The peak integrations of a chromatogram resulting from a GC analysis of a mixturecontaining component X and component Y (of a fractional distillation) shows thefollowing data:Component X - Area = 64.3 sq unitsComponent Y - Area = 156.5 sq unitsWhat was the percentage composition of the compounds X & Y in the mixture?X= 39.1%, Y= 60.9%X= 29.1%, Y= 70.9%X= 48.1%, Y= 51.9%X= 70.9%, Y= 29.1% 5.20 g of tea leaves were used for the extraction of caffeine in a laboratory experiment, If the mass of crude caffeine obtained and the mass of pure caffeine recovered after recrystallization are 0.166 gand 0.082 g respectively, what is the percentage yield of pure caffeine from the tea leaves?O 2.10%O 2.30%O 1.58%O 3.62%

Area under the curve of GC is correspond to mass of that component.

The peak integrations of a chromatogram resulting from a GC analysis of a mixture containing component X and component Y (of a fractional distillation) shows the following data: Component X - Area = 64.3 sq units Component Y - Area = 156.5 sq units What was the percentage composition of the compounds X &Y in the mixture? X= 39.1%, Y= 60.9% X= 29.1%, Y= 70.9% X= 48.1%, Y= 51.9% X= 70.9%, Y= 29.1%

The peak integrations of a chromatogram resulting from a GC analysis of a mixture containing component X and component Y (of a fractional distillation) shows the following data: Component X - Area = 64.3 sq units Component Y - Area = 156.5 sq units What was the percentage composition of the compounds X &Y in the mixture? X= 39.1%, Y= 60.9% X= 29.1%, Y= 70.9% X= 48.1%, Y= 51.9% X= 70.9%, Y= 29.1%

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter15: Solutions

Section: Chapter Questions

Problem 12CR: Without consulting your textbook, list and explain the main postulates of the kinetic molecular...

See similar textbooks

Similar questions

You want to prepare a 1.0 mol/kg solution of ethyleneglycol, C2H4(OH)2, in water. Calculate the mass of ethylene glycol you would need to mix with 950. g water.
34. For each of the following solutions, the number of moles of solute is given, followed by the total volume of the solution prepared. Calculate the molarity of each solution. a. 0.754 mol KNO; 225 mL b. 0.0105 in of CaCl; 10.2 mL c. 3.15 mol NaCl; 5.00 L d. 0.499 mol NaBr; 100. mL
According to the Resource Conservation and Recovery Act (RCRA), waste material is classified as toxic and must be handled as hazardous if the lead concentration exceeds 5 mg/L. By adding chloride ion, the lead ion will precipitate as PbCl2, which can be separated from the liquid portion. Once the lead has been removed, the rest of the waste can be sent to a conventional waste treatment facility. How many grams of sodium chloride must be added to 500 L of a waste solution to reduce the concentration of the Pb2+ ion from 10 to 5 mg/L?
Without consulting your textbook, list and explain the main postulates of the kinetic molecular theory for gases. How do these postulates help us account for the following bulk properties of a gas: the pressure of the gas and why the pressure of the gas increases with increased temperature; the fact that a gas tills its entire container; and the fact that the volume of a given sample of gas increases as its temperature is increased.
A 12.63 g sample of calcium ore was dissolved in HCl and gravimetrically analyzed, through the precipitation of calcium into CaC2O4 · H2O. The precipitate was filtered, washed, dried, and ignited at 500 oC until the weight was constant, giving a final mass of 2.35 grams pure CaCO3 (100.087 g/mol). Calculate the % Calcium (40.078 g/mol) in the sample.
1. A buffer is prepared using lactic acid (HLac) and sodium lactate (NaLac). 0.300 dm3 of the 0.500 mol·dm–3 HLac solution is mixed with 0.300 dm3 of the 0.300 mol·dm–3 NaLac solution to prepare the buffer. Ka for lactic acid (HLac) is 1.4 x 10-4 What will the pH of the above solution be after 5.0 cm3 of 0.200 mol·dm–3 NaOH has been added to only 100.0 cm3 of this buffer? 2. Data in the table below were collected at 25°C for the following reaction:2 I–(aq) + S2O82–(aq) I2 (aq) + 2 SO42-(aq) a) Determine the rate law for the reaction. b) Calculate the rate constant, giving the correct units for k.
11.50.0 g of silver nitrate is mixed with 50.0 g of hydrochloric acid in a water based solution. A white precipitate forms. The solution is filtered and the white precipitate collected and dried. The dried precipitate is measured to have a mass of 36.1 g. What is the percent yield?
A 0.879 g sample of a CaCl2·2H2O/K2C2O4·H2O solid salt mixture is dissolved in ~100mL of deionized water. The precipitate, after having been filtered and air-dried, has a mass of 0.284 g. The limiting reactant in the salt mixture was later determined to beCaCl2 ·2H2O. a.Write the ionic equation for the reaction. b.Write the net ionic equation for the reaction. c.How many moles and grams of CaCl2 ·2H2O reacted in the reaction mixture? d.How many moles and grams of the excess reactant, K 2C2O 4H2O, reacted in the mixture? e.How many grams of the K2C2O4·H2O in the salt mixture remain unreacted (inexcess)? f.What is the percent by mass of each salt in the mixture
A 19.51 ݃ sample of impure methylamine, which contains 72.58% (by mass) of CH3NH2 , isreacted with 30.81 ݃ of pure oxygen gas:4CHଷNHଶ(g) + 9Oଶ(g) ⟶ 4COଶ(g) + 10HଶO(ℓ) + 2Nଶ(g) In another experiment, this impure methylamine was used as follows: An unknown mass of the impure compound is dissolved in enough water to make 500.0 ݉ܮof solution. 20 ݉ܮ of this solution was transferred by pipette to a clean 250 mL volumetric flask andmade up to the mark. The molarity of the CH3NH2 in the final solution was determined to be 0.103 M.Determine the mass of CH3NH2 present in the original amount of impure compound used tomake this solution.