The water surface is at point A in the illustration when the funnel is empty, and the mercury at s=13.65 indicates a deviation of 15 cm. Find the new mercury deviation after the funnel has been completely filled with water at B

The water surface is at point A in the illustration when the funnel is empty, and the mercury at s=13.65 indicates a deviation of 15 cm. Find the new mercury deviation after the funnel has been completely filled with water at B

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Water flows through a horizontal 60-mm-diameter galvanized iron pipe at a rate of 0.021 m³/s. If the…

Q: A cantilevered beam has a distributed load (w) of 5035N/m acting down on it and along its entire…

Q: A 7.6m cantilever beam shown carries 104KN/m uniform load. Point A is free end while point B is…

A: Objective: To determine the value of EIy' (kN/m2) at the free end i.e., A using the Double…

Q: 5. For frame presented in Fig. 5, calculate the reactions at the two supports under the applied…

Q: A municipal wastewater treatment plant uses a circular clarifier. It receives 12 million gallons per…

Q: Assume that laminar flow of 60°F water has been maintained in a 1-in. schedule 160 (actual I.D. of…

A: Given Length = 100 ft Reynolds number= 23000

Q: At a hydraulic jump, the flow depths are 0.4 m and 5 m at the upstream and downstream, respectively.…

A: Hydraulic jump is a condition which occurs when fluids having supercritical flow meets subcritical…

Q: A simple curve has a length of 175.60 meters and its central angle or angle of intersectionis 52°.…

Q: The uniform 17-m pole has a mass of 135 kg and is supported by its smooth ends against the vertical…

A: Given data:- The given pole has a mass of, m=135 kg From the given figure find the magnitude at A…

Q: Current Attempt in Progress Cable AB passes over the small ideal pulley C without a change in its…

Q: List some composite materials that you use in your daily life.

A: Panels, frames, interior parts, and other components for vehicles and equipment are now made of…

Q: (2) 27"/ 6" TE #4 4 #9 (1) d = ? (2) (? C (3) = ? 39 Love d-c (4) Mn = ? fé= 3 ksi Grade 60 steel…

Q: A line of levels was taken at given points on the existing surface as part of a road reconstruction…

A: Given data:- Station Points Elevation 2+075 A 104.63 m 2+225 B 109.13 m 2+550 C 107.29 m…

Q: 14. CONVERTING BEARINGS TO AZIMUTHS. Convert the following bearings to azimuths (reckoned from…

A: Given data, A) N17°43'E B) Due west C) S25°31'E D) N12°19'W E) S57°30'W F) N77°13'W

Q: tb = (16.67 - 11.11)9.81(0.15 + 0.05) how did the answer became 2.83? when multiplied the following…

A: Given data: tb = (16.67 - 11.11)9.81(0.15 + 0.05)

Q: Problem 6.78: Determine the components of all forces acting on member ABCD of the assembly shown…

A: Given data : Determine the component of all forces acting at ABCD?

Q: A cantilevered beam has a distributed load (w) of 5083N/m acting down on it and along its entire…

Q: #1 Determine the vertical displacement of joint A. Each bar is made of steel and has a…

A: Given: E=200 GPaA=600 mm2P=54 Na=2 m

Q: Compute the product of inertia with respect to the x- and y-axes. 60 60 60 30- 60 Dimensions in mm…

Q: Unbound granular materials have stress-hardening properties. a. True b. False 32. Fine-grained…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: For fully developed laminar pipe flow in a circular pipe, the velocity profile is given by u(r) = 2…

A: For circular pipe there is a standard relation between average velocity and maximum velocity. The…

Q: Draw the complete shearing force diagram for the beam shown below. A 2 m 120 kN B C 1 m 36 kN/m -3…

A: Objective: To draw the shearing force diagram for the given beam. The shearing force diagram will…

Q: efficient of consolidation (C) for this clay was found to be 0.544x10-² ompute the ultimate…

A: Given:-drainage settles=10cm in 5 yearCv=0.544 x 10 -2cm2/sec60% of this amountTo find:-Ultimate…

Q: Two identical each cylinders with a mass of 50 Supported by the smooth C and D. A and kg are planes…

Q: are required, state them clearly. Calculate: any assumptions

Q: There is a structure composed of beam (AC) and truss (BD) as shown in the figure below. After trying…

A: E=29000kips/in2 To find displacement at B and C

Q: Lyanna, a former employee at a power plant, was injured on the jobsite last year: Under the OSH Act,…

A: Answer-1, Lyanna, a former employee at a power plant, was injured on the jobsite last year: Under…

Q: A simply supported beam is loaded as shown. Using double integration method with E = 21.8 x 10 kN/m2…

Q: The Venturi meter shown in the sketch below, contracts the flow down to one quarter of its original…

A: Answer From Bernoulli's equation we have P1γa+v122g+z1= P2γa+v222g+z2+hL P1γa-…

Q: 3. A concrete pipe of 6 m long is used to block flood water from the left to contaminate a pond of…

Q: 1600 N/mm², fy = 460 N/mm². Upypu) = 0.92, estimate the moment capacity of the section according ACI…

Q: Two solid steel shafts (G = 77.2 GPa) are connected to a coupling disk B and to fixed supports at A…

A: Given data : G = 77.2 GPa A) Reaction at each support B) Max. shear stress in shaft AB C) Max…

Q: 45. A 7x3/4 in. A36 plate is shown in Figure P4.45, where the holes are for 3/4 in. bolts. Determine…

A: Given: Grade of Steel = A36 Gross area(Ag) = 5.25 in2 Thickness (t) = 0.75 Diameter of the bolt…

Q: A rigid retaining wall of 6m height has a saturated backfill of soft clay soil. What is the critical…

A: Given a rigid retaining wall has, Height, h = 6 m. Properties of the clay soil are: γsat=17.56 kNm3.…

Q: determine the slope and defelction at A and C of the beam in the figure using virtual work method.…

Q: 1) Determine the Azimuth and Bearing angles for all line segments of the given traverse and…

Q: 15. CONVERTING AZIMUTHS TO BEARINGS. The following lines have their azimuths reckoned from north: a)…

A: Given data, a) AB, 52°21' b) BC, 180° c) CD, 337°15' d) DE, 219°56' e) EF, 5°23' f) FG, 134°29'

Q: 5. lim (v² + 2v) (2v³ – 5) - v-2

A: Given -

Q: Give a detailed example of estimating rainfall using the Isohyetal Method. Include the steps and the…

Q: 16. Two tanks are connected by a 500-ft length of 1-in.- I.D. PVC pipe. The appropriate value for…

A: In this problem we have asked difference in water surface elevation between the two tanks. we have…

Q: The water content of a 100% saturated soil is 30%, and the specific gravity of solids is 2.50.…

A: Water content = w = 30% Degree of saturation = S = 100% Specific gravity = G = 2.65 To determine -…

Q: Determine the deflection at point C A 2 k/ft 30' B 10⁰' 12 k

Q: Collars A and B slide along the fixed right-angle rods and are connected by a cord of length L = 6.2…

Q: ) Room ventilation is an important area of environmental and architectural engineering for the…

A: Given: In this question, the given details are The room ventilation is an important area of…

Q: d. Problem III. A sample of wet soil has water content of 18% and a porosity of 42%. The unit weight…

Q: Degree of saturation

A: Introduction: The given question is related with geotechnical engineering . In this question we are…

Q: Please answer these Civil Engineering Questions 1. Can a contractor refuse to do change order…

A: Note : “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: continue the last 2 please

Q: The member is an A-36 steel structural Tee for which I = 76.8 in². Suppose that P = 4.3 k. Use the…

A: Given data:- Value of P is 4.3 I = 76.8 in4

Q: (1) 21" 3". 4#9 14" (1) Ec = ? (2) fr=? (3) Mer=? #4 (4) When M = 70 (5) & Mn = 2 fl=5 ksi Grade 60…

A: Given: fc = 5 ksi = 5000 psi fy = 60 ksi = 60,000 psi b = 14 in d = 21 in h = 24 in main bar =…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

15 cm
к
B
-30 cm
A
80 cm
water
mercury
s = 13.65

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Sit3.3 Please show your complete solution.
G.3 2/3
Give the equation for Cunningham correction factor.
ASAP
Problem 1 Fill the table and use 25% expansion factor Fill Vol. Cut Vol. Fill Vol. Cum. yd (25%) (-) Station Cut, ft? Fill, ft? yd' (+) yd3 Vol. yd3 120+00 0. 121+00 195 122+00 239 123+00 425 124+00 410 56 124+50 90 111 125+00 0. 183 126+00 200 127+00 199 128+00
E should 29 x 10^3 ksi.
What reduction factor are we going to use if p > Pb a. 0.9 b. 0.65 c. 0.45 d. Ø= 0.65 +0.25 Ey Tet Ey-0.005
Given: F |Change in length of BE=0.00352a mm Area(BE)=150a mm? Area(CF)=150a mm? E=200 GPa Required: |Change in length of CF? 18a mm 2ба mm P - 24a - mm
Prepare and complete profile level notes, show the customary arithmetic check and plot the profile(use graphing paper in plotting the profile) STA BS HI FS IFS ELEV. BM3 1.260 99.695 0+10 1.280 0+20 1.288 0+30 1.310 0+40 1.315 0+50 1.321 0+60 1.342 0+70 1.350 0+80 1.360 0+90 1.363 1+00 1.335 1+10 1.345 1+20 1.360 1+30 1.330 1+40 1.350 1+50 1.320 1+60 1.400 1+70 1.440 1+80 1.465 1+90 1.490 BM4 1.500
Take yz as 48. please give the detailed solution
Tons :ו וסAnldLi Review View Help O Recc 14 A A A E E EE 1E A Shape Fill O Find Aa 2 A ALLOIG Z Shape Outline Replace IUS ab AV Arrange Quick EE Styles O Shape Effects A Select Font Paragraph Drawing Editing A7 cm long poorly graded sand (k=0.05 cm/s) is placed next to a 33 cm long sandy silt (k=0.005 cm/s). Both soils have a cross sectional area of 10 cm? and are attached to reservoirs as shown below. 50 cm 100 cm 40cm Sand Sandy silt A) What is the equivalent hydraulic gradient for the system? (iAB) B) What is the flow rate through the poorly graded sand? C) What is the height of the vertical column of water inside piezometer installed at point C? D) What is the hydraulic gradient from A to C? s中石 |四 =
2. The following equations were established for a study area. T=40+ 489x, -0.004x,-02-0.017. (1₂=5₁4₂=3,1₂=9.44 = 1.2, R² = 0.69) (r = 25, R² = 0.45) where T = 30 + 5.9X₁ T = 300 +0.25X₂ T = 25 +2.4X₁ + 0.15X₂ (t = 41, R² = 0.23) X, = family income ($1000) (4= 35,4 = 95, R² = 0.85) T= trips/household X₁ = vehicle ownership (cars/household) X₂ = population density (persons/acre) = distance from the CBD (miles) 175 be The number of observations used in setting up these equations is 53. (R² and 1-tests results are also given.) Comment on the reasonableness and logic of these equations for use in this study.