v(t) = 120 sin (377t + 60°) V i(t) 50 μF 2002 40 mH

Q: Question 1 v(1) R-2502 L = 20 mH C-50 µF Compute for the phase angle of the phasor current i(t) if…

A: We need to find out phase angle for current .

Q: Two coaxial tubes are inserted into a tray containing an insulating liquid (oil) with a dielectric…

A: Given data: The capacitance, C=2πε∘lnba F/m The given diagram is shown below,

Q: 1. In the circuit shown, determine (a) load current; (b) the load voltage and power; (c) current…

A: In this question,  We need to determine the load current, load voltage, power delivered by sources…

Q: What is the closest phase of the capacitor voltage relative to the current used in your circuit at…

A:

Q: The circuit shown below is in a fixed bias common emitter configuration. This does not have any…

A:

Q: 3. Consider the circuit shown to determine the values of the resistances. 3A (1 RA + 4 V - + 12 V. 2…

A: here we have to find the resistances RA , RB , RC values.

Q: Briefly explain TNC-S earthing scheme as applied to earthing system design. (Hint: Support your…

A: Earthing is the process of connecting a power supply system's neutral location to the earth. The…

Q: A 489V shunt motor delivers 30hp at the shaft at 1120rpm. If the motor has an efficiency of 86% at…

A:

Q: Find the transfer function, G(s) = Vo(s)/Vi(s) of the operational amplifier below. v(t) 4μF 600 ΚΩ…

A: We  need to find out the transfer function for given amplifier circuit.

Q: Explain the environmental hazard of Nuclear power generation with neat diagram

A: Nuclear power plants use uranium as fuel. During the process of mining uranium released high amounts…

Q: Determine the node voltages Va, Vb, Vc and Vd of the circuit from Figure 2 using Nodal Analysis.

A: Given, Method required: KCL analysis

Q: Find the transfer function, 02(s)/T(s) for the given rotational mechanical system. (Non-anonymous…

A:

Q: 4. Find the IDFT of X[k] = [2, 4 + 4j, 14, 4 - 4j].

A:

Q: 4.5 A 12 Ω io 1.8 Ω 20 Α 14 Ω 50 V • 10 Ω 15 Ω

A: To find Io by using super position theorem

Q: 2. For a causal LTI system described by the following input-output relation. y(n) = 2ay(n − 1) −…

A:

Q: 121≤20 otherwise -jkn An ideal lowpass filter has the following frequency response H(j) = {67) the…

A:

Q: Q5. Design a Voltage-divider D-MOSFET circuit that produces a voltage gain of - 6. The following…

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: 1. Find the value, that is, the current across the 30 resistor. 302 ww 24V 662 2A 662

A: We need to find out the current through 3 ohms for given circuit .

Q: USING D1 1N4001G or SILICON DIODE. To sketch the characteristic curve of the diode you need to vary…

A: In electronics, "biasing" often refers to the application of a constant DC voltage or current to a…

Q: - Determine mesh currents i1 and i2.

A: Mesh analysis is the application of KVL. Mesh analysis is defined as a method in which the current…

Q: Briefly explain three (3) objectives of testing and commissioning a designed work.

A: It is asked to explain three (3) objectives of testing and commissioning a designed work in brief.

Q: 2. Determine Ix using superposition theorem.

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: Minimize the following boolean function- F(A, B, C, D) = Σm(1, 3, 4, 6, 8, 9, 11, 13, 15) + Σd(0, 2,…

A: We need to find out simplified Boolean expression for given function .

Q: In the circuit below, R₂ = 300 kk = 1 mA/V², Vt = -1 V, VDD = 5 V, find R₁ such that ID = 2 mA. R₂…

A: We need to find out value of unknown resistor for given circuit.

Q: QUESTION 7 Output PL2 will be energized: Inputs oto PB1 oo PB2 PB1 3E C5:1/DN VE C5.1/DN BE PB2 36 E…

A: 7.Given,  We need to explain the condition when the output PL2 will be energized.

Q: A single room is supplied with a device which has 100volt circuit with a resistance of 25 ohms,…

A: Given data:-Supply voltage=V=100vResistance=25ΩFind:- Currnet=I=?

Q: For the following function, find all of the prime implicants using the Quine-McCluskey method.…

A:

Q: 2. A 50 HP, 440 volt single-phase motor is 92% efficient and operates at 88.2% power factor,…

A:

Q: Find the steady-state error for input of 5u(t) to the system below. The function u(t) is the unit…

A:

Q: The input of a full-wave rectifier is 60 Hz AC voltage. If the voltage drop across diodes is 0 V,…

A: The rectifier is a circuit that converts alternating current into direct current. The average…

Q: Suppose you want to install a hot tub in your back yard, about 20 meters from the electrical…

A: Given, The voltage required by the hot tub, V=250 V The current requirement for a hot tub,i=50 A

Q: 12. Use mesh analysis to find Vob and io. 80 € (+ V 80 V – Α 20 Ω Μ 20 Ω 20 Ω Μ Μ 30 Ω. Μ 30 Ω 30 Ω…

A:

Q: find the Fourier expansion of the periodic function shown below f(x) = sinx -π<x<π using fr 2396…

A:

Q: V₁ R6 ww V3 R7 V₂ R8 www R9

A:

Q: The armature of a d.c. The machine has a resistance of 0.25 ohm and is connected to a 300V supply.…

A: Given data: The resistance, R=0.25 A The voltage, V=300 V The generated current, I=100 A The motor…

Q: 2, Calculate Vx using transformation. 20L-90°v ՏՂ M Source 40 j130 NIE 32 J4n + 100 & Ux

A:

Q: 1. Determine v using superposition theorem.

A: It is given that:

Q: - Vcc = 6 V - The voltage VB is set such that the circuit has a DC output voltage of 3V - parameters…

A:

Q: To find current in a resistance connected in a network, Thevenin's theorem is used Vth =20V and Rth…

A:

Q: A 400 V of 50 Hz is supplying a three-phase load of 150kW that is located 150 m away from the…

A:

Q: 1₁ a. Find the value of V. Answer: Answer: b. Find the current (down) through R₁. Answer: c. Find…

A:

Q: Optical Fibre communication link: Discuss the results in regards to power transmitted (dBM) Vs The…

A: According to the question, for the graph shown below We need to discuss the results in regards to…

Q: Given the characteristic equation of a unitary feedback system by: S(S+40)(S+50)(S² + 205 +200) +…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: If Vs=147V, R1=49kΩ, R2=60kΩ, R3=24kΩ, L=181mH, determine the inductor current, iL (in mA) at…

A: Given, supply voltage, Vs=147 V Values of resistors, R1=49 KΩR2=60 KΩR3=24 KΩ The value of the…

Q: 3. Making use Babinet's principle, calculate the impedance of a slot antenna with respect to a…

A:

Q: 1. As the potential across the resistor increased, the current through the resistor increased. If…

A: Given data: given that the potential across the register increased , the current through the…

Q: 5. Determine the Thevenin's and Norton's equivalent circuits across a-b.

A: The thevenin's equivalent circuit can be obtained by finding the open circuit voltage and equivalent…

Q: Determine all possible signals that have the following Z-transform: X(z) = 1 1-2- Hint: X(z) has…

A:

Q: Suppose you are planning to go on a country-side tour riding your bike. In an unfortunate situation,…

A: This application requires the following modules to implement   (i) The step down transformer that…

Q: Given the DELTA-connected resistors, inductors, and capacitors. Convert into to equivalent…

A: Convert the given circuit in Delta connection to Star connection. :

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.