The traffic volume data table below counts was taken on rural a highway during the morning peak hour at (8:00-9:00 am) on Monday of a week. Time periods (minute) 8:00-8:15 AM 8:30-9:00 AM Number of vehicles 385 790 The average time headway (sec) during 2.25 8:00-9:00 am a) Find the traffic volume for the period from 8:15 to 8:30 am. b) Determine the hourly volume (HV), the maximum rate of flow within the hour, and the peak hour factor (PHF). c) Estimate the density and speed of traffic if an average spacing of 150 ft. d) Estimate the daily volume for Monday if the hourly expansion factor (HEF) is 22.05.

The traffic volume data table below counts was taken on rural a highway during the morning peak hour at (8:00-9:00 am) on Monday of a week. Time periods (minute) 8:00-8:15 AM 8:30-9:00 AM Number of vehicles 385 790 The average time headway (sec) during 2.25 8:00-9:00 am a) Find the traffic volume for the period from 8:15 to 8:30 am. b) Determine the hourly volume (HV), the maximum rate of flow within the hour, and the peak hour factor (PHF). c) Estimate the density and speed of traffic if an average spacing of 150 ft. d) Estimate the daily volume for Monday if the hourly expansion factor (HEF) is 22.05.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.18P: The drag on an airplane wing in flight is known to be a function of the density of air (), the...

See similar textbooks

Similar questions

YouTube Mall Over... Leeds International... M1 Questions by To... Question Completion Status: QUESTION 2 A car of mass 750 kg moves along a stretch of road which can be modelled as a line of greatest slope of a plane inclined to the horizontal at 30°. As the car moves up the roa for 500 m its speed reduces from 20 ms-¹ to 15 ms-¹. Calculate: a the loss of kinetic energy of the car 65,625) 66,625 67,625) O 68,625)
1) From 0 to 10 sec, find alphaA1, alphaC1 in rad/s^2, omegaA1(t), omegaC1(t) in rad/s, thetaA1(t), thetaB1(t) and thetaC1(t) in rad, and the distance made by the load s1 in inches and in feet made by the load during this time.
MT NUIES ASK YOUR (a) Find a conversion factor to convert from miles per hour to kilometers por hour, mi/h x = km/h (b) Suppose the maximum highway speed is 70 mi/h, Use the conversion factor from part (a) to find the speed in kilometers per hour. km/h (c) Suppose the maximum highway speed has been raised to B5 mi/h in some places. In kilometers per hour, how much of an increase is this over the 70 mi/h limit? km/h
v(m/s) 1.00 6) Draw a velocity-time graph that shows the motion of a ball that roll up then down a ramp with an initial velocity of +1.0 m/s and an acceleration of -0.20 m/s². 15 1.0 t(s)
Parts for each product Homework 1 n produce dryer plant Can for each product castiens Then each product is assembled in its dedicated washing and dryer A machines. Difterent are manufactured by press and motor ly sechon. The the monthly capacity of different sections are: washing machine or looo dryer machine Press section: 100 - Motor section: 1600 washing machine or 7o00 drjer machine machine assembly line: goo0 machine washing druer machine assembly line: 5000 machine washing 1, profit for each unct of washing and dryer machines is 270 and 300 respectively. Formulate a linear programming problem for Find ing how many washing and dryer machines should be produced many washing to maximize total plant's profit. 2.A A Post Company need to transfer 30000 boxes with two each truck presented of olifferent trucks. Chavactenistics problem for The table below. Formulate a linear programming each truck to optimum nunber of minimIze total Cost.
The figure shows a plot of potential energy U versus position x of a 0.270 kg particle that can travel only along an x axis under the Influence of a conservative force. The graph has these values: UA9.00 ). Uc 20.0 J and Ug 24.0J. The particle is released at the point where Uforms a "potential hill" of "height" Ua 12.0J. with kinetic energy 7.50 J.What is the speed of the particle at la) -3.50m and (b)x - 6.50 m? What is the position of the turning paint on (c) the right side and (d) the left side?
1. The graph in Fig. A shows the velocity of an ambulance vehicle driver plotted as a function of time. How far does the officer go in the first 3 seconds? The first 7 seconds? The first 11 seconds? Vx (m/s) 50 45 40 35 30 25 Fig. A 20 15 10 5 t (s) 2 4 6 !8 10 12 14 7 11 3.
Energy of a Roller Coaster Car 500 450 400 350 --- 3 300 250 E 200 150 100 50 6 8 10 Time (s) Mechanical Energy ....... Potential Energy -- Kinetic Energy This graph shows different types of energy for a roller coaster car that starts at the top of a large hill and goes down to its lowest point at 6 s. According to the graph, what is the most likely relationship between height and potential energy? Your answer: They are directly related. They are inversely related. There is no relationship between the two. There is not enough information for a conclusion.
Q1: 1 1 3 4 5 6 8 10 11 time (s) The above velocity- time graph for an object that moves as shown path. 1. Discuss the diagram. 2. Instantaneous acceleration after 1.5 second of staring. 3. The displacement during the first six seconds. 4. The acceleration last 2 seconds. velocity (m/s)
I have data accrued from a fan could you explain to me the concepts and show me how to calculate the horsepower and work done by the fan that data was composed of below in this table? Time (s) Run #1 Velocity, Blue (m/s) Run #1 0.05 0 0.1 0 0.15 0 0.2 0 0.25 0 0.3 0 0.35 4.04E-04 0.4 4.04E-04 0.45 0 0.5 -4.04E-04 0.55 -4.04E-04 0.6 0 0.65 0 0.7 4.04E-04 0.75 8.08E-04 0.8 4.04E-04 0.85 -4.04E-04 0.9 -8.08E-04 0.95 0 1 8.08E-04 1.05 4.04E-04 1.1 0 1.15 -4.04E-04 1.2 0 1.25 4.04E-04 1.3 0 1.35 0 1.4 -4.04E-04 1.45 0 1.5 4.04E-04 1.55 0 1.6 0 1.65 -4.04E-04 1.7 0 1.75 4.04E-04 1.8 0 1.85 0 1.9 -4.04E-04 1.95 0 2 4.04E-04 2.05 4.04E-04 2.1 4.04E-04 2.15 0 2.2 0 2.25 0 2.3 0 2.35 0 2.4 0 2.45 0 2.5 4.04E-04 2.55 8.08E-04 2.6 8.08E-04 2.65 8.08E-04 2.7 8.08E-04 2.75 8.08E-04 2.8 4.04E-04 2.85 0 2.9 0 2.95 0 3 0 3.05 0 3.1 0 3.15 0 3.2 0 3.25 0 3.3 0 3.35 0…
1. The wheel starts rotating from rest, 2) if its angular velocity Was a function of angular position 0 is W=0.1-0², where O is in radian, and its radius ris 0.2 m, what is the magnitude of the angular acceleration (in rad/s?) of the wheel after the wheel has turned 1.1 revolution(s) from rest. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. P
Problem Compute the kinetic energy of an 3046 lb. Automobile travelling at 104 mi/hr, ) How many times as great is the kinetic energy if the velocity is tripled (3). Ans. 9 times Problem Compute for the kinetic energy in ergs and in joules of a riffle bullet travelling at 276 m/sec. Ans 2.160 X 10 567.00 gram 11 ergs; 21595.896 dynes