In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage isdisplayed on an oscilloscope and the reading is 10 V peak-to-peak. The rms value of this voltage is .What will bethe rms value of this voltage if the frequency is reduced to the half value?3.536 Vrms . 3.536 VrmsO 5 Vrms . 1.7677 VrmsO 3.536 Vrms. 1.7677 VrmsO 5 Vrms . 5 Vrms......O 10 Vrms . 10 Vrms......

Given oscilloscope peak to peak voltage is 10Vp-p at certain frequency. Hence maximum voltage Vm=5V…

In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This v displayed on an oscilloscope and the reading is 10 V peak-to-peak. The rms value of this voltage i .Wha the rms value of this voltage if the frequency is reduced to the half value? O 3.536 Vrms . 3.536 Vrms O 5 Vrms . 1.7677 Vrms O 3.536 Vrms . 1.7677 Vrms .... O 5 Vrms . 5 Vrms ...... 10Vrmo 10Vrmo

In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This v displayed on an oscilloscope and the reading is 10 V peak-to-peak. The rms value of this voltage i .Wha the rms value of this voltage if the frequency is reduced to the half value? O 3.536 Vrms . 3.536 Vrms O 5 Vrms . 1.7677 Vrms O 3.536 Vrms . 1.7677 Vrms .... O 5 Vrms . 5 Vrms ...... 10Vrmo 10Vrmo

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Similar questions

The peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 7 cm and the 'volts/cm' switch is on 35 V/cm. The peak to peak voltage is given by 5.00 V 173.22 V 490.00 V O 122.50 V
The peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 9 cm and the 'volts/cm' switch is on 25 V/cm. The peak voltage is given by O 2.78 V O 159.07 V O 112.50 V O 225.00 V
In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 16 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is doubled? Select one: O 16 Vrms 32 Vrms O 8 Vrms . 8 Vrms ..... O 5.657 Vrms 5.657 Vrms ....... O 8 Vrms . 16 Vrms O 16 Vrms 8 Vrms ......
A double beam oscilloscope displays 2sine waveforms A and B. The time/cm switch is on 100us/cm and the volt/cm switch on 2V/cm. The width of each complete cycle is 5cm for both the waveforms. The height of waveforms A and B are 2cm and 2.5cm respectively. Determine their a) frequency, b) phase difference, and c) peak and r.m.s value of voltages. The difference between the two waveforms is 0.5 cm.
A pure sinusoidal current is being rectified. For the given maximum value of half wave rectified current is 50 A, then the rms value of full wave rectification will be 50 (a) 100 (b) - - (c) 100 A (d) 70.7 A
A sinusoidal waveform is displayed on a C.R.O. screen, the time/cm switch is on 30 µs/cm and the volt/cm switch is on 20 V/cm. The width of one complete cycle is 3.8 cm and the peak to peak distance is 4.8 cm. Determine the following: The frequency is? The magnitude of the sine voltage is? The amplitude is? The R.M.S voltage is?
What is the ripple factor of a DC signal having ripple voltage of 2 V and a DC voltage of 50 V? Answer in percentage % O 8% O 1.2% O 2.83% O 4.0%
Ratio of dc output voltage to rms voltage is a. 0.318 b. 0.637 c. 0.45 d. 0.9
3. A double beam oscilloscope displays 2 sine waveforms A and B. The time/cm switch is on 100us/cm and the volt/cm switch on 2V/cm. The width of each complete cycle is 6 cm for both the waveforms. The height of waveforms A and B are 3 cm and 3.5cm respectively. Determine their a) frequency, b) phase difference, and c) peak and r.m.s value of voltages. The difference between the two waveforms is 0.6 cm.
A double beam oscilloscope displays 2 sine waveforms A and B. The time/cm switch is on 150µs/cm and the volt/cm switch on 5 V/cm. The width of each complete cycle is 8 cm for both the waveforms. The height of waveforms A and B are 5 cm and 4 cm respectively. Determine their a) frequency, b) phase difference, and c) peak and d) r.m.s value of voltages. The difference between the two waveforms is 0.7 cm.
The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak voltage?
Problem 5 Determine the period in ms, frequency in Hz, amplitude in volts, and phase in degrees (vs base cosine signal) of the harmonic voltage signal shown in the figure. Keep 3 significant digits. voltage, V 10 5 -5 -10 36 12 time, ms 24 Question 11 What is the period, T, in ms of the waveform above?