PLEASE ANSWER ALL THE ITEMS. WILL GIVE YOU THUMBS UP AND GOOD RATING TRUE OR FALSE 1. The specific gravity bottle method can be used for both liquid and solid state. 2. The pycnometer method is the official USP method for determining specific gravity. 3. The density of water at 25 degrees Celsius is 0.9973 g/ml. 4. There are no limitations for miscibility.  5. Matter with a density close to zero will float. 6. Solutions are always clear, transparent and colorless. 7. Substances with a density lesser than 1 g/ml will sink. 8. The Westphal balance is more accurate than the specific gravity bottle method. 9. The buoyant force is less than the weight of the water displaced by the object. 10. All matter has a greater density than zero.  11. Molar concentrations are not temperature-dependent. 12. A substance heavier than water has lower specific gravity

Q: liquid (density= .5 g/mL) spills out of a cylinder vat (radius= 15 ft and depth=20 ft) at 13,500…

A: Density is defined as the mass per unit volume. It is represented by rho . It’s relation with mass…

Q: Imagine your burette contains (3.38x10^1) mL of ion exchange resin and that the ion exchange gel can…

A: A question based on dimensional analysis that is to be accomplished.

Q: 45. Normal temperature again From the measurements of body temperature in Chapter 14, Exercise 29,…

A:

Q: 1.In practice, a graduated cylinder is also used as a TD vessel for volumes of 1ml and below. a.True…

A: Graduated cylinder is used as a TD( to deliver) but not as Tc( to contain) . Specific gravity is…

Q: The density of a liquid was determined by the automatic pipette method. A 100-μL automatic pipette…

A: Density is defined as the mass per unit volume. If the material has higher density, the number of…

Q: In the vapor deposition method, solids are usually converted into solutions using their solvents. *…

A: A question based on general chemistry that is to be accomplished.

Q: The Stoichiometry of Driving and its Environmental impact Lab: In application lab you may…

A: #Q.1: miles per gallon of the vehicle = 14  Required conversion factor is: 1 gallon = 14 miles miles…

Q: 2. Retort Distillation Apparatus usually used to measure water and oil saturation. Analyzing the…

A:

Q: Liquid temperature affects micropipette ACCURACY. Higher liquid temperatures DECREASE volume…

A: ✓Pipetting at a constant temperature can improve accuracy by up to 5 %. Allow time for equilibration…

Q: 1. Using the pictures in the below, record the volumes of water in the graduated cylinders with and…

A: We would read the volumes from each cylinder with and without rock . Then volume of rock is…

Q: FINAL ANSWER INTO THE FOLLOWING: WEIGHT = 4 DECIMAL PLACES VOLUME = 2 DECIMAL PLACES DENSITY,…

A: Calculation of the questions is given below.

Q: Before  Investigating the scene the technician must dilute the luminol solution to a concentration a…

A: Molarity of the solution = 2×10-2M Volume = 2L Moles =?

Q: Part 2: Obtain volume of a marble using volume by water displacement technique. 1. Using the…

A: It is given that the volume of the rock needs to be determined by water displacement method, this…

Q: What will be the volume of the solid if its’ specific gravity is 0.73 and mass is 4.96 grams?  b.)…

A:

Q: A 4.00 (+0.01) mL Class A transfer pipet is used to transfer 4,00 mL of a 0.294 (40.005) M Cu stock…

A:

Q: Density of a Liquid Material A dry 5-ml graduated cylinder weighs 52.2365 g. Into it was poured a…

A: A question based on measurement, which is to be accomplished.

Q: State whether the errors in (a)-(d) are random or systematic. If it is systematic, identify if it is…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Calculate densities in lbm/ft3 of the following substances:(a) a liquid with density of 995 kg/m3.…

A: a) Given that : Density of liquid = 995 kg/m3 Density in lbm/ft3 =? 1lbm/ft3 = 16 kg/m3 Hence, 995…

Q: The torsion prescription balance has a sensitivity requirement of 0.004 g. and an error of not more…

A:

Q: Fill the table and create a publication quality graph of density vs % mass for solutions 5. Fit the…

A: Use the excel to draw the trendline graph- write the value of x and y axis select them , choose…

Q: A graduated cylinder was initially filled to the 7.5-ml mark. A 3.57-gram solid sample was placed in…

A:

Q: I was brewing beer and 5ml of worth (before fementation) weighed 5.3g a .what is the wort’s density?…

A: Density (d) :-  The ratio of mass of substance to volume of the substance is called density  d =…

Q: Which of the following weights would you expect to be suitable for weighing on an ordinary bathroom…

A: Most bathroom scales use pounds (lb) to measure weight.Hence, we will convert each unit to pounds.…

Q: Class A Torsion Balances has a sensitivity requirement of 6 mg with no load on each pan and maintain…

A:

Q: 1-m diameter and 1 fluid whose density me of the fluid in ft3. s of the fluid in Ibm:

A: Given diameter of cylinder = 1m  Height = 1.6m  Density = 850kg/m³  We have to find volume in ft³,…

Q: Six measurements are obtained for the mass of water delivered by a calibrated volumetric pipet:…

A: According to the question, we have six measurements for the mass of water and we need to calculate…

Q: The volume of the solution that can be measured with 5-10 microliter pipette and 2-20 microliter…

A: Volume of solution that is measured using a 20-200 microliter pipette is 0.02 mL to 0.2 mL. Hence,…

Q: 14. You are calibrating a buret that is graduated to 0.1 mL. The measured volume delivered is 25.31…

A: Burette correction is the quantity that must be added algebraically to a particular buret reading to…

Q: Estimated volume of crucible 25.0 mL  measured volume of crucible 23.0 mL  percent error of…

A: Percent error or percentage error expresses as a percentage the difference between an approximate or…

Q: You wait an empty glass filter on the balance and record a way of 12.4361 g. After a 1.00 L sample…

A: The weight of the TSS is calculated as shown below. wTSS=wtotal-wfilter

Q: What's 3 products available on the market where its specific gravity must be measured  with picture…

A: 3 products available on the market where its specific gravity must be measured: 1) Gems (to decide…

Q: of chlörine was 2.0 M, and in Experiment 2 the chlorine concentration the was 6.0 M. Below each line…

A: IMPORTANT POINTS:  This is a third order  reaction which is second order w.r.t to NO and first…

Q: In administering  a mixture of NO2 and O2 by flow meters the target total flow is 14 L/min.  What…

A: Yes, this problem can be simplified.  The question asks us as to what the individual flow rate of…

Q: 3. A cylindrical tank with a diameter of 2.0 meters contains a fluid with a specific gravity of 0.9.…

A:

Q: Volume Measurements (procedure) The small white cup is filled to the lid with water. The volume of…

A:

Q: Two methods were used to measure the arsenic level (ppb) in drinking water. Quantity Mean arsenic…

A: First, we need to calculate the F value and T-value, and compare the standard deviations for the two…

Q: Calculate the total flow for a 35% venture mask set at 10 liters per minute at the flow meter?

A:

Q: Suppose Megan needs to transfer 5.00 mL of a liquid with high precision and accuracy. Which of the…

A:

Q: A 4.00 (±0.01) mL Class A transfer pipet is used to transfer 4.00 mL of a 0.264 (+0.005) M Cu2+…

A:

Q: Date lab performed: Name: Date due: Partner(s) ame Measurements: Density of a Sallne Solution Data:…

A: 10 mL graduated cylinder is most accurate and 100 mL beaker is least accurate. In the 10 mL…

Q: 1000 mL of 0.45% NaCl IV for 3 hours Drop factor: 20 gtt/mL Flow rate: ________ gtt/min

A:

Q: Select the piece of equipment that should be used to carry out the specified task in each example.…

A:

Q: brine solution containing 25.39% NaCl by mass is mixed with a weaker solution containing 1.08% NaCl.…

A:

Q: One hundred grams (100 g) of water is mixed to 150 g of alcohol (density = 790 kg/m3). Calculate the…

A: Specific Gravity(SG)- It is the ratio of the density of a fluid with respect to the density of any…

Q: Mass of a 50 mL dry and empty beaker. Next, use a 10-mL graduated cylinder and transfer 5.0 mL of DI…

A: Given : mass of empty beaker = 29.90 g And mass of beaker + water = 34.96 g

Q: Be sure to answer all parts. Pheromones are compounds secreted by females of many insect species to…

A: Density is the ratio of mass to Volume.By using known unit conversion, the density is calculated.

Q: Answer in not more than 5 sentences per question 1. Discuss the a) direct method of weighing b)…

A: Note: You have uploaded 4 different questions at same time. But i can solve only 1st que As per…

Q: John just started his job as lab assistant at Dr. Vogel's lab. He received a set of p1000, p200, and…

A: Given: In Trial-1: mass of water = 850 mg In Trial-2: mass of water = 849 mg In Trial-3: mass of…

Q: Q)What is used for heating small amounts of solids at a high temperature? a) Mortar and pestle b)…

A: Q)What is used for heating small amounts of solids at a high temperature? a) Mortar and pestle b)…

Q: Estimated volume of crucible 25.0 mL  measured volume of crucible 23.0 mL  percent error of…

A: % error=accepted value-experimental valueaccepted valuex100 %