It is found that the energy required to reduce particles from a mean diameter of 1 inche to 0.3inche is 11 kJ/kg. Estimate the energy requirement to reduce the same particles from a diameter of 0.1 in to 0.01 assuming: (a) Kick's Law, (b) Rittinger's Law, (c) Bond's Equation Comment on your results

Q: error_outlineHomework solutions you need when you need them. Subscribe now.arrow_forward   ...

A: (a)   The schematic diagram for the absorption of NH3 (A) in water (B) from the air in an enclosed t...

Q: The inner and outer radii of a hollow spherical shell are 4 cm and 9 cm respectively. The thermal co...

A: Given information:   Inner radius of the hollow spherical shell, r­i = 4 cm = 0.04 m Outer radius of...

Q: A solution is prepared by mixing 1.0 grams of benzene (C6H6) in 100 g of water to create a solution ...

A: Given:   Mass of benzene (B), mB = 1.0 g Mass of water (W), mW = 100 g Total solution volume, V = 10...

Q: Estimate the diameter of an RDC to extract acetone from a dilute toluene–acetone solution into water...

A:

Q: An 8×8 in test panel, 1 inch thick is placed between two plates, and the whole is properly insulated...

A: Heat transfer is the process of transferring the heat from the higher temperature to the lower tempe...

Q: Approximately how many times louder is a  125-dB  sound than a  65-dB  sound?

A: The intensity of the sound is denoted by Ii. The difference in intensity level is given by:

Q: It takes 15 kWh (kilowatt-hours) of electrical energy to produce 1.0 kg aluminum metal from aluminum...

A: NOTE : 1 Watt = 1 J/s and not 51 J/s  And 1 KWh = 3600 KJ  

Q: reactive chemical disposed of by dilution in a river dissipates at a uniform rate of 0.15 mg/l A per...

A: Given:   The volumetric flow rate of waste being discharged in the river, Qw = 7000000 gallons/day M...

Q: ) Calculate the thermal conductivity for Ne at 300K and 15 mbar pressure. The gas iscontained in cub...

A: Given data: Temperature = 300 K Pressure = 15 mbar The edge of a cubic vessel = 15 cm The temperatur...

Q: A decanter to separate oil from water is needed. The oil flow is 8,500 lb/hr, and the water rate is ...

A: Given:   A decanter to separate oil from water.   The mass flow rate of oil, moil = 8500 lb/h The ma...

Q: Electrolytic manganese dioxide can be prepared from manganese carbonate ore by crushing,milling and ...

A:

Q: Feed to a cooling crystallizer is 2,000 kg/h of 30 wt% Na2SO4 in water at 40oC. This solution is to ...

A: Given data:   Flow rate of feed = 2,000 kg/h Composition of Na2SO4 in the feed = 30 wt% Temperature ...

Q: An aqueous NaOH solution is evaporated at 6 psia. If the solution is 35-wt% NaOH, determine the: (a)...

A: The given NaOH solution evaporates at 6 psia. Thus, the vapor pressure of water is taken as 6 psia. ...

Q: 30.21 The wetted-well column shown in Figure 30.4 is used to humidify a pressurized air stream. Bone...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: Sketch the principle of a hydraulic press. Explain the principle of the amplification of the force. ...

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: To what type of separation operations Kremser method is applicable?

A: The separations where the Kremser method of separation is used is to be stated.

Q: A process is being developed to produce carbonated beverages. As part of this process, a wetted-wall...

A: (a) The maximum possible concentration of dissolved CO2 in water at 2.54 atm CO2 partial pressure is...

Q: Wastewater of 30ft3/s with a biochemical oxygen demand (BOD) of 55mg/l, and dissolved oxygen (DO) of...

A:

Q: Steam at 400 °C and 10,000 kPa flows through a throttle valve. It exists at 1 bar. What is the exit ...

A: Given data:   Initial temperature of the steam (T1) = 400 0C Initial pressure (P1) = 10,000 kPa Pres...

Q: Twenty five liters of hydrogen is produced at a total pressure of 1 atm by the action of acid on met...

A:

Q: While driving down the highway you notice that your speedometer reads 50 miles/hr and 80 km/hr. Whic...

A: The faster speed out of the 2 given options is to be chosen.

Q: A container having a volume of 40 liters contains n-butane at 300oK and 50 bars. As a good productio...

A:

Q: The main trunk duct of air conditioning system is rectangular in cross section (16×30 in) and has ai...

A:

Q: The gas space above the water in a closed tank contains nitrogen at 80oF and 15 psi. The tank has a ...

A:

Q: A bottle of wine contains 12.5% ethanol by volume. The density of ethanol (C2H5OH) is 0.789 g/mL.  C...

A:

Q: While filling up your car with gasoline, you notice that it takes 2 minutes to dispense 15 gallons o...

A: Since the mass flow rate is given by  Mass flow rate = volumetric flow rate X density   

Q: Alcoholic beverages are solutions. Typically, a beer contains about 4.50% (v/v) of ethanol fermented...

A: Given information:   The percentage of ethanol in beer is 4.50% by volume. The percentage of ethanol...

Q: In chromatography, what causes different solutes to pass through the chromatograph with different re...

A: The reason for the residence time of the solutes which are passing through the Chromatograph to be d...

Q: What is the effect upon adding sodium acetate,CH3COONa to and acetic,CH3COOH solution at equilibrium...

A: The equations of the reactions are:

Q: Estimate the theoretical production of landfill gases (CH4, NH3 and CO2) from the degradation of 80 ...

A:

Q: Steam at 1 kg / s mass flow enters a steam isentropic turbine at a pressure of 4 MPa, a temperature ...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: 1. a. With the aid of a diagram showing how the four facets of the environment and briefly discuss i...

A: Note: Since we only answer 1 question, we’ll answer the first question. Please resubmit the other qu...

Q: I have asked this question but it was rejected. I am submitting the problems to check my understandi...

A:

Q: Estimate the specific enthalpy of ethyl alcohol at 1 bar and 200°C, taking the datum temperature as ...

A:

Q: Ethane is contained in a piston/cylinder arrangement at a temperature of 100oC and a pressure of 10 ...

A: The temperature attained by the ethane after passing the cylinder is to be calculated for the given ...

Q: A very thin polymeric coating of thickness 0.1 mmuniformly coats a rectangular surface. The rectangu...

A: Note: Since we only answer 1 question, we’ll answer the first question. Please resubmit the other qu...

Q: The answer should be W~=1900j/mol I have posted this question but can you explain how to get that va...

A: Given information:   Since nothing is mentioned about the behavior of methane gas, assume it to be a...

Q: A roll of aluminum foil from the grocery store is 12 inches wide by 75 feet long (if you unroll it)....

A: Dimensions and density of Aluminium foil Length = 75 ft Width  =12 inch Mass    = 2.8 kg Density= 27...

Q: Wet towels at the Biltmore Hotel are dried in a continuous dryer after washing for use by hotel gues...

A:

Q: ​A stream with a flow of 1.7 m3/s and BOD 3.4 mg/l is saturated with DO (9.27 mg/l at 20oC). It rece...

A: Let ‘S’ represent the stream, ‘E’ be the effluent, and ‘M’ be the mixed stream.   The flow rate of t...

Q: What is the analogical reason between heat transfer by conduction and flow of electricity through oh...

A: The diagram for the composite wall with conductivity ‘k’, thickness ‘t’, and cross-sectional area ‘A...

Q: In Exercise, compute the Laplace transform of the given function from the definition. gl0 = t

A: The Laplace transformation of the given function is to determined.

Q: Estimate sphericities of the following simple particle shapes: (a) a cylindrical needle with a heigh...

A: The solids are handled in the mechanical operations. The sphericity of solid particles is used for t...

Q: A new flash tank is being designed by engineers Musa and Victor. A liquid mixture of p-xylene (X, C8...

A: Let benzene be ‘B’ and p-xylene be ‘X’. The given information for the flash tank is prepared as the ...

Q: Consider the interphase mass-transfer process for the chlorine dioxide, ClO2–air–water system. ClO2 ...

A: Given information:   Interface mass transfer for ClO2 – air-water system   ClO2 gas is species A whi...

Q: THE PROBLEM It has been proposed that commercial manganese ferrite (MnFe2O4) production in Ghana is ...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: Calculate the wavelength of the laser for d = 1/1000 mm. Use the modified “grating equation” given b...

A: For the given laser, the wavelength is to be calculated by using the formula given.

Q: Write an equation for a precipitation reaction and indicate when precipitation is thermodynamically ...

A: Precipitation is a process in which the insoluble salts are formed from the solution and deposit in ...

Q: Fresh orange juice contains 12.0 wt% solids in water, fed to the evaporator to concentrate the orang...

A:

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.