In a hydroelectric power plant, water at 20℃ is supplied to the turbine at 1.2 m3/s through a 200 m long, 0.35 m diameter cast iron pipe. The elevation difference between the free surface of the reservoir and the turbine discharge is 115 m and the combined turbine/generator efficiency is 80%. Disregarding minor losses, determine the electric power output (kW).

In a hydroelectric power plant, water at 20℃ is supplied to the turbine at 1.2 m3/s through a 200 m long, 0.35 m diameter cast iron pipe. The elevation difference between the free surface of the reservoir and the turbine discharge is 115 m and the combined turbine/generator efficiency is 80%. Disregarding minor losses, determine the electric power output (kW).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The water needs of a small farm are to be met by pumping water from a well that can supply water continuously at a rate of 50 L/min. The water level in the well is 13 m below the ground level, and water is to be pumped to the farm by a 2-cm internal diameter pipe. The required length of piping is measured to be 20 m, and the total head loss in the piping system is estimated to be 10 m. a) Using Bernoulli equation, determine the pressure difference between the two points (A & B). b) Taking the efficiency of the pump to be 70 percent, determine the rated power of the pump that needs to be purchased.
include a free body diagram Seawater is to be pumped into a large tank at a rate of 165 kg/min. The tank is opwn to atmostsphere and the water enters the tank from a 80 m height. The overall efficiency of the motor pump unit is 75 percent and the motor consumes electricity at a rate of 3.2 KW. If the irreversible headloss in the piping is 7 m, the velocity of the water (in m/s) at the tank inlet isA. 6.21B. 7.12C. 8.7D. 5.05
Throughof the system that showsof the figure circlesa flow rate of 100L/slight oil(s=0.72), which ispowered by apump it upsupplies apower of 5.0 kW andworks with a85% efficiency.determine the timegauge mmdifferential
on the island, hydropower is expected to be extracted from a river of the river system via a pipe, 74 m long, to a turbine.During the dry season, from February to May the average daily flow rate of the river is 35 m3s-1 and for the remaining 8 months, the average daily flow rate of the water is 115 m3s-1. Assume, the initial capacity expenditure evaluated on a yearly basis of the run of a river system is $900 000, the annual operating cost is $17 500; and the density of water is 1000 kg ∙m-3.Considering the run of the river system above, determine(i) the energy potential at the source for one year,(ii) the levelized cost of electricity, and(iii) compare the LCOE value and the cost of electricity, and comment on the capital investment.
kindly help me with this problems INSTRUCTIONS: Solve the problems neatly and systematically. SUse free-floating decimals in all your calculations and in expressing your answers. Box your final answers. 1. A water from Agno River is pumped using a submerged pump at an efficiency of 78% that is discharged to aswimming pool in Itogon which has a free surface of 30 m above the Agno River water level. The pipe that wasused has a diameter of 7 cm on the suction line and 5 cm on the discharge line from the pump. If the powerrequirement of the pump is 5 kW assuming that the elevation difference between the pump inlet and outletand the effect of the kinetic energy correction factors are negligible, calculate for the followinga) Power requirement by the pump in kWb) Pressure difference across the pumpc) Pumping cost/day(24 hour) if the electricity cost is ₱2.00/kW-hr
How much air is used per kg of coal burnt in a boiler having a chimney of 31.1 m height to create a draught of 19 mm of the water column when the temperature of the flue gases in the chimney is 361 o C and the temperature of the boiler house is 28.4 o C. Also find the equivalent gas head of the chimney.
.Water is stored in a reservoir 5 m deep and 100 m in diameter. It is pumped through a 0.3 m diameter pipeline at a flow rate of 220 L s1, and the pressure drop due to friction is 1.2 Pa/m. The pump is located at the bottom of the reservoir and has a power of 50 kW and is 70% efficient. How high can the liquid be pumped from the surface of the reservoir up a 30° incline?
The pump shown in the figure iswhen pumping water from a lake to a lake aboveIt gives 7.5 kW of energy to the water. your lakesThe elevation difference between the surfaces of 9 m and the loadloss is 4.5 m. under given conditionsa.) The flow through the pipes,b.) The power loss that occurs under these flow conditionsfind it.
4. Water flowing through a tube with a diameter of 10.0 cm has a velocity of 12.5 m/s. The diameter shrinks to only 2.0 cm wide and incurs an increase of density to 1020 kgm3, 2% more than water. Calculate the new velocity of the water under these new conditions. of on chiest
A centrifugal pump is required to handle 50 lit/sec of gasoline against a net pressure of 4 kg/cm², Determine the head in m of liquid and the HP required by the pump, if its overall efficiency is 62%. Take the specific gravity of gasoline as 0.7. (57 and 43) A centrifugal pump draws water from a sump through a vertical 15 cm pipe. The pump has a horizontal discharge pipe 10 cm diameter which is 3.5 m above water level in the sump. While pumping 35 lit/sec, gauges near the pump at entrance and discharge read kg/cm respectively. The discharge gauge is 0.5 m above the suction gauge. Determine the horsepower output of the pump. 0.35 kg/cm and+1.8 (10.82) - To p. edict the performance of a loge centrifugal pump, its model, having р. the following specification, was made: P=24 IIP H=8 m N=925 rpm Diameter of model pump impeller is 9 times smaller than that of the prototype. The prototype pump has to work against a head of 30 m. Find its working speed and HP required to drive it. Determine…
A centrifugal pump is used to pump the water at its temperature in a reservoir with the free water surface located 2 m above the center of the pump inlet to the atmosphere. Piping system in 5ng from tank to pump; It consists of 3 galvanized iron pipes with an internal diameter of 20 cm and an average internal roughness of 0.15 mm. Local ancillary elements above the piping system are years; Sharp edged inlet (Kg-0,85), flanged smooth 3 pieces 90 ° bend -0,3 each thousand and one flanged full open globe valve (KK-8). Find the net positive charge on the usable suction since the minimum volumetric flow is 30 L / s that can be mpaed without cavitation. Evaporation pressure for water at 25 ° temperature: 3.169 kPa) (Standard atmospheric pressure: 101.3 kPa) -997 kg / m3 (-1.05) (dynamic viscosity of water at 25 ° temperature: 8.91.10-kg / ms)
(a) Water flows by gravity from one lake to another as illus- trated; the surface levels of the lakes differ by an eleva- tion of h= 50 ft. If the volumetric flow rate is steady at Q = 80 gallons per minute, what is the associated loss of available energy? (b) A pump is to be installed to pump the water from the lower lake to the upper lake with the same flow rate as above (Q = 80 gpm). If the amount of energy loss is assumed to be the same as in part (a), how much mechanical power must be supplied by the pump? Answer: (a) loss = 1600 ft-lb/slug, (b) Wpump = 2.0 hp