In a gas turbine the compressor takes in air at a temperature of 15°C and compresses it to four times the initial pressure with an isentropic efficiency of 82%. The air is then passes through a heat exchanger heated by the turbine exhaust before reaching the combustion chamber. In the heat exchanger 78% of the available heat is given to the air. The maximum temperature after constant pressure combustion is 600°C, and the efficiency of the turbine is 70%. Neglecting all losses except those mentioned, and assuming the working

In a gas turbine the compressor takes in air at a temperature of 15°C and compresses it to four times the initial pressure with an isentropic efficiency of 82%. The air is then passes through a heat exchanger heated by the turbine exhaust before reaching the combustion chamber. In the heat exchanger 78% of the available heat is given to the air. The maximum temperature after constant pressure combustion is 600°C, and the efficiency of the turbine is 70%. Neglecting all losses except those mentioned, and assuming the working

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A simple Rankine cyele work hetweenpressure 3400 kpaand beahpa,the initialaCanelition of steam belng olry Saferaked.Calculafe the oyche work ratio and speciplensteam frerency, . T下 Consumptione lo00Kp
Exercise We consider an ideal Diesel Cycle whose compression ration The heat transfer to the motor fluid from 18 = Vmin At the start of and the temperature is 15°C~ We the neglect which is assimilated Compression the air pressure Ft to the Narvation of composition of the contents in moles of a perfect = 1.80 MJ.xg diatomic gas (Ideal gos) of mass Determine the pressures Pa as well as the temperatures T2, T3, Tp. WEEng Nmin is 1.00 bar Express temper T₁, T₂, T3, Ty and d. Numerical Application (M = 29 g mul~) Comment on 1-2 reversible adiabatic compression (isentropic) 2 +3 fuel Injection and Combustion 34 reversible adiabatic expansion (isen tropic) Cooling of perfect l' deal) gases. Isochoric erature of this cycle as a function of Imax M = 2.M Please answer the above question step-wise, showing explanations, Including diagrams where nee Decessary. Thanks in adland 3 PA 3 Y 21 Vmin JA Imax PV
A gasoline engine has a volumetric compression ratio of 15 and before compression has air at 300 K, 80 kPa in the cylinder. The combustion peak pressure is 7000 kPa. Assume cold air properties. (a) Sketch and label the P-v and T-s diagrams (b) What is the highest temperature in the cycle? (c) Find the temperature at the beginning of the exhaust (heat rejection) (d) The overall cycle thermal efficiency
Nitrogen at a flow rate of 0.1 kg / s enters a heat exchanger at a temperature of 450 K and 320 It comes out at K temperature. The other fluid of the heat exchanger is water, it enters at 20 ° C and leaves at 35 ° C. a) Calculate the flow of water. b) Calculate the entropy generation in this heat exchanger. (Take the average specific heating heat for nitrogen as 1.042 kJ / kgK.)
Steam enters the high-pressure turbine at 150bar and 550c and low pressure turbine at 40bar and 550c .the condensor pressure is 0.1bar using mollier diagram find 1.the dryness fraction at the end of low pressure turbine 2.efficieny 3.steam rate 4.heat rate 5.work ratio
What is the ideal mass flow rate for a refrigeration and cryogenic plant for oxygen production? Show solution if necessary and reference.
7 A four-cylinder, four-stroke SI engine, having a bore of 10 cm and stroke 9 cm runs at 4000 rpm. The fuel used has a carbon content of 84.50 per cent and hydrogen content of 15.50 per cent by weight. The volumetric efliciency of the engine at Tuế of full thrott l at 4041 lan is 0.85 referred to 300 K and 1 batue ve engine is to pplied we of air coeflicient 0.95 when finning at 75% of full throttle. Calculate the throat diaweter of the vent uri if the air velocity at broat is not to exceed 200 1 rate of fuel flicien kg/s at the pressure drop at venturi o 1at. Discharge coellicient for the venturi is 0,8 and the area ratio of the venturi s 0.8. Take R for air as 0.287 kJ/kg K and for luel vapour is 0.09 kJ/kg K. а mixture iender the above operating conditions. vealculate the lution
please expain to me how can I Calculate the net work done on the gas as it goes around the cyclic path ACDA.
In air handling unit, the 0.8 kg/s of the outlet air at 40C db, 28C wb mix with 2.4 kg/s of the return air at 24C db, 50% RH. The mixture passes through the water cooling coil have surface temperature ADP = 8C. Assume the contact factor of the cooling coil is 80%. Draw the processes on the psychrometric chart, then find: 1. Cooling coil capacity. 2. Quantity of the removed moisture.
A vapour compression refrigerator working with Freon-12 has its temperature range -10°C and 30°C. The Vapour enters the compressor dry and under cooled by 5°C in the condenser. For a capacity of 15 TOR, find: C.O.P Entropy Temp °C 30 -10 Enthalpy hf 64.59 26.87 Hfg 135.03 156.31 ng 199.62 183.19 Sf 0.24 0.108 Sg 0.6853 0.7019
If air enters the adiabatic turbine at 227 degree C and 1500kpa. Final pressure would reach 100kpa, and efficiency of turbine at 85%. What is final temperature and final work? Cv is 0.719kJ/kg.K, cp is 1.007kj/kg.k. Pls sketch two processes of T-S diagram
What is the specific refrigerant that meed for refrigeration and cryogenic plant for liquid oxygen production? (ex. R134a, not a nitrogen answer please)