Two impedances are fed by a source with V = 100Vrms 160 °, as shown below. The total current is I = 2Arms 190 ° ,and the first load consumes P1 = 23.2W and Q1 = 50 var. Calculate a) currents I1 and I2 b) the power factor of each impedance c) the total power factor of the circuit

Q: A balanced positive-sequence wye-connected 60-Hz three-phase source has line-to-line voltages of VL…

A: for  Y connected system , Line voltage = 3 ×phase voltage. and Line current = phase current . Given…

Q: For the circuit in Figure: Determine I, VR, and Vc in phasor form. Calculate the total power factor,…

A:

Q: The total power drawn by the two-impedance load in parallel is 27kW at 0.90 power factor lagging,…

A:

Q: Two impedances Z₁ and Z2 are connected in series to a voltage source with voltage Vs volts. Let V₁…

A: Given that two impedances are connected in series to a voltage source Vs. V1 is the voltage across…

Q: (c) A single-phase power system is shown in Figure Q3(c). The power source feeds a 100KVA, 14/2.4 kV…

A:

Q: A substation rated 1250 kVA is operating at full-load at 0.8 pf lagging and to carry an addition…

A: A substation is a place included in the electrical power generation system where electrical voltage…

Q: A resistor of 10ohm and an inductor of 0.2 henry are connected in series and given a supply of 230…

A: Solution:- Resistor R=10, henry L=0.2 H, connected in series.  supply voltage V=230 V, Frequency…

Q: Q1. The circuit of Figure 1 has a source of 240V and source, line and load impedances according to…

A:

Q: (d) Figure Q1(d) shows an AC circuit. Given Vị = 24 - 15° V (i) Determine the value of impedance Zr.…

A: The solution is given below

Q: load resistor operating at an average power of 5W. Finalize answers as: RL(standard)= Isavertgmin=_…

A: The given circuit is full wave rectifier. In positive half cycle diodes D1 and D2 will conduct.  In…

Q: The following information is given in connection with a load circuit consisting of two parallel…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: As shown in Figure Q1(b), two loads A and B are connected in parallel across a 1.5 kV r 60-Hz line.…

A: The solution can be achieved as follows.

Q: . Two impedance Z1= 12+j 16 ohms and Z2= 4- j4 ohms are connected in parallel across 240 volts , 60…

A:

Q: In the circuit given in Figure 2, voad(t) = /2-80 cos(4f)V a) Express each circuit element in phasor…

A:

Q: Assume that the voltage applied to a load is V = 2082 – 30° V and the current flowing through the…

A: Complex power  S = VI°  | S| = Complex power . S  SI unit VA  COS(theta) = pf.  V = 208< -30° V…

Q: For the circuit shown, find the following Calculate the requirements in the same order and put your…

A: In the circuit,  Inductance capacitance and resistance are consist.  Find the current I1 , I2  and…

Q: 2. A series AC circuit consisting of R = 750 N and C = 3 µF are connected across a voltage source V…

A:

Q: Q.19: For the circuit shown: 1. Find the phasor currents i, & i2? 2. Compute the total power. (Ans.:…

A:

Q: v1 (V) VL (V)|11(A) | 12(A) IL (A) PI(W) | P2 (W) | Iin(A 429a.512 a577 bo 58 59.87 67 So o767 tit5…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Three impedances Z1, Z2 and ZL are connected in tee. The impedance Z1 is connected in series with…

A:

Q: Suppose that a current source with Is amperes of current is connected in parallel to a pair of…

A: This is a basic problem of circuit.  The solution is given in the next step.

Q: 4.3. Consider 3 ac loads connected across a 240V ac source where: L1 absorbs 10kW at 0.8pf laggin L2…

A:

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: Since you have asked only for (ii) so I have posted solution only for (ii) . This question belongs…

Q: Q4: For the circuit shown in figure below, find the value of impedance Z that will receive maximum…

A:

Q: washing machine is, in effect, an RL circuit. If the machine takes 311 W and 4.5A from 115-V source…

A:

Q: In the circuit given in Figure 2, v,(t) = /2 · 50 cos(4t + 60°)V a) Find the equivalent load…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: For the network of Figure Q3(e), determine the dc voltage Vg and calculate the input impedance Z,…

A:

Q: A three-phase steel-treatment electric oven has aphase resistance of 10Ω  and is connected…

A: a) The current flowing through the resistors in wyeand delta connections. The current for the wye…

Q: In the circuit shown below, V=20<0, R1=10 ohm, R2= 5 ohm, Zc=-j5, and ZL=j3 ohm. Choose the load…

A:

Q: A balanced three-phase Y-connected power source is feeding three loads in parallel. Power source:…

A:

Q: A 25 ohm resistor connected in series with a coil of 50 ohm resistance and 150 mH inductance.

A:

Q: Two circuits, the impedances which are given by z₁ = 15+j12 and z₂ = 8 - j5 ohms are connected in…

A:

Q: Figure below shows a simple single-phase AC power system with three loads. The voltage source is V =…

A: Kirchoff's voltage law is an important method to solve big and complex circuits. According to KCL,…

Q: Rjine jXiine + + VL |L, L2 - L1: Absorbs an average power of 20kW at a leading power factor of 0.9.…

A:

Q: In general, a three-phase induction motor isdesigned for wye connection operation. However,…

A: Calculate the power for wye connection operation,

Q: Two impedances are fed by a source with V = 100 V rms /160° , as shown below. The total current is I…

A: Circuit is given as, Given data,   P1=23.2WQ1=50 Var

Q: The following information is given in connection with a load circuit consisting of two parallel…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Q2. A station supplies a load of 1000 kVA at a lagging power factor of 0.65. A synchronous motor is…

A: The solution is given below

Q: atelier -j0,3 N 0,2 0 13 11 12 Is + j6 N j8 N Es 10Ω -j 12 N ·

A: Given information: The source voltage is Es=250.7&lt;-4.16° Volts. Here atelier is the workshop. We…

Q: 1) The load shown in the Figure consists of a resistance R in parallel with a capacitor of reactance…

A:

Q: Q3 (а) Given a circuit in Figure Q3(a); Determine the load impedance, Zı that results in maximum…

A: Maximum power transfer to ZL when Load impedance is equal to complex conjugate of thevinin…

Q: Q1:- Two circuits, the impedances of which are given by Z1=10+J15 AND 22=6+j8 ohm are connected in…

A:

Q: Question 1: Based on figure below: a. Find the total impedance Z, in polar form b. Draw the…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: For the circuit shown below  1.Draw power triangle for each load  2. Find PT,QT,ST,PFT for the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Consider the following three phase balanced circuit. 21020° Vrms j0.5 2 24-j21 2 2102-120° Vrms j0.5…

A: Using delta star convertion convert star equivalant of delta connected load. Now using KVL find…

Q: A three-phase feeder supplies two loads A and B at 380 V (Figure 2). Find the impedance of load A of…

A: A three-phase feeder supplies two load A and B at 380V. Now, the impedance of the delta connected…

Q: I1, I2 and IS. 2. Total complex, active and reactive power delivered by the source. 3. The power…

A:

Q: The instantaneous voltage and current for the network in series having a voltage and current…

A:

Q: Consider the below circuit. Suppose that Vrms = 700 V and R = 30 Ω. 1- Find the power delivered by…

A: