Problem 5 Find the equivalent inductance Leg for the network shown below. 72 mH oooo Leq 49 mH elle elle 313 mH elle 64 mH elle 80 mH

Q: (f) T(s) 100 s(1 + 0.01s)(1+0.001s)

A:

Q: A 2200 resistor is connected in series with the gate of an SCR using basic circuit in figure .The…

A: Given: Resistance, R=2200Ω Current required to fire the Gate, Ig=10mA Taking Vg=0.7V

Q: Find It, I2, I3 using |A Nodal and Cramers rule 852 tilltr 17 pm In On In I₁ los 13A 13 SA R 12V

A:

Q: 15 HP 220 V shunt motor has an armature resistance of 0.07 ohm and shunt a shunt resistance of 200…

A:

Q: MM 452 find vx 1 3 A and Ex √ Ix 25V + GV

A:

Q: det. the total current, IT.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A Thevenin's equivalent circuit has parameters of RTH as 500 and VTH as 15V. If a 40 load is…

A: Given a thevenin equivalent circuit has parameters of, Thevenin resistance, Rth=50 Ω. Thevenin…

Q: Find RL in the network in the figure below in order to achieve maximum power transfer. RL = www 2 ΚΩ…

A:

Q: b. Given RC = 2.2 kn, RF = 120 kn, RE = 1.2 kn, beta = 90, and VCC= 10 V, find Av. Zi, and Zo

A: It is given that: RC=2.2 kΩRF=120 kΩRE=1.2 kΩβ=90VCC=10 V

Q: 60V 200 V₁ M i₁ V₂ 13 12 100 V 3 250 Solve the value of V1, V2, V3, 11, 12, 13

A:

Q: For circuit series and parallel, the supply voltage of, VSupply 240 Volts, R₁= 2002, R₂-300, R3=80,…

A: Given, supply voltage, Vs=240 V value of resistances, R1=20 ΩR2=30 ΩR3=8 ΩR4=30 ΩR5=60 Ω

Q: The dielectric strength of rubber is 40000 V/mm at frequency of 50 Hz. What is the thickness of…

A: Given, Dielectric strength of rubber = 40000 V/mm. Frequency = 50 Hz. Applied voltage = 33 kV.…

Q: Solve for X(s). Hilt V1 Vi R1 1002 C1 0.25FF L1 2H R2 -1002 Vo

A:

Q: For the circuit given below, has values as follows; Vsupply = 120V; R₁ = 3.5KM; R₂ =5000; R3 =…

A:

Q: fluorescent lamp consist of a 10 µF capacitor in parallel with 239 ohms.It is supplied by a 95Vrms,…

A:

Q: QUESTION: DERIVE EXPRESSION VO IN TERMS OF THE INPUT VOLTACES V. HENCE SO THAT 4-BIT A VALUE of…

A:

Q: What is the value of It. V1 -100V R1 1000 C1 0.001FF

A:

Q: A 50 kVA transformer has an efficiency of 98% at full load,0.8 p.f. and 97% at half full-load, 0.8…

A:

Q: Consider a 16-bit digital sensor capable of measuring a range of zero to one volt. Calculate the…

A: Given: Consider a 16 bit digital sensor capable of measuring a range of zero to one volt.    To…

Q: A short 3-phase transmission line connected to a 33kV, 50 Hz generating station at the sending end…

A: Given data: The output power = 10 MW The efficiency, η=96 %=0.96 The frequency, f=50 Hz Vs=333=19.52…

Q: What is the value of inductive reactance, if the phase impedance of a three-phase delta connected…

A: Given: A three phase delta connected system with, Impedance, Z=50 Ω. Resistance, R=25 Ω.

Q: 8-EE) For BSEE. Much like Newton's law of gravity, Coulomb's law states that the force between two…

A:

Q: A charged particle moves with a uniform velocity 1.1 (m/s) in a region where E= 12£ (V/m) and B- Bo…

A: Given: A Charge Particle   E→ = 12Z^ V/mB→ = B0 x^uniform Velocity U→ = 1.1 y^ m/s Velocity of…

Q: A silicon sample is doped with 1022 boron atoms per cm ³. The Hall sample has L = 0.1cm, W = 0.01cm…

A: Given- Length of Hall sample L = 0.1 cm, Width of Hall sample W = 0.01 cm, Depth of Hall sample d =…

Q: The electrostatic force of repulsion between two α-particles of charges 4.0 × 10-¹⁹ C each, and…

A: Given, Charge of each α- particle, Q1 = Q2 = 4×10-19 C Distance between two particles, (R) = 10-10…

Q: The op amp in the circuit in (Figure 1) is ideal. Take R = 80 ΚΩ Figure 6 kQ www 120 mV la 20 kQ ww…

A:

Q: 6) Consider the circuit shown in Figure 1. 2 V 12 V + M R₁ 5 A 12.5 A + 10 VR₂ 41 A 5 V≤R3 15 V ||…

A:

Q: Combinations of transformations: Let x[n] = a^u[n], where a > 1, find and plot z[n] = x [2-2n].

A: We need to find out given sequence and we need to plot the given sequence

Q: Question Two media are characterized as: 1) E, =1,4 =4 and 2) €, =4, L=4 and Where, E E, =relative…

A: Given- For media 1- εr=1, μr=4, σ=0, For media 2- εr=4, μr=4, σ=0, To Find- The ratio of the…

Q: stress test for elite athletes a physical system is used to measure the performance of the…

A: SOLUTION                                     PART_A ANSWER Correct…

Q: A long shunt compound DC generator delivers a load current of 150A at 230V and has armature, series…

A:

Q: node-voltage method

A:

Q: 0.5 JAPAN 2004 6 Collector-Feedback Configuration 27 For the collector-feedback configuration of…

A:

Q: On an energy point of view, discuss why is it advantageous to run induction motors in star  mode…

A: Given: Why is it advantageous to run induction motors in star mode when the load is less than 50%?…

Q: (a) clearly indicate the three terminals on the diagram below with B, E, and C. (b) What minimum…

A: Given: VCE=0.2V  & VBE=0.7V Forward voltage in LED is 2V

Q: ELEMENTARY 4.53. Find (a) L INVERSE LAPL 2-14 (b) -1. (c) 2-1 1 38 +1 48 82 +16

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: In the differential amplifier shown in below figure, R₁ = 10 Kohm, R₂ = 10 Kohm, R₂ = 100 Kohm and R…

A: The given circuit diagram is shown below: It is given that: R1=10 KΩR2=10  KΩR3=100  KΩRf=100  KΩ

Q: 1) What is a diode?

A: A diode is an electronic device.

Q: 6. Determine the value of A and ia in Figure 6 such that vo = 2*vs +9. A ix www + विश्वन 122 in 62…

A: This is a problem of circuit. The detailed solution is given in the next step

Q: The voltage sensitivities of Barium Titanate and Quartz are respectively 12 X 10-3 Vm/N and 50 X…

A: Given- Voltage sensitivities- For Barium Titanate - 12×10-3 Vm/N, For Quartz- 50×10-3 Vm/N,…

Q: A cylindrical rotor generator delivers 0.5 pu power in the steady-state to an infinite bus through a…

A:

Q: 11 The intrinsic impedance of a medium is given by impedance in free space is: Hint: -8.854x10 and…

A: Given data, Permittivity of free space ε0=8.85×10-12 F/m. Permeability of free space μ0=4π×10-7 H/m.…

Q: From the plots, what is the frequency of the input signal (in samples as well as radians)? 2)…

A: The given plots of input signal are shown below: The given plots of input signal are shown below:

Q: Battery TP1 TP4 Switch #1 Lamp #1 TP2 TP5 Statues Battery is dead Switch #2 failed open P Switch #1…

A:

Q: 1 The position error coefficient of a system G (8) = (3+2)(+7) with unity feedback is

A: Given: G(s)=1s+2s+7 H(s)=1

Q: A 3-phase, 50 Hz, 20 km long overhead line supplies 1000 kW at 11kV, 0.8 p.f. lagging. The line…

A:

Q: 1. The voltage across a 20 uF capacitor is vc www capacitor current ic. 5 = 100te V. Determine the

A:

Q: In the following circuit, R = 42, L = 10 mH, Vdc = 12 V, and Calculate the average power for each…

A: It is given that: R=4 ΩL=10 mHVdc=12 VVst=36+30cos4π60t+10cos8π60t

Q: 5. Determine IR₂ and IR3 in the circuit below using current division. IT 22 V R₁ 1.0 ΚΩ R₂ 2.2 ΚΩ…

A:

Q: A 5 PC charge is uniformly distributed over conductive sphere of radius 13cm, the elf Time component…

A: Given data: Q=5 pCRadius, R=13 cm

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.