three phase, 60 Hz transmission line has an inductance of 1.08 mH per Km per phase and a capacitance of 0.0118 µF per Km per phase. The line is 500 Km long, and for the purpose of this problem, a lossless line is assumed. the phase constant B is ÷ the line surge impedance is 2c 0 and the wavelength A is #

Q: Description Measured Computed E, Audio Generator Output voltage 10Vpp 10 Vpp E Voltage across…

A: While designing an electrical circuits,  less tolerance electrical components should be preferred…

Q: For the circuit shown in figure 1, the diodes is in complete model and the resistance of both diodes…

A: Here using the basic concepts of diodes we solve the quantities of the above circuit.

Q: Determine the value of Vx in  Figure 4 using mesh analysis

A: It is given that:

Q: Industrial Motor Controls 15.a. A discrete input can be which of the following? A. −10–+10 VDC B.…

A: To select correct answer from given options

Q: Q1Determine the centre frequency, gain, and quality factor for the filter in figure. 11 kOhm 120 nF…

A: Q1. Given circuit is shown below. Above circuit is a Twin-T notch filter

Q: Assume that the microprocessor can directly address 1M with a and 8 data pins. The maximum RAM…

A: Consider that the microprocessor can directly address 1M with a and 8 data pins. The maximum RAM…

Q: The diameter of an ACSR conductor is 1.14323 inches. The steel core has strands of diameters of…

A:

Q: - Industrial Motor Controls, 19.a. The purpose of the analog-to-digital converter is to A. convert…

A: 19.a) Analog to digital converter converts the analog signal(continuous in time) into discrete or…

Q: - 4.5 The work done by the force F = 4a − 3a, + 2a. N in giving a 1 nC charge a displace ment of…

A: Given data, Force F=4ax-3ay+2az N Charge q=1 nC Displacement dl=10ax+2ay-7az

Q: Show that the emf induced for two inductors is equivalent to

A: Given We need to derive the expressions for induced EMF due to mutual inductance. Please find the…

Q: Q3\A point charge Q 25 x106 C is located at A (4,-3,6) find 1- E at (8,2,5) 2- Eat (1,-2,7).

A: Types of coordinates system  Cartesian coordinate system  Spherical coordinate system  Cylindrical…

Q: a transmission line has an impedance of 4 12 Ohms/phase, Find the per-unit impedance of this line on…

A:

Q: 4. In a series circuit, if the IR voltage drop is measured to be the same across two resistors, what…

A: In a series circuit, if the IR voltage drop is measured to be the same across two resistors, what…

Q: Find your for the circuit in Figure 3, if Vi = 2sin(ot) Volt. Assume that all op-amps in the circuit…

A:

Q: Construct a logic circuit that will produce a logic 1 output whenever two or more of its input are…

A: Consider A,B, C are inputs of a logic circuit. Y is output of a logic circuit. The truth table is…

Q: EX2: infinite line along the z-axis with 20 nc/m. Calculate the capacitance between p=10 and p=4 for…

A:

Q: 68 k 20 k Q-point for the circuit below is IDQ = 5.4 mA VGSQ = 2.4 V -20V T'o 2.7 k12 D Vps 1.8k…

A: Q point is the bias point. It also known as the operating point of a device. In Q- point Dc voltage…

Q: (1-) Jacob graduated from Harvard university before 30 years ago, He turned back to his country…

A:

Q: The magnetic field intensity is given in square region 0.5<x< 1 y = 0,1C2CIS by H = 2 ax + x²³ ay +…

A:

Q: H.W: Consider about a washing machine equipped with fuzzy logic controller. There are two inputs…

A: Given,The weight of the cloths to be washed is,W=4.5 kgThe cloths are in level 3 of greasiness.

Q: how can draw energy band diagram? 1 & 2 & 3 & 4 Please answer in short like it definitely..

A: According to the question, we need to draw the energy band diagram for the given MOSFET a shown…

Q: Find the Transfer Function Y(s)/X(s) of the following network. H₂ H3 R(s) Y(s) Y(S) R(S) G G5 L₁ G₂…

A:

Q: = transfer function H(o) elow

A: Open Loop System (OLS)-A system having a input in the system which does not depends on the system…

Q: 21: Assume that V is a function of y and at y=2, V-5 volt and at y = 4, V = 10 volt. a) Fi cis. 30μc…

A: Electric field is also known as electric strength and electric intensity. Electric field is the…

Q: The diameter of an ACSR conductor is 1.162 inches. The steel core has 7 strands of diameter 0.1291…

A: Formula to calculate number of strands is: N=3x2-3x+1where N is number of strandsx is layer number

Q: Question (1) (a) Define homo-structure and hetero-structure devices with appropriate schematic…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A three phase 69-KV short transmission line delivers 55 MVA at 0.82 lagging power factor at 64KV.…

A:

Q: 3. At three winding transformer at no-load case, the current flows through the tertiary windings is…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power. The…

Q: Q5/What the value of Rr.Fr, are required in the circuit below. 47 kOhm 0 022 uf H 0.022 uf 47 kOhm 0…

A:

Q: A three phase transformer supplies a balanced three phase laod with constant impedance. The name…

A: Given information about a three-phase, Y-d (star-delta connected) transformer is, Sn=100 kVA. V1n=22…

Q: Given the boolean expression (X+Y). (X+Z) = X.Z+X.Y Which common functional unit (i.e. standard…

A: In the given questions, one terms is missing in right hand part. We need to find that one.

Q: 2 (4) ( Q: For the circuit shown in fig.(2), the current and voltage sources are given in a form of…

A: Problem is done using superposition theorem.considering one frequency at a time.  At first impedance…

Q: find the resistance of one lamp If three identical lamps are connected in parallel and the combined…

A:

Q: Construct the magnitude and phase plot for the following transfer functions 100(s +20) H(s) = s(s+…

A: By observing se can se that the system is single input single output. The order of the system can be…

Q: What happens to the transistor when at cut-off operation?   a. maximum current flows from emitter to…

A: In this question,  We need to choose the correct options  What happens to the transistor when at…

Q: 3

A: For the  above given question we need to calculate the value of VAB. Note: In the below solution…

Q: Solving. Using convolution, determine the response of an LTI system using the given input signal…

A:

Q: Q3] Sketch the root Locus of the unity-feedback system whose open-loop transfer function is given…

A: Given  An open loop transfer function. We need to determine the  No of poles and zeroes,locate…

Q: SECTION 13.2 Sinusoidal ac Voltage Characteristics and Definitions 1. For the periodic waveform of…

A:

Q: Calculate the specific capacitance

A: Capacitor- It is one of the passive elements which can't act like source it can only utilize…

Q: Example: A 100 hp, 250 V compounded de motor with compensating windings has an internal resistance,…

A: Given: A 100 hp, 250 V compounded dc motor with compensating windings has an internal resistance,…

Q: Identify the type of source the symbol represents v = kix O a. Dependent current source b. Dependent…

A: It is given that:

Q: Design a 3-Bit (fixed reference) comparator for 100 reference values.  b) Logic Gates  c) PROM  d)…

A: LOGIC GATES: A logic gate is a device that acts as a building block They perform basic logical…

Q: 1ΜΩ + 18 V + VGSO ΜΑΞΙ 154 IDss = 10 mA 16 Vp = -4V OV 1516 1.5 ΚΩ 100 750 Ω

A: Self-bias FET: It is a voltage-controlled device. in this device, there is no current and 0 voltage…

Q: Determine the stability of the closed loop transfer function. 10 T(s) = Using Routh-Hurwitz…

A:

Q: 7) The wound-rotor induction motors are rarely used, and it is not so common in industry…

A:

Q: a) Write down and prove DeMorgan's theorem.  b) Remove the following complements using DeMorgan's…

A: a) Write down and prove De-Morgan's theorem. b)  Remove the following complements using De-Morgan's…

Q: 5. An oil droplet is sprayed into a uniform electric field of adjustable magnitude. The 0.04 g…

A: Given data, Mass of oil drop m=0.04g Electric field=370 N/C All forces operating on a body should be…

Q: Q3. Determine the noise power spectrum of a RL circuit with resistance R and inductance L in series…

A: An RL circuit (sometimes called an RL filter or RL network) is an electrical circuit made up of the…

Q: 3. (a) Discuss about the working principles of Light Emitting Diode (LED) with necessary figures.…

A: LED refers to light emitting diode, it is mainly used as it emits light when current flows through…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.