In single phase AC distribution system, the net drop is the sum of the drop in resistance due to the inphase component and in reactance due to quadrature component of current Select one: O True O False

In single phase AC distribution system, the net drop is the sum of the drop in resistance due to the inphase component and in reactance due to quadrature component of current Select one: O True O False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.13MCQ

See similar textbooks

Related questions

Q: (2) (z) Just to make sure as a preliminary question... if the base quantity is XB and the actual…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: An AC three phase distribution system (given in Figure 2), which has end user with balanced three…

Q: A three-phase feeder 1.05 mi, the line-to-line voltage is 11 kV, and the total three-phase power is…

Q: Three-phase System Data: 30 Source Zine 30 Load Source: Ean = 12020° v; Epn = 120 – 120° v; Een =…

A: Given under fallowing fault cases 1) single line to ground, 2) LL, line to line fault, 3) fault…

Q: A single phase transmission line is delivering 410 kVA load at 10 kV. Its resistance is 5.5 ohm and…

A: Given: A single phase transmission line is delivering 410 kVA load at 10 kV. Its resistance is 5.5…

Q: A 6,600V, 1,200 kVA, 3-phase alternator is delivering full load at 0.80 power factor lagging. Its…

A: The solution is given below

Q: 1.The primary conductor in the figure is one phase of a three-phase transmission line operating at…

Q: A single phase transmission line is delivering 490 kVA load at 10 kV. Its resistance is 6.5 Q and…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: In a three phase overhead system , each line is suspended by a string of three insulator. The…

Q: 2.27: 208V, , 3-, 3-wire and CBA-system with Y-load (ZA=60°Q. Z3=630°Q and Zc=5Z45°Q). Find the line…

A: A 3 phase balance star connected system. Sequence of the system CBA. Line to line voltage V=208V…

Q: A single phase transmission line is delivering 450 kVA load at 13 kV. Its resistance is 7 Q and…

Q: In a balanced system, the phasor sum of the line-to-line voltages and the phasor sum of the…

A: In three phase balanced system each phase is displaced by 120 degrees each other. In case of…

Q: The resistance and reactance of the single-phase 60HZ transmission line conductors are 8.2 ohm and…

Q: For a single phase network shown in the figure below, work in per-unit with 200 VA & 250 V as base…

A: In this question we need to find a load current of the given system.

Q: Discuss why: (a) All ac transmission and distribution system are 3 phase system. (b) The…

A: a) All ac transmission and distribution system are 3 phase system because in 3 phase system…

Q: The capacitance between the line to neutral of a three-phase 50 Hz, 66KV overhead line conductors…

A: Frequency is given f = 50 Hz Capacitance is given C=8.3×10-7 Farad/ph/m Capacitive reactance is…

Q: The voltage regulation of a transmission line is negative for lagging power factor. Select one: O…

A: Given Voltage regulator is negative for lagging load True or false

Q: The RL (Resistive and Inductive) Load in the Load Side Section of the Distribution Line Simulator is…

A: This question is based on the load connection in the distribution line simulator. RL load in the…

Q: A load of 135 MW at a power factor of 0.65 lagging can be delivered by a 3-phase transmission line.…

Q: In a three phase overhead system , each line is suspended by a string of three insulator. The…

Q: A single phase transmission line is delivering 470 kVA load at 14 kV. Its resistance is 4 Ω and…

A: A single phase transmission line Output power S=470 kVA load at 14 kV. Transmission line resistance…

Q: Assuming ACB sequence, find the line and phase voltage if Vcn= 30<50 V.

Q: A single phase transmission line is delivering 470 kVA load at 10 kV. Its resistance is 6.5 N and…

A: Receiving end voltage =10kV. Receiving end power factor=0.8 lag Receiving end power=470kVA So…

Q: 470 kVA load at 12 kV. Its resistance is 7 Ω and inductive reactance is 7 Ω if the load power factor…

A: As we have given: S=470 KVAV=12 KVR=7 ΩXL=7 ΩP.F.R=0.9

Q: A single phase transmission line is delivering 490 kVA load at 12 kV. Its resistance is 6 N and…

A: current in transmission line = power delivered to load in KVA voltage in KV. sending end voltage =…

Q: . Calculate the line currents for phase a, b and c. 2. Calculate the line-to-neutral voltages at the…

A: From the given circuit Van = 120 ∠0 V V bn = 120∠-120 V V cn = 120 ∠-240 V R a=R b=R c=…

Q: Find the line and phase voltage if Vcn= 30<50 V. Assuming ACB sequence

Q: A single phase transmission line is delivering 460 kVA load at 11 kV. Its resistance is 4.5 e and…

Q: For same power capacity, the size of the conductor in single phase is lesser than conductor size in…

A: For the same power capacity, the size of the conductor in a single phase is lesser than the…

Q: In a balanced Y-A system the phase voltage is 11kV volts [maximum value], the impedance of each load…

A: In the balance star delta system. Phase voltage Vph = 11kV maximum. Load impedance ZL = 12000+j2400…

Q: A single phase transmission line

Q: A three-phase Y-connected load (6, 8, 10 Ohm) are energized by a balanced Y-connected three-phase…

Q: Q9-b) Sketch the connection of 3-phase source to 3-phase load using 3–phase 4 wire complete with…

Q: A load of 120 MW at a power factor of 0.8 lagging can be delivered by a 3-phase transmission line.…

A: Solution:- Given, PL-3ϕ =120 MW PL-1ϕ = 40 MW Pf = 0.8 lagging VR-1ϕ = 45 × 1033= 25.9807 KV Single…

Q: A single-phase transmission line has a resistance of 0.22 ohm and inductive reactance of 0.36 ohm.…

A: Write the given values. R=0.22 ΩXL=0.36 ΩSR=500 kVAVR=2000 Vpf=0.707 lagging

Q: A three-phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure…

A: Transposed line: It is an arrangement of conductors. In this conductors are periodic changes its…

Q: The RL (Resistive and Inductive) Load in the Load Side Section of the Transmission Line Simulator is…

A: For loading, generally resistor and inductor are connected in series.

Q: EXAMPLE : Estimate the distance over which a load of 15000 KW at p.f=0.8 lagging can be delivered by…

A: The solution can be achieved as follows.

Q: What type of HVDC link is the following configuration? a) Monopolar b) Homopolar c) Bipolar d)…

A: The given HVDC link is shown below:

Q: The resistance and reactance of the single- phase 60HZ transmission line conductors are 7.2 ohm and…

A: inductive reactance=2*π*frequency*inductance. sending end power factor=costan-1sendind end reactive…

Q: A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of…

A: In this question we will find distance between conductors D with given GMD....

Q: What are the types of connections in three phase load, which connection is best? Justify your…

A: Four types of connection we have for three phase transformer- Y-Y- This is used for small, H.V.…

Q: a) Explain mathematically how to covert impedance Z per unit using new MVA and kV bas values. b) A…

A: In this question we will write how we will convert impedance from old MVA and KV to new MVA and…

Q: The resistance and reactance of the single-phase 60HZ transmission line conductors are 5.4 ohm and…

A: Note: As per guidelines will be solving only first 3 subparts. Repost for others For the given data…

Q: A single phase transmission line is delivering 450 kVA load at 14 kV. Its resistance is 5.5 Q and…

A: Sending end voltage Vs = Receiving end voltage + drop in the line Regulation = Vs -VrVr…

Q: Q4/ What is the three phase emf generation and show their two main advantages with type of…

A: Three phase emf generation- A three-phase device has three equivalent voltages or emf of the same…

Q: A 3¢, with VL-L of 34.5 kV, grounded-Way feeder has 556.5 kcmil ACSR with 30-strands AL conductor,…

A: for star connection , phase current = line current . apparent power = 3 ×VL×IL

Q: The conductor of one phase of a three- phase transmission line operating at a line voltage of 324 kV…

A: Given that MVA rating of VT (S) = 930 MVA Primary voltage of VT ,V1 =324 KV CT ratio = 1200/1…

Q: A load of 145 MW at a power factor of 0.8 lagging can be delivered by a 3-phase transmission line.…

Question

Solve it fast plz

In single phase AC distribution system, the net drop is the sum of the drop in resistance due to the inphase component and in
reactance due to quadrature component of current
Select one:
O True
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
in distribution transformers; What is 30 degrees phase shift in delta-star connection? What are the disadvantages? (can you explain with drawing?)
Please help with this balanced three-phase circuit problem.
Two alternators rated 400 MW and 600 MW are operating in parallel. The droopcharacteristics of their governors are 3% and 4% respectively from no loadto full load. Assuming that the alternators are operating at 50 Hz at noload, how would a load of 1000 MW be shared between them? What will be thesystem frequency at this load?
Connect three single-phase transformers in Y-Y, with subtractive polarity, so that the line-to-line voltages on the primary are 30 degrees delayed to their respective line-to-line voltages on the secondary. It should show each step that is needed to make this connection (example: the phasor diagram) and should show the final connection of the three transformers including the polarity markings. Assume phase A on the primary is terminal "H1".
Subject - Design electrical circuits for single phase AC networks Question - Compare the effect of varying resistance, capacitance and inductance in a pararllel and series AC circuits on voltage resistance and impedance.
8. It is the general practice to have the high voltage side lead the low voltage side by the above minimum phase shift. Draw phasor and circuit diagrams to accomplish this requirement for both the Y/A and A/Y connected transformers.
Three single-phase transformers, each rated 10 MVA , 66.4/12.5 kV, 60 Hz , with an equivalent series reactance of 0.1 per unit divided equally between primary and secondary, are connected in a three-phase bank. The high-voltage windings are Y-connected and their terminals are directly connected to a 115-kV three-phase bus. The secondary terminals are all shorted together. Find the currents entering the high-voltage terminals and leaving the low-voltage terminals if the low-voltage windings are (a) Y-connected and (b) Δ- connected.
In single phase AC distribution system, the net drop is the difference of the drop in resistance due to the inphase component and in reactance due to quadrature component of current Select one: True False
Describe the star-delta connection configuration types in three phase transformers and their necessity by drawing and writing. Thank you very much if you answer.
6.5% ans ex A so kvA. 2o00/20 V, So He single-phase transformar has impedance drof of8% and resistance drop of 4%. Caleulate. The Requlation of the Thams former at full- Load o8 P.s Legging. also find The Power factor at which Voltage requlation will Be Zero. Sols 0.5 leading. s alculate The % Noltege Requlation af atransformar in w hich the Percantage resistance drof is 1% and Percentage dre is 6% when The Power fador is 0.8 lagging ) > unity aMS 38 % ans 1 % (シ→ 0.8 leading . amS - 2.2%