Q.12: Consider the linear transformer in Fig. Q12. Determine the input impedance Zin and the current from the voltage source. 40/0° V Μ 4Ω j8 Ω j3 Ω -j6Ω j10 Ω Figure Q12 6Ω =j4Ω

Q: 200 KVA, single phase two-winding transformer rated 4160/230 V, 60 Hz has primary and second…

A:

Q: www 1. Since m(t) = 2 cos(100лt) + 4 cos(200πt), ma = 0.9 and c(t) = 10cos(20000ft), find the…

A: According to bartleby's guidelines we are supposed to solve only one question out of multiple…

Q: 1) Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and…

A: Solution:

Q: In the figure below &1 = 6.00V, 82 = 12.00 V, R₁ = 100 2, R₂ = 300 , R3 = 2002, and both batteries…

A:

Q: Draw a simple diagram of a basic voltage amplifier including all components

A: Voltage amplifiers are used to amplify the voltage. Most used amplifier to get high output voltage…

Q: The lowest energy possible for a certain particle trapped in a certain box is 1.00 eV. (a) What are…

A:

Q: An inductor of 150hms and resistance of 10 Ohms are connected in series to a 230V, 50 Hz ac supply.…

A:

Q: Q2. If x(n) is the input and y(n) is the output of the system; y(n) = log10 [x(n)]. (A) If x(n) =…

A: Given:Aim:If input signal, draw x(n), y(n), y(-n-2), y(n)+y(-n-2)Check the property: Homogeneity,…

Q: EX: Find the Fourier Transform of X(t) = 3 Sin (lo x fc t) Plot the Signal of Xet) in the time…

A: Given:To do:We have to plot the signal X(t) in time domain and frequency domain for And what will…

Q: How should the initial data be erased from an EPROM?

A: Erasing the initial data from an EPROM (Erasable Programmable Read-Only Memory) requires a specific…

Q: c) d) d'y(1),dy(1) 3 +2 dt¹ dt y(t+2)-t²y(t+1) Property linear causal fixed (time invarient) dynamic…

A: Two differential eqns with contains terms multiplied with time coefficients.

Q: Given the feedback circuit below: R = 10 ΚΩ wo a. Loop gain b. Closed loop gain c. Input resistance…

A: “Since you have posted multiple questions with multiple sub parts, we will provide the solution only…

Q: The return loss (S11) plot of an antenna is shown in the figure below:

A: The return loss (s₁₁) plot of an antenna, The incident power (through a cable ) = 4 watts Frequency…

Q: 3. Write the Hamiltonian the Born-Oppeinheimer expression for a polyatomic molecule using…

A: In the field of quantum mechanics, the Born-Oppenheimer approximation is a fundamental concept used…

Q: 4) Calculate the voltage Vx and the current through the coil in the circuit below. (For t=0, it is…

A:

Q: A requirement exists for an FIR digital filter to meet the following specifications: Passband edge…

A: Given: A FIR digital filter has the following specification:To find:a) Sketch the tolerance scheme…

Q: Determine the capacitor voltage v(t) for t > 0 t = 0 6Ω 12V Μ 200 mF Η + v(t) – 3 Ω 2Ω

A:

Q: State whether the following systems are linear or nonlinear, causal or non causal, fixed or…

A: Given Data:The continuous-time systems of,To Find:LinearityCausalityTime-invariance or FixedDynamic…

Q: 2. The potential difference between the conductors is 110 V. How much work done in moving current of…

A: To calculate the work done in moving a current, we need to know the relationship between work,…

Q: 1 - Analyse the circuit as shown in Figure (initial state is 15) 2- show the timing diagram and…

A:

Q: Solve the given DC circuit using the node voltage and loop current methods. Write the circuit…

A: The node voltage, current through all the resistors and the power dissipated across the resistor…

Q: Find the initial and final values of f(t)=L-¹[F(s)] if 5s² + 7s +1 s. (s + 1)² F(s)

A:

Q: a) 8[n + 5] b) x[n] = u[n ] — «[n — 4] - c) x[n] = 0.5"[n]

A: We need to find out Z transform of the following signal and Fourier transform .Signala)…

Q: sider the circuit shown in (Eigure 1). re .00 A 10.0 2 20.0 2 www -ww 60.0 Ω 5.0 V 35.00 www 60.0 Ω…

A:

Q: EX: Find the Fourier Transform of X(t) = 3 Sin (lo x fc t) Plot the Signal of Xet) in the time…

A: Given:To do:We have to plot the signal X(t) in time domain and frequency domain for And what will…

Q: For the system of Figure 1, T = 2 s and G(z) = K(z + 0.8) (z - 1)(z-0.6) G(s) Figure 1. Unity…

A:

Q: + 4Ω Μ 6Ω 8 Α Μ Μ 80 3Α Μ ΤΩ

A: Circuit diagram is given as,

Q: Since the amplitude value of the current source in the circuit is x=99A, find the value of V0 using…

A:

Q: A 10 pole, 25Hz alternator is directly coupled to and is driven by 60 Hz synchronous motor. What is…

A: It is given that:For alternatorFor synchronous motor

Q: V1 1K DO DIODE /5mA # D1 D2 100 9V +1 10 Vo 1K

A:

Q: Given the feedback circuit below: V, 0- RE Rei m Q₁ a Vcc 2₂ m Rc₂ RF Q3 -o V₂ Find the following in…

A:

Q: A spherical insulator of radius R₁ = 10 cm has a spherically-symmetric charge density given by…

A: Gauss Law-It states that the electric flux through a closed surface is proportional to the electric…

Q: If the amplitude of the input reflection coefficient is 0.5 with an angle of 45 degrees and the…

A:

Q: 34, JoMVA, 11KV, y connected, alter neter is profected by mer 2- price circulating current system.…

A: Merz-price differential protection scheme:Merz-price differential protection is nothing but a…

Q: The magnetic flux density of a homogeneous magnetic field is B = 0.5538 T and is faced away from the…

A:

Q: I. ADC shunt motor having an armature resistance of 0.25 and a brush contact volt drop of 3 V…

A: Armature resistance Brush voltage Terminal voltage V = 120 V.Induced voltage

Q: At the instant the switch is closed in the circuit in (Figure 1), the capacitor is charged to 6.7 V,…

A: Solution:Given Data:=>V=4v=>C= 500nf=>t= 46ms=>V(o)R(0)=5.1Kilo - ohm=>Amplifier =…

Q: (2.1) Show how the optimal control problem with cost functional (1) I = t₁ f^*^* ƒº (z(t),u(t)) dt,…

A:

Q: 2. The 2-to-4 decoders with active-low outputs are available as building blocks. Each block has two…

A:

Q: According to the Routh-Hurwitz criteria discuss the stability of a system with the characteristic…

A: For stability of system using RH CRITERIA . we need to make RH table and check the sign change in…

Q: In an RLC circuit, L = 0.1; H₁; R=0.6; 22,; C=0.4;F, and E(1) = 60; V. Find the charge at time 1.…

A: Given dataInitial charge, Initial current, To find outExpression for the charge

Q: 3. A transmission gate contains two complementary transistors: NMOS and PMOS devices with their…

A: Why do we need two complementary transistors connected in parallel? Why having a single MOSFET…

Q: The signals on the oscilloscope V1(t) and V2(t) are given as V1(t) = 300*sin(120 π *t + 30) , 2 V…

A: In this questionWe need to determine the value of A and B. We are solving this problem using the…

Q: for the signal that is shown in the figure below A) plot the amplitude spectrum X(t) 3 -1 1 C) Find…

A:

Q: What is meant by slew rate of an operational amplifier?

A: What is meant by slew rate of an operational amplifier?

Q: Determine (a) the peak frequency deviation, (b) minimum bandwidth, and (c) baud for a binary FSK…

A:

Q: An FIR digital filter has the following specification Passband frequency ≥ 50 Hz ≤ 40 Hz Stopband…

A: Given: A FIR digital filter has the following specification:To find:(1) Sketch the tolerance scheme…

Q: 6. In Fig., solve for IB, IC, and VCE. Also, construct a DC load line showing the values of…

A:

Q: The diagram below shows a DC circuit containing resistors. State your answers to two significant…

A:

Q: Given the following circuit diagram, where the impedances are R1 = 60, R2 = 30, R3 = 40, C = -2j0,…

A: The circuit diagram,

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.