreases to 1/2 its…

A: When an incompressible and ideal fluid flows through a pipe of constant area of cross-section, the…

Q: A horizontal pipe widens from a radius of 0.150 m to 0.280 m. If the speed of the water is 1.40 m/s…

Q: A horizontal water pipe has varying diameters. At a certain point, the waters speed is 3.00m/s and…

A: Write the given values with the suitable variables. v1=3 m/sP1=2×104 N/m2A2=A12 Here, v1, P1, A2,…

Q: If the velocity profile of a fluid over a plate is parabolic with the vertex 20 cm from the plate,…

A: Given; Distance of vertex from plate= 20 [cm] Velocity at vertex= u= 120 [cm/s] Viscosity= μ= 8.5…

Q: Water flows out through a pipe with a cross sectional area of 1.6 m2 without friction at a rate of…

A: Formula of volume flow rate is as follows; Q=Av…

Q: Liquid flows through a pipe of diameter 3.00 cm at 1.50m/s. a)Find the volume flow rate. b)There…

Q: A flat vertical metal gate in the face of a dam is shaped like the parabolic region between the…

A: Find the depth of the metal gate. y=4x24=4x2x=1 ft The area of the gate is, A=1 ft5 ft=5 ft2

Q: A horizontal pipe widens from a radius of 0.110 m to 0.240 m. If the speed of the water is 1.30 m/s…

A: Write the equation of continuity of fluids.

Q: A horizontal pipe narrows from a radius of 0.250 m to 0.100 m. If the speed of the water in the…

A: Given: Radius r1=0.250 m Radius r2=0.100 m Speed V1=1.00 m/s

Q: The velocity profile in fully developed laminar flow in a circular pipe of inner radius R = 2 cm, in…

Q: Someone claims that the volume flow rate in a circular pipe with laminar flow can be determined by…

Q: Water flows through a horizontal tube 3.00 cm in diameter with a speed of 60.0 cm/s. If the pipe…

Q: A horizontal pipe widens from a radius of 0.140 m to 0.300 m. If the speed of the water is 2.00 m/s…

Q: The top part of a water tank is divided into two com- Now a fluid with an partments, unknown density…

A: Recall P=hρg Pressure at same horizontal level are equal. So P1=P2

Q: At one point in a pipeline, the water’s speed is 3.00m/s and the gauge pressure is 5.00x104 Pa. Find…

Q: What is the specific gravity of the liquid in the left leg of the U-tube manometer as shown in the…

A: We are going use the pressure difference formula to solve the problem. As, you can see the heights…

Q: hat is the flow rate of water that moves at an average speed of 2.8 m/s through a uniform pipe with…

A: Volume flow rate is Q=Av=πd24v

Q: years, In Bou speeds of 45 100 mi/h) when the jet stream descends during early spring. Approximately…

A: Solution:→Case 1 Bernouli's equation is given as: P1 + 12ρv12 = P2 + 12ρv22 where,…

Q: A horizontal pipe narrows from a radius of 0.280 m to 0.140 m. If the speed of the water is 1.70 m/s…

A: Equation of continuity will be used, which is given as follows: A1v1=A2v2 Here A1, A2 are the area…

Q: If a fluid flows in a pipe and speeds up when it moves into a region of smaller crosssectional area,…

A: Continuity equation : This equation helps to demonstrate that flow rate into certain area should be…

Question

Water flows at a rate of 800 cm3/min in a pipe of varying cross-sectional
areas. Calculate the velocity of the water at the section where:
(a) the radius is 3.0 cm; and
(b) the radius is 5.0 cm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Water emerges straight down from a faucet with a 1.80-cm diameter at a speed of 0.500 m/s. (Because of the construction of the faucet, there is no variation in speed across the stream.) (a) What is flow rate in cm3/s? (b) What is the diameter of the stream 0.200 m below the faucet? Neglect any effects due to surface tension.
What is density of a woman floats in fresh water with 4.00% of her volume above the surface? (This could be measured by placing her in a Wii marks on the side to measure how much water she displaces when floating and when held under water.) (b) What percent of her volume is above surface when she floats in seawater?
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
Logs sometimes float vertically a lake because one end has become water-logged and denser than the other. What is the average density of a uniform-diameter log that floats with 20.0% of its length above water?
Calculate Reynolds numbers for flow of trough (a) a nozzle a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when be nozzle is attached to hose. The flow rate through hose and nozzle is 0.500 L/s. Can flow in either possibly be laminar?
An oil gusher shoots crude 25.0 m the through a pipe with a 0.100-m diameter. Neglecting resistance but not resistance of the pipe, and assuming laminar flow, calculate pressure at be entrance of be 50.0-m-Iong vertical pipe. Take of the oil to be 900 kg/m3 and its viscosity to be 100(N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to 50.0-m column of oil in pipe.
Water is moving at a velocity of 2.00 m/s through a hose with internal diameter of 1.60 cm. (a) What is the flow rate in liters per second? (b) The fluid velocity in this hose's nozzle is 15.0 m/s. What is the nozzle's inside diameter?
Suppose you have a wind speed gauge like the pitot tube shown in Figure 14.32. By what factor must wad speed increase to double the value of h in the manometer? Is independent of be moving fluid and be fluid the Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
Is there a limit to the height to which an entrainment device can raise a fluid? Explain your answer.
What is the pressure drop due to the Bernoulli Effect as water goes into a 3.00-cm-diameter nozzle from a 9.00-cm-diameter fire hose while carrying a flow of 40.0 L/s? (b) To what maximum above be nozzle can this water rise? (The actual height will be significantly smaller due to air resistance.)
A sump pump (used to drain water from be basement of houses built below the water table) is draining a flooded basement at rate of 0.750 L/S, with an output pressure of 3.00105N/m2 . (a) The water enters a hose with a 3.00-cm inside diameter and rises 2.50 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.500 m in height and widens to 4.00 cm in diameter. What is the pressure now? You may neglect frictional losses both parts of the problem.
(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.