Select the letter of the correct answer from the given problem.*Kindly provide a CLEAR and COMPLETE solution* (Answer should be typewritten)*Please answer it ASAP Question 41Theveni'ns theorem is not applicable when:1) Load is coupled with the network2) Linear3) Time invariant4) None5) Non linear6) Time varying5,61,5,61,3,5,6O 1,5

Thevenin’s theorem : It is possible to simplify any linear complex circuit, to an equivalent circuit…

Answered: Theveni'ns theorem is not applicable…

Theveni'ns theorem is not applicable when: 1) Load is coupled with the network 2) Linear 3) Time invariant 4) None 5) Non linear 6) Time varying O 5,6 O 1,5,6 O 1,3,5,6 O 1,5

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.35P

See similar textbooks

Related questions

Q: Q3/ Answer the followings For the oscilloscope trace of a sine wave. Each horizontal division…

A: We need to find out the frequency, peak to peak voltage and RMS value for given waveform

Q: transmission media

Q: Discuss the difference between resonant and non-resoinant circuits. Use equations to explain your…

A: It is asked to discuss the difference between resonant and non-resonant circuits. We need to explain…

Q: 1. Calculate the current in all branches and the voltages at all nodes for the following circuit 10…

A: Given: Op-amp circuit:

Q: 19. The value of absolute permeability is: a. 1.2566 x 10-6 H cm b. 1.2566 x 10-4- cm C. 1.2566 x…

A: 19) The absolute permeability of the free space is given by u.

Q: 37. Calculate the reluctance of a material with length 2π x 10-4 in air with an area of 0.5 m. a. 1…

Q: calculate (vo,VS) R12 Ma Rs VS. A lkn 10uF Yo=& Figure (3) B-160 -Vcc=20V Rc=4kQ H Vout 1uF Rl >2kQ

Q: An alternating current is given by I = 22sin222t. What is the time to generate 3 cycles of current?…

A: Given: An alternating current , I = 22sin222t. To calculate the time to generate 3 cycles of…

Q: For the circuit shown: 1. Find the value of "R" that makes the circuit in resonance. 2. Determine…

A: It is given that:

Q: Find u (1) in the circuit shown in Fig. 16.9. Note that, since the volt- age input is multiplied by…

Q: 15. Which of the following is TRUE? a. A conductor has a large amount of energy gap between…

A: Given a. A conductor has a large amount of energy gap between conduction band and valance band b.…

Q: Example 3.8: ELECTRICA Consider the circuit in Fig. 16.12(a). Find the value of the voltage across…

A: given here a transient analysis circuit and asked to find the voltage across the capacitor.

Q: Referring to this figure, calculate Av if yos= 20 µS. Vp in the figure is Vgs(off)

A: The required parameters can be calculated by using the DC analysis and AC analysis of FET amplifier.

Q: Find the function FF using Karnaugh map and draw the logic circuit.…

A: For the above given minterms we need to compute their simplified boolean expression by using k map.

Q: The efficiency of a 1000kVA, 110/220V, 50Hz single phase transformer is 98.5% at a half load 0.8 p.f…

Q: In a common-source JFET amplifier, the output voltage is 180 out of phase with the input 90 out of…

A: Answer: 180 out of phase with the input. Explanation: a. It is a valid option. The amplifier…

Q: Question 39 Super positions theorem is not applicable in the network when it is Linear Time in…

A: In this question we will write about superposition theorem....

Q: A transformer of 500kW output with unity power factor is required to operate for 8 hours at 25%…

Q: Q2: Equipment ratings for the four power system shown in Figure (1) are as follow: - GI 500 MVA,…

A: In this question we need to draw a positive sequence per unit reactance diagram of given system.

Q: Find even and odd X (+) = sin(t) + Sin(t)• Cost) + sinA) + cos(t)

A: Given A signal ,we need to determine the even and odd signal. Please find the below attachment for…

Q: b) A square loop carrying a current of 15 A with dimensions of 2 cm x 2 cm is positioned within a…

A: Whenever current passes through the loop a magnetic field is generated , which produces a torque as…

Q: The average current of sinusoidal wave is 50A. Compute for maximum current. Group of answer choices…

A: given here the average current of sinusoidal wave is 50 Ahere we have to find the maximum value of…

Q: Question 17 Find the wave length of a carrier wave with frequency of 20 MHz. 35m 45m 25m 15m

A: Given: Frequency, f=20MHzSpeed of light, c=3×108 m/s

Q: (6) Apply Norton's theorem to find Vo in the circuit of Fig. 6 ΤΩ 4Ω ΜΕ 34 16Ω Figure 6 5Ω 12 V 10 Ω

Q: If the impedance of the circuit is 500 and the resistance is 80. Find the power factor.

A: In AC circuits, the power factor is defined as the ratio of Active power to Apparent power. It is…

Q: The value of the equivalent resistance in the circuit shown in: Figure is R1=90 O 21 O 15.14 O 0.095…

Q: Find the maximum value of gm for FET with loss 10mA, V₂=-2V, VGs 5V? express answer in mS

A: To find the maximum value of gm for FET with IDSS = 10 mA , Vp = - 2 v and VGS = 5 v

Q: Consider a band-limited CT signal xc(t). It is properly sampled, being spaced T seconds apart, and…

A: Consider a band-limited continuous-time signal xc(t). It is properly sampled, being spaced T seconds…

Q: 5. The short circuit load is connected to a transmission line. When the transmission line length is…

Q: The superposition theorem is valid for

A: Superposition theorem states that in any linear bilateral network consisting of number of energy…

Q: 86) A two coils are mutually coupled with L₁ = 60μH, L₂=120JUH, K = 0.65 calculate the maximum and…

Q: QI/A: The per unit admittances are indicated at the diagram and the bus data are given in table as…

A: YBUS=Y11Y12Y13Y21Y22Y23Y31Y32Y33where,Y11=y12+y13Y12=Y21=-y12Y13=Y31=-y13Y22=y12+y23Y23=Y32=-y23Y33=…

Q: - B- Use Thevenin's Theorem to find the current through (R) in the circuit shown below. 2 A (1+ R3…

Q: 27. Given the field H = 20p² a m Find the total current passing through the circular surface p ≤ 1,0…

A: We need to find out current for given field

Q: 5. When an open circuit load is attached to one end of a transmission line, the voltage will be the…

Q: 9. Find the magnetic field intensity when the flux density is 8 x 10-6 T in the medium of air. a. 1x…

Q: Find u (1) in the circuit shown in Fig. 16.9. Note that, since the volt- age input is multiplied by…

Q: Find vo(t) in the circuit shown in Fig. 16.9. Note that, since the voltage input is multiplied by…

A: The s-domain circuit is shown below: v(t)=e-2tu(t)Lv(t)=Le-2tu(t)V(s)=1s+2 Applying K.V.L at the…

Q: Given the first order circuit below, compute the time constant T 2kn 1A ) ( (a) 7 = 3ms (b) T = 2s…

A: We need to find out the time constant

Q: 22. For the circuit shown beside, find v₁ and v₂ ford> 0 if the circuit is in steady- state att 0.…

A: To find V1 and V2 for t > 0 in the circuit

Q: What is the value for v www 1919 2 4V + 1 20220 22 n чить N₂ 262 mo it Im UT 22 P v WAITINEN 09010…

A: In this question we will find unknown voltage v...

Q: 36. The induced emf in a material opposes the flux produc a. Faraday's Law b. Ampere's Law C.…

A: In this question we will write about law for induced voltage....

Q: If the bar magnet moves away from the loop, in which direction should the induced current go in the…

A: In this question we need to find a direction of induced current.

Q: series motors has a very high starting torque because its armature resistance is small O True O…

A: Given A true or false question based on series DC motor. Please find the answer below

Q: A 200μF capacitor is connected in series to a 250V, 60Hz source. Assuming its resistance is 2002,…

A: For the given values of resistance, capacitance and frequency we need to compute equivalent…

Q: 9. What will be the impedance of a LR-C circuit if it has a circuit current of 3A and a supply…

A: 9. Answer: 40 ohm Explanation: a. It is not a valid option, By using ohms law the resistance is the…

Q: Plot a Root locows of the system K (5 + 2) (5+3) (5+1) (S-1) G(s)H(s) =

Q: R₁ P R3

Q: Q1) A) What is bus? How many ways to construct bus system. (explain with example for one type)

Q: For the following magnetic circuit, the flux density is 1 T and magnetic field intensity is 700…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Select the letter of the correct answer from the given problem.

*Kindly provide a CLEAR and COMPLETE solution* (Answer should be typewritten)

*Please answer it ASAP

Question 41
Theveni'ns theorem is not applicable when:
1) Load is coupled with the network
2) Linear
3) Time invariant
4) None
5) Non linear
6) Time varying
5,6
1,5,6
1,3,5,6
O 1,5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The two machines operate in parallel in a power station. What is the equivalent. H constant for the two, relative to a 100 MVA base?
A generator operating at 50 Hz delivers 1 p.u. power to an infinite bus through a transmission circuit in which resistance is ignored. A fault takes place reducing the maximum power transferable to 0.5 p.u. Where as before the fault, this power was 2.5 p.u. and after the clearance of the fault, it is 2 p.u. The value of 8 is max
Driving-point admittance The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is of O 6000 VA O 8000 VA O2000 VA 4000 VA Jump to ncements MacBook Air DD DII F10 F9 F8 000 F7 F6
write all possible KCL and KVL equations. simplify all and in ascending order, with contsant at the right side of the equation.
How can I compute and get the values of branch currents (Iab, Iac, Ibc, Ibd, Icd and Ica) and the algebraic sum of the potential difference for electrical loops (abca, abdca, acda, abcda and acbda) by using Kirchhoff's voltage and current law (KVL and KCL) equations?
1- Some HV - TL use Double Circuit .instead of One, why To transmit maximum voltage stability, and enhance the steady state stability. 6 To increase the capacity of HVTL and to enhance power system stability. a- All these answers are wrong. d- To increase the impedance of HVTL and to enhance power system stability. 2- Sometimes we use Red Balls with HV.TL in specific locations ? why and where a- To prevent HV.TL from lightning, it located at earth wire over roads and rivers. To give an alarm for the planes, it located at earth wire over roads and rivers. To reduce static transient voltage, it located at earth wire over roads and rivers. d- To reduce static transient voltage, it located at earth wire everywhere. 3- How you can read this impulse voltage : 1.2/50 us and at which ? Standard Durations wave front : 1.2 tr, Wave tail duration is defined as 50 m.si as in International Standard). C Durations wave front : 1.2 tr ( where tr is the transient time ), Wave tail duration is defined…
7. In the circuit below write the loop equations and set up (not solve) the matrix equation for the load current. Wiso 150 75 28 100
help me with this hw problem please. thanks!
Please help☹️ Give information about RE, RL and RLE loads. Write how loads are used in modelling.
Q2. A symmetrical n-network has a resistance of 7502 in the series arm and 2502 at each shunt arm. a) Calculate the open and short circuit impedances. b) Calculate the characteristic impedance. c) Calculate the propagation constant. d) Find its equivalent T-network.
How to solve this using kirchhoff's law?☹
For the circuit shown in figure, draw the oriented graph and write (i) tieset matrix, (b) cutest matrix -> tov