IThe endpoint of an acid-base titration is defined as the point whereO A. The amount (moles) of acid and base present are equivalent and a physio-chemical change occurs.O B. All the base added from the burette is used up.O C. Excess titrant is present.O D. The number of moles of acid and base are equal.

" The endpoint of an acid-base titration is defined as the point where. O A. The amount (moles) of acid and base present are equivalent and a physio-chemical change occurs. B. All the base added from the burette is used up. C. Excess titrant is present. O D. The number of moles of acid and base are equal.

" The endpoint of an acid-base titration is defined as the point where. O A. The amount (moles) of acid and base present are equivalent and a physio-chemical change occurs. B. All the base added from the burette is used up. C. Excess titrant is present. O D. The number of moles of acid and base are equal.

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter15: Acid-base Equilibria

Section: Chapter Questions

Problem 114CP

See similar textbooks

Similar questions

Another way to treat data from a pH titration is to graph the absolute value of the change in pH per change in milliliters added versus milliliters added (pH/mL versus mL added). Make this graph using your results from Exercise 61. What advantage might this method have over the traditional method for treating titration data?
An acid is titrated with NaOH. The following beakers are illustrations of the contents of the beaker at various times during the titration. These are presented out of order. Note: Counter-ions and water molecules have been omitted from the illustrations for clarity. (a) (b) (c) (d) (e) a. Is the acid a weak or strong acid? How can you tell? b. Arrange the beakers in order of what the contents would look like as the titration progresses. c. For which beaker would pH = pKa? Explain your answer. d. Which beaker represents the equivalence point of the titration? Explain your answer. e. For which beaker would the Ka value for the acid not be necessary to determine the pH? Explain your answer.
Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the formula KHC8H4O4. This is often written in the short-hand notation as KHP. If 25.0mL of a potassium hydroxide solution are needed to neutralize 2.26g of KHP, what is the molarity of the potassium hydroxide solution? Potassium hydrogen phthalate sometimes called potassium biphthalate, as shown on this bottle is an acid that is convenient to store and use because it is a solid.
Sketch the titration curve for a weak acid titrated by a strong base. When performing calculations concerning weak acidstrong base titrations, the general two-slep procedure is to solve a stoichiometry problem first, then to solve an equilibrium problem to determine the pH. What reaction takes place in the stoichiometry part of the problem? What is assumed about this reaction? At the various points in your titration curve, list the major species present after the strong base (NaOH, for example) reacts to completion with the weak acid, HA. What equilibrium problem would you solve at the various points in your titration curve to calculate the pH? Why is pH 7.0 at the equivalence point of a weak acid-strong base titration? Does the pH at the halfway point to equivalence have to be less than 7.0? What does the pH at the halfway point equal? Compare and contrast the titration curves for a strong acidstrong base titration and a weak acidstrong base titration.
Describe how the amount of sodium hydroxide in a mixture can be determined by titration with hydrochloric acid of known molarity.
Follow the directions of Question 64. Consider two beakers: Beaker A has a weak acid(K a=1105). Beaker B has HCI. The volume and molarity of each acid in the beakers are the same. Both acids are to be titrated with a 0.1 M solution of NaOH. (a) Before titration starts (at zero time), the pH of the solution in Beaker A is the pH of the solution in Beaker B. (b) At half-neutralization (halfway to the equivalence point), the pH of the solution in Beaker A the pH of the solution in Beaker B. (c) When each solution has reached its equivalence point, the pH of the solution in Beaker A the pH of the solution in Beaker B. (d) At the equivalence point, the volume of NaOH used to titrate HCI in Beaker B the volume of NaOH used to titrate the weak acid in Beaker A.