Remove the 50 Ω resistor in the given circuit and assume an operating frequency of 50 Hz and a load of 100 Ω connected between terminals and b. In the given circuit x = 8.00∠0° A. j60Ω ww 50Ω 80Ω 1 ob Compute the average power delivered by the source. (Round the final answer to three decimal places.) × W. The average power delivered by the source is 6400

Remove the 50 Ω resistor in the given circuit and assume an operating frequency of 50 Hz and a load of 100 Ω connected between terminals and b. In the given circuit x = 8.00∠0° A. j60Ω ww 50Ω 80Ω 1 ob Compute the average power delivered by the source. (Round the final answer to three decimal places.) × W. The average power delivered by the source is 6400

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.2P: Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your...

See similar textbooks

Similar questions

If the voltage Vs = 800 mV, then the current flowing in the primary winding Ip, is: 1:8 -j202 Select one: a. Ip =40<0° mA O b. Ip =320<-90° mA O c. Ip = 0.320<90° A %3D O d. None of these ll
6. Determine the rms current I as shown in figure 1. Source voltage is already in RMS value (Answer must be in polar form and should be in 4 decimal places). -j4 N j1.5 A B 4 0 A 200/30° V -j2 N: jIN Figure 1.
How did he/she get the -j0.01963? I got different answer :(
DC/AC MOTOR (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS NEEDED. ANSWER IN 2 DECIMAL PLACES. BOX THE FINAL ANSWER.) A current of (120-j150) A flows through a circuit when applied voltage is (8 + j12) V. A. What is the magnitude of the circuit impedance: a. 0.0635 ohm b. 0.0256 ohm c. 1.52 ohm d. 1.325 ohm B. What is the reactive power? a. 825.75 VAR b. 525.68 VAR c. 639.75 VAR d. 438.72 VAR
For the circuit shown in Figure 1, determine the following: All the values are in ohms. 4 j8 3. A 3 jb 5 -j8 Figure 1 (a) The total impedance in the polar form in ohm. (b) The total current in polar form. (c) The total power absorbed in W. (d) The power factor of the circuit.
For the following circuit, determine the maximum power, PMa in Watts that can be transferred to the load resistor RL. Along the way you must find: (a) VTh, (b) RTh, and (c) PMaz in Watts. You must show all your work to receive full or partial credit. Put your final answers in the box provided. 15N a 102 2A( T RL 15V
%23 IoA 1172 IAB wwww IBC 20L-90°y -J992 204 30°y A ICA IcC a) Find the load current ICA ? b) Give the line yoltoge Vab? C Calculate the total complex power over the saurces of the voltoge7 www
PLEASE RESOLVE! THE FINAL ANSWER MUST BE IN THE CHOICES. DC/AC MOTOR (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS NEEDED. ANSWER IN 2 DECIMAL PLACES. BOX THE FINAL ANSWER.) A current of (120-j150) A flows through a circuit when applied voltage is (8 + j12) V. A. What is the magnitude of the circuit impedance: a. 0.0635 ohm b. 0.0256 ohm c. 1.52 ohm d. 1.325 ohm B. What is the reactive power? a. 825.75 VAR b. 525.68 VAR c. 639.75 VAR d. 438.72 VAR
2. A triangular voltage source has a peak value of 10 V. What is the computed RMS value of this source? a. 3 V b. 4 V c. 5 V d. 6 V 3. In Question 2, if the source is measured by an analog meter, will it show the correct RMS value? a. Yes b. No
Referring to figure 3, determine the rms voltage at j5Ω reactance (inductor) using KVL(Answer must be in polar formand should be in 4 decimal places).
A generation station has the following daily load cycle: Time (h) 0-6 6-10 10-12 12-16 16-20 20-24 Load (MW) 40 50 60 50 X 40 Find the value of X, if the units generated between 3pm to 11pm is 290000. Draw the load duration curve.
Determine the output waveform for the network of figure below and calculate the output dc level. Si D1 + 220 V 60 Hz ODeg 2.7kn V. TS POWER_10_Td_1 Si D2