See the diagram below: Capacity/Rated Capacity (%) vs. Temperature (°C) 60 50 Temperature (°C) 40 30 20 10 0 0 10 20 20 -10 20 -20 -30 -40 30 46 40 50 50 60 70 80 90 0 90 100 110 120 Capcity/Rated Capacity (%) A battery bank needs to store at least 2300 Wh of energy at 56 V outside where the ambient air temperature is 0° C. You have access to lead acid batteries that have a nominal capacity of 18 Ah at 10 V at 25° C. What is the minimum number of batteries required to meet this charging requirement? Draw a schematic of the battery configuration.

See the diagram below: Capacity/Rated Capacity (%) vs. Temperature (°C) 60 50 Temperature (°C) 40 30 20 10 0 0 10 20 20 -10 20 -20 -30 -40 30 46 40 50 50 60 70 80 90 0 90 100 110 120 Capcity/Rated Capacity (%) A battery bank needs to store at least 2300 Wh of energy at 56 V outside where the ambient air temperature is 0° C. You have access to lead acid batteries that have a nominal capacity of 18 Ah at 10 V at 25° C. What is the minimum number of batteries required to meet this charging requirement? Draw a schematic of the battery configuration.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter30: Dc Motors

Section: Chapter Questions

Problem 6RQ: What is CEMF?

See similar textbooks

Similar questions

What is CEMF?
in the circuit shown below. Determine the following A)Vs (at the secondary) B)Vout(across R) C)Vrip (ripple Voltag) D) VDC full wave rectifier E) PIV(peak inverse Voltage) V1 C1 100µF 240V / 50HZ R1 104µF 1k T1 30:1
The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current (in amperes) flowing into the load resistor with 5.5 kiloohms resistance. O 0.00327 00.00152 O .0.00248 O 0.00175 34°C E jaao W 直。 DELL
89. If the ripple voltage in a full-wave rectifier is 25 V at a load current of 60 mA, its value at a load current of 120 mA will be (i) 50 V (ii) 25 V (iii) 100 V (iv) 12.5 V
Question (2) A controlled half-wave rectifier has a 240 V rms 60Hz ac source, The load a is R=30 Ohm resistor (a) Determine the delay angle such that the average load current is 2.5A (b) Determine the power absorbed by the load (c) Determine the power factor.
Click Submit to complete this assessment. Question 10 Extrinsic semiconductors are having more charge carriers than intrinsic semiconductor. True False A Click Submit to complete this assessment. MacBook Pro
What should I do when I get a current like 0.263187845A, should I round into the simplest form, or keep it and convert into mA?
Rectifier Circuit. 1. What is V1 reading? a. 110V b. 220V c. 0V d. 146.67V 2. What is V2 reading? 146.67V 207.42V 0V 103.7V 3. What is V3 reading? 132V 104V 207.42V 147V Thank u.
An alternating voltage, given by v = 100 sin 314t is connected to a full-wave rectifier. The average value will be _________. 31.8 volts 63.7 volts 70.7 volts 50 volts A sinusoidal current has a rms value of 3 amperes, its maximum value will be ______. 3.46 amp 2.1213 amp 0.866 amp 4.2426 amp A sine wave has a maximum value of 20 volts; its value at 135° is _________. 15V 5V 10V 14.14V
In a full-wave rectifier, the dc voltage level is larger than the ripple voltage level. Select one: O True False
Calculate % ripple factor for the given details of a full wave bridge rectifier. frequency= 50 Hz Rms voltage = 220 V Capacitance= 100 microfarad Resistance= 1 kiloohm
a. If you do not go completely around the loop when applying Kirchhoff’s voltage law, then the algebraic sum of the voltages cannot be determined the algebraic sum of the voltages will always be positive the algebraic sum of the voltages will always be negative the algebraic sum is the voltage between the start and finish points b. A p -type semiconductor is a semiconductor doped with impurity atoms whose electron valence is +4 pentavalent impurity atoms trivalent impurity atoms