Answered: (I) If the force F needed to move the…

(I) If the force F needed to move the wire in Fig. 10–34 is 3.4 x 10-3 N, calculate the surface tension Y of the enclosed fluid. Assumel = 0.070 m. %3D

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 57P: Assuming the human body is primarily made of water, estimate the number of molecules in it. (Note...

See similar textbooks

Related questions

Q: Why does the stream of water from a faucet become narrower as it falls (Fig. 10–43)? FIGURE 10-43…

A: According to the principle of continuity, if there is no change in the amount of fluid that is…

Q: A nylon rope used by mountaineers elongates under the weight of a 65.0-kg climber. If the rope is…

A: Given , Weight of climber = 65.0 kg length of rope = 45.0 m Diameter = 8.00…

Q: A copper (Cu) weight is placed on top of a 0.40-kg block of wood (density = 0.60 × 10° kg/m³)…

A: The expression for the force in the given situation will be,

Q: (10.53) Water at a gauge pressure of 3.8 atm at street level flows into an office building at a…

A: By equation of continuity, A1V1 =A2V2 πd2/4V1 = πd2/4V2 V2 =V1(d1∧2/(d2∧2)…

Q: For safety in climbing, a mountaineer uses a nylon rope that is 50. m long and 1.0 cm in diameter.…

Q: What is absolutely viscosity?

Q: The lever in Fig. has a weight W at one end and is tiedto a cylinder at the left end. The cylinder…

A: Given :- W=20NL1=75x10-2mL2=50x10-2mD=10x10-2mL=22x10-2mOR=1mmTg=20∘CFrom databook glycerin at…

Q: Viscosity in liquids, decrease by increasing the temperature. Ture or False

Q: When pushing off horizontally from a pool wall with her legs, the resulting force of the wall on the…

A: compression in length (∆L) = 2.98×10-5 m Length (L) = 36 cm = 0.36 m Radius (r) = 1.82 cm = 0.0182 m…

Q: A spherical ball contracts in volume by 0.0098% when it is subjected to a pressure of 100 atmosphere…

A: The expression for the Bulk modulus is,

Q: A drinking fountain shoots water about 12 cm up in the air from a nozzle of diameter 0.60 cm (Fig.…

Q: A man lifts a 100 N can of oil by pressing his two hands against the smooth sides, toward each…

A: given data, weight of oil , W = 100 N coefficient of static friction , μ = 0.3

Q: There is an issue with the toilets at school. If the water is coming out at 5.0 m/s, how much water…

A: Velocity of water coming out (v) = 5 m/s Mass of person (m) = 95kg

Q: A three-legged wooden bar stool made out of solid Douglas fir has legs that are 2.0 cm in diameter.…

Q: A piece of metal has a specific gravity of 2.80. When placed in a graduated cylinder, it displaced…

Q: As an oil well is drilled, each new section of drill pipe supports its own weight and that of the…

Q: If 20 kN load is applied on a cylinder of diameter 20 mm, the stress developed in the cylinder is

A: Force = 20 KN = 20000 N Radius = 10 mm = 0.010 m AREA = πr2 = 3.14 x 0.0102 = 3.14 x 10-4 m2 Stress…

Q: Why can a person lay on a bed of nails and not get hurt, but would get hurt if they stand on nails?

Q: pipe 6-77 Water is flowing into and discharging from U-section as shown in Fig. P6-77. At flange…

A: Let m denotes the mass flow rate, A denotes the area of the opening, P denotes the pressure and ρ…

Q: Only with great difficulty can you crush an egg when squeezing it along its long axis, but it breaks…

A: The ends of an egg form arches. Therefore, pressing them together along the long axis will only…

Q: A cube of unknown material is 0.200 m on each side and has a mass of 17.6 kg. It is suspended in a…

Q: Coffee runs up into a lump of sugar when one corner is held in the liquid. Why?

A: It is due to the fact that sugar lump has many tiny holes in it.

Q: When blood pressure is measured, why must the arm cuffbe held at the level of the heart?

A: We have to give the reason for keeping the arm cuff at the level of the heart while testing the…

Q: For safety in climbing, a mountaineer uses a nylon rope that is 50. m long and 1.0 cm in diameter.…

A: Young’s modulus is given by,

Q: A man weight 200lb at one particular moment when he walks, his right heel is the only part of his…

Q: For safety in climbing, a mountaineer uses a nylon rope that is 50 m long and 1.0 cm in diameter.…

Q: For safety in climbing, a mountaineer uses a nylon rope that is 63 m long and 100-kg climber, the…

A: Given:- The length of the rope L = 63 m The diameter of the rope is d = 1.2 cm The mass of climber…

Q: A metal bar’s dimensions are 1 in x 2 in. If the bar has a modulus of elasticity of 4.14x10^9 Pa,…

A: Given Initial lenth is 15 in Final lenth = 15.25 in Dimensions = 1*2 in E = 4.14*10⁹ pa concept…

Q: Determine the force P required to maintain the 210-kg engine in the position for which = 20°. The…

Q: A moonshiner makes the error of filling a glass jar to the brim and capping it tightly. The…

A: The expression for find force exerted by moonshine is K=FA∆VV0FA=K∆VV0 Substitute values in the…

Q: (II) A house at the bottom of a hill is fed by a full tank of water 6.0 m deep and connected to the…

A: The height of water level of full tank,WL = 6.0 m. Assume the vertical height between the base of…

Q: A solid cylindrical bar, of 20 mm diameter and 180 mm long, is welded to a hollow tube of 20 mm…

A: Given data as per question Diameter of solid bar =20 mm Length of solid bar =180 mm Internal…

Q: A piston of cross-sectional area “a" is used in a hydraulic press to Exert a small force of…

Q: A moonshiner makes the error of filling a glass jar to the brim and capping it tightly. The…

A: Given data The increment of the volume is: ∆vv∘=4 × 10-3 The magnitude of the bulk modulus is given…

Q: If an empty cylinder is half filled with a liquid, its center of gravity is: A) shifted upwards…

A: Center of gravity is known as the point of the object where weight is evenly dispersed means all…

Q: A cube of wood floating in water supports a 200-g mass resting on the center of its top face. When…

Q: How do jogging on soft ground and wearing padded shoes reduce the pressures to which the feet and…

A: jogging on a soft ground with padded shoes

Q: The elastic limit of brass is 379 MPa. Wha should be the minimum diameter of a bra rod if it is to…

A: GivenMximum stress ,σmax=379 Mpa=379×106 PaLoad ,P=400 N

Q: A metallic cube of side 125cm is subjected to a uniform force acting normal to the whole surface of…

Q: (II) Water and then oil (which don't mix) are poured into a U-shaped tube, open at both ends. They…

Q: (I) Estimate the pressure exerted on a floor by (a) one pointed heel of area = 0.45 cm², and (b) one…

A: (a) The pressure exerted by the force acting on the floor is, P=FA=mgA=56 kg9.8 m/s20.45 cm20.0001…

Q: tring on a tennis racket is under a tension of 275 N. If its diameter is 1.00 mm, by how much is it…

A: The force is 275 N. The diameter is 1.0 mm or 0.001 m and the radius is half the dimeter so radius…

Question

(I) If the force F needed to move the wire in Fig. 10–34 is
3.4 x 10-3 N, calculate the surface tension Y of the enclosed
fluid. Assumel = 0.070 m.
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

(I) Solar cells (Fig. 15–26) can produce about 40 W of elec- tricity per square meter of surface area if directly facing the Sun. How large an area is required to supply the needs of a house that requires 24 kWh/day? Would this fit on the roof of an average house? (Assume the Sun shines about 9h/day.) FIGURE 15-26 Problem 53.
(II) When a diver jumps into the ocean, water leaks into the gap region between the diver’s skin and her wetsuit, forming a water layer about 0.5 mm thick. Assuming the total surface area of the wetsuit covering the diver is about 1.0m2 and that ocean water enters the suit at 10°C and iswarmed by the diver to skin temperature of 35°C, estimate how much energy (in units of candy bars = 300 kcal ) is required by this heating process.
(II) A small immersion heater is rated at 375 W. Estimatehow long it will take to heat a cup of soup (assume this is250 mL of water) from 15°C to 75°C.
(III) Approximately how long should it take 8.2 kg of ice at 0°C to melt when it is placed in a carefully sealed Styrofoam ice chest of dimensions 25cmx 35cm x55 cm whose walls are 1.5 cm thick? Assume that the conductivity of Styrofoam is double that of air and that the outside temperature is 34°C.
(I) What speed would a 1.0-g paper clip have if it had thesame kinetic energy as a molecule at 22°C?
(II) How long does it take a 750-W coffeepot to bring to aboil 0.75 L of water initially at 11°C? Assume that the partof the pot which is heated with the water is made of 280 gof aluminum, and that no water boils away.
(I) A concrete highway is built of slabs 12 m long (15°C).How wide should the expansion cracks between the slabs be(at 15°C) to prevent buckling if the range of temperature -–30°Cis to +50°C
(II) The rms speed of molecules in a gas at 20.0°C is to beincreased by 4.0%. To what temperature must it be raised?
(II) The lowest pressure attainable using the best availablevacuum techniques is about 10-12 N/m2 At such a pressure,how many molecules are there per cm3 at 0°C?
(II) Samples of copper, aluminum, and water experience thesame temperature rise when they absorb the same amount ofheat. What is the ratio of their masses? [Hint: See Table 14–1.]
(I) Calculate the number of molecules /m3 in an ideal gas at STP
(II) If 16.00 mol of helium gas is at 10.0°C and a gaugepressure of 0.350 atm, calculate (a) the volume of thehelium gas under these conditions, and (b) the temperatureif the gas is compressed to precisely half the volume at agauge pressure of 1.00 atm