Qu 1 Determine the normal stress component σx' and the stress component Tx'y' acting on the inclined plane AB. Solve the problem using the method of equilibrium. Express your answer in MPa to three significant figures. A 65 MPa /30° 20 MPa B

Determine the stress components acting on the plane AB. Solve the problem using the method of equilibrium described in Sec.

The state of stress at a point in a member is shown on the element. Determine the stress components acting on the inclined plane AB. Solve the problem using the method of equilibrium. Suppose that the normal stresses o₂ = 23 ksi, o, = 12 ksi act in the directions shown in the figure below. (Figure 1) Figure y' A 50° σv B < x' 1 of 1 σ x Determine the normal stress o Express your answer using three significant figures and include the appropriate units. OT = Submit Part B Tr'y = μA Submit Value Request Answer Determine the shear stress Try'. Express your answer using three significant figures and include the appropriate units. μA Value Units Request Answer ? Units 2 ?

The 80-kg lamp is supported by two rods AB and BC as shown in Figure. If AB has a diameter of 10 mm and BC has a diameter of 8 mm, determine the average normal stress in each rod.

In each case, the state of stress sx, sy, txy produces normal and shear stress components along section AB of the element that have values of sx = -5 kPa and txy = 8 kPa when calculated using the stress transformation equations.Establish the x and y axes for each segment and specify the angle u, then show these results acting on each segment.

The clamp presses the smooth surface at E when tightening the screw. If the tension in the bolt is 40 kN, determine the principal stress at points A and B and show the results on the elements located at each of these points. The cross-sectional area at A and B is shown in the adjacent figure. 300 mm 50 mm 30 mm 100 mm B 25 mm A 100 mm -50 mm

he state of stress at a point in a member is shown on the element.  Take σx = -3 ksi , σy= 4 ksi , τxy = -3 ksi . A) Determine the shear stress component acting on the inclined plane AB. Solve the problem using the method of equilibrium. B) Determine the normal stress component acting on the inclined plane AB. Solve the problem using the method of equilibrium.

If the allowable tensile stress for wires AB and AC is sallow = 180 MPa, and wire AB has a diameter of 5 mm and AC has a diameter of 6 mm, determine the greatest force P that can be applied to the chain.

Determine the stress components acting on the inclined plane AB in (Figure 1), where τxy=−42.7MPa τxy=−42.7MPa. Solve the problem using the method of equilibrium.

Determine the stress components acting on the inclined plane AB. Solve the problem using the method of equilibrium described in Sec