The two diodes are identical with forward voltage of 0.68 V. At what value of V will Vout be one half of V? Express your answer in volts. 100 Ω WHI Vout

Q: 89. A wire has a resistance of 6 ohms. It is bent in the form of an equilateral triangle. The…

A: Given: Resistance of a wire, R=6 Ω. It is bent in form of equilateral triangle.

Q: If in a Y- connected ac generator, each phase voltage has a magnitude of 90 Vrms, what is the…

A: Given a Y-connected generator with, Each phase voltage has magnitude, Vph=90 V rms.

Q: True or False Lenz' Law applies to all types of circuits, but in the case of dc circuits, all…

A: Given that Lenz' Law applies to all types of circuits, but in the case of dc circuits, all circuit…

Q: What are the expected voltages at points C and D of this circuit? O10 V and 2 V O2 V and 0 V O12 V…

A: Given data: Voltage Voltage is the pressure from the power source of an electrical circuit that…

Q: What are the functions of a sensor? Explain the function of on delay timers. Explain the working…

A:

Q: A 620-V source connected to a resistor network described by RT = 50 + (R || 20) provides 120 V to…

A:

Q: onstruct a ladder diagram for Priority Sequence R1 R2 R3 (ARRANGE IN ORDER)

A: According to the question, we need to construct a ladder diagram for priority sequence R1, R2, &…

Q: For an FM modulator with a modulation index m = 1.5, a modulating signal vm(t) = Vm sin(2000πt), and…

A: Given: Modulation index, m=1.5 Modulating signal, vm(t)=Vmsin2000πt vm(t)=Vmsin2π×1000πt…

Q: Problem 4.23 (Node-Voltage Method) Find io 800 Ω www Το 50 V (+ 80 Ω V 40 Ω 50 Ω 500 C Yż Ο 4 )750…

A:

Q: The current through a 12-mH inductor is 4 sin 100t A. Find the energy stored at t = π/200 s. A) 34…

A: Given a inductor L = 12 mH and current i(t) = 4 sin 100t Ahere we have to find the energy stored by…

Q: Given an input signal x(n)=()u(n), derive a solution for y(n) within the finite inter 0 ≤ n ≤N for…

A: We need to find out the output for given input and system , we will use z transform to find out…

Q: A 230V, 50 Hz, 4-pole, single-phase induction motor is rotating in the clockwise (forward) direction…

A: Given- 230 V, 50 Hz, 4-pole Single phase Induction motor, Speed N=1425 RPM, Rotor resistance- R2=7.8…

Q: Find Reqv. across the terminals A and B. 19 1Ω 1Ω www at Recy⇒ 1.0 www 1Ω 1.0. :19 10 Σ1Ω 1Ω 1.0.…

A: Given circuit,

Q: Measured Voltage 9 V. Computed Current Measured Current -W- 1.0KQ R3 1.0KQ R1 R2 >1.0kQ Figure 1…

A:

Q: series circuit consists of a dc voltage source and 4-, 5-, and 6-ohm resistors. If the current is 7…

A: We need to find out source voltage for given current and resistor .

Q: 10 of 20 Which DMM measurement would you expect based upon the red and black leads in this image? 12…

A:

Q: A separately excited generator has a no-load voltage of 130V at a field current of 2.1 A when driven…

A: Generated emf of DC machine is directly proportional to product of flux and speed. Take the ratio of…

Q: For the parallel circuit, given R1=1.5 2; R2=14 2; R3-13 ; R4-5.75 02; RT R₁ ww R₂ R3 R4

A: Given circuit, Where, R1=1.5 Ω.R2=14 Ω.R3=13 Ω.R4=5.75 Ω.

Q: using straight line approximation draw the bode magnitude response diagram oa a system with transfer…

A: Given- Gs=100.25s2+0.5s+1s0.01s2+0.1s+1, To Find- To draw the bode magnitude response diagram fa a…

Q: TRUE OR FALSE Susceptance is always expressed as a imaginary number and comprised the imaginary part…

A:

Q: A charge of 10 mC flows through a cross- section 2.5 mm² normally in 2 seconds. The current is (1)…

A: We need to find out the current for given charge and time .

Q: Provide the timing diagrams for the following circuits when provided with the following input…

A:

Q: The flux density at a distance of 0.1 m from a long straight wire, carrying a current of 200 A is?

A: Given: Distance from a long straight wire, d = 0.1 m. The wire carrying a current, I=200 A.

Q: 1₁ V₂+ R M 2Rx R=202, I₁=5A, V/₂=40V, and V3 = 18V. Determine the values of the 4 currents listed…

A: We need to find out the current due to individual source for given circuit .

Q: G(s)=35/s(s+5) find: damping ratio natural freq.

A: We need to find out damping ratio and natural frequency for given characteristics equation .

Q: 3. Solve for I and the power delivered to the 3-k resistor using Mesh Analysis and KVL at the outer…

A:

Q: Find the inverse Laplace transform of the following functions d. F(s)-(+2)(8+3) F(3) 68+25 F(s) (+5)…

A:

Q: The Laplace transform of a function () is given by the expression F(a)=L(/(-/* Find the Laplace…

A:

Q: Calculate the intensity of radiation for the surface which has temperature of 200 °C. Select one: a.…

A: Given, The surface has temperature, T=200 °C=473.15 K. The intensity of radiation, E=?

Q: 7. Express F = BC'+ AB + ACD in canonical form (both SoM and POM).

A:

Q: Given the following information, find the magnitude of the total power developed in the circuit and…

A:

Q: A certain FET with k-2mV/V2 and λ= 0.05 V-1 is biased at Ip =2mA. If RD=5k2 and R=3k2, estimate the…

A:

Q: 9. The purpose of the Zener diode is to maintain the voltage across the load at 11 V. The load draws…

A:

Q: Problem 4.30 (Node-Voltage Method) Find the power developed by the 20 V source 35 έφ ΖΩ 1Ω Va Va 4Ω…

A:

Q: Q2. a). Find the voltage, Vs in the electric network shown in figure B, 4mA Vs R = 3 ΚΩ + V₁ Is ET…

A: Given data, Circuit diagram is given as,

Q: Question 11: The nominal impedance of a low pass 1 section filter is 500 ohms, and its cut-off…

A: Given, Nomial impedance of low pass π section filter, R∘=500 Ω Cut off frequency fc=100 Khz

Q: R₁ = 69 R₂=392 R3 = 492 R4 = 59 R5 = 89 R6=292 Io = 2.4A a Answer: R₂ d What is the current through…

A: Given, R1=6 ΩR2=3 ΩR3=4 ΩR4=5 ΩR5=8 ΩR6=2 ΩI∘=2.4 A

Q: Consider the circuit shown in the figure below. (Assume R₁ = 11.00, R₂ = 2.70 , and V = 7.70 V.) R₂…

A:

Q: Use the mesh-current method to find the branch currents ia , ib, and ie in the circuit in (Figure…

A: We need to find out current for given circuit, first we will find out the node voltage then we will…

Q: 4 V2 5V 5 R2 www 192 L2 1H 7 6 C1 1F

A:

Q: a www R33 d Io R₁ b R₁ R5 e R₂ www R6 с R₁ = 50 R₂=302 R3=692 R4=802 R$ = 492 R6=202 Io = 4.5A What…

A: Given circuit:

Q: A voltage source with series impedance 32-j8 2 is connected to a load impedance. What must the load…

A: Given: Impedance connected in series of voltage source, Zs=32-j8 Ω.

Q: If R1= 1 Ohm R2= 2 Ohm. Suppose R1 and R2 are connected SERIES. Then what is Equivalent (a)10 Ohms…

A: Given data, Resistances are given R1=1 Ω, R2=2 Ω

Q: Find Vo=? Ο Vs =20 V M 8 Ω 6Ω Vo=?

A: Given circuit,

Q: Using straight line approximation draw the Bode magnitude response diagram of a system with transfer…

A: The question is about bode plot.

Q: analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz.  The…

A: We need to find out the number bits per sample for quantization error .

Q: How many truth table entries are necessary for a four-input circuit? Select one: O a. 12 O b. 4 O c.…

A:

Q: SOLVE FOR THE FOLLOWING. I(s), I(t), Vr(t), VL(t).

A:

Q: 1.32 For the circuit shown in the figure below, the voltage across the 1 ohm resistor is given by 4…

A: Given circuit,

Q: If xn = 12.5 + 3.6 e-0.2 n then calculate x10 Give two digits past the decimal point.

A: Given data: xn=12.5+3.6e-0.2n

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.