Given figure shows a unity feedback system. The ratio of time constantsfor open loop and closed loop response areR(s)2S+4O 3:2O 1:12:1O 2:3Which of the following transfer function will have the greatest maximumovershoot?O 36/(s^2+2s+36)25/(s^2+2s+25)16/(s*2+2s+16)O 9/(s*2+2s+9)

Since there are multiple questions present, according to company policy we will be answering only…

Answered: Given figure shows a unity feedback…

Engineering

Electrical Engineering

Given figure shows a unity feedback system. The ratio of time constants for open loop and closed loop response are

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The closed-loop transfer function of a negative unity feedback system is given by

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: A unity feedback system is shown in Figure Q1.1. The root locus of this system is depicted in Figure…

Q: In a feedback system, the basic amplifier open-loop low frequency gain is 400k and the open loop 3…

A: An operational amplifier is termed as an op-amp. Two inputs, a negative and a positive input is…

Q: What is the effect of velocity feedback in close loop system? How velocity feedback effect the…

A: 1) The effect of velocity feedback in close loop system is as follows: - The streamlining of a speed…

Q: feedback system root locus graph shown in figure below. On the edge of stability, the gain K =

A: According to question: The open loop transfer function of the given system is calculated as…

Q: Q2) Consider the following feedback system outlined in Figure Q2 Plant R(s) 10 1 C(s) S+ 1 Ky Figure…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: Sketch the root locus for the unity feedback system shownin Figure P8.3 forthe followingtransfer…

A: TRANSFER FUNCTION : A system, sub-system, or component's transfer function (also known as system…

Q: CP6.8 Consider the feedback control system in Figure CP6.8 D. (a) Using the Routh-Hurwitz method,…

A: Given a non-unity feedback system: G=5s(s+10) , H=2+K1s a) Using Routh-Hertwiz criteria we need to…

Q: What is closed loop gain?

A: Closed loop gain: To achieve stable operation, op-amps are used in negative feedback. Gain of an…

Q: Compare feedback control and feedforward in terms of advantages and disadvantages

A: Feedback control system is a close loop control system. Output depends upon feedback signal.…

Q: Explain through diagrams the four methods through which we can connect our negative feedback…

A: The fallowing are the four methods through which we can connect our negative feedback circuit:

Q: Q1 Simplify the block diagram shown in the following figure and obtain the closed loop transfer…

Q: Given the uncompensated unity feedback system in Figure 8 below.

Q: Explain how the Nyquist stability criterion can be used to determine the stability of a closed-loop…

A: Given data:

Q: find Given the unity feedback system shown in figure he range of K that keeps the system stable.…

Q: A feedback system signal flow graph diagram shown in figure below. The number of the forward path is…

Q: (a) Give a component block-diagram for a practical temperature feedback system. kplain how the…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 2) Given the unity feedback system in the figure below: R(s) + E(s) C{s) G(s) Figure 2: Unity…

Q: A feedback system signal flow graph diagram shown in figure below. The number of two nontouching…

A: Given : In the given question they have mentioned the signal flow graph. From the given signal…

Q: 4. Consider the system block diagram shown below Vout A Vin What type of feedback system is…

A: 4 ) Given diagram :

Q: R(s) + 50 C(s) s+1 a) Represent the system in a standard unity-feedback control structure and using…

Q: Given figure shows a unity feedback system. The ratio o time constants for open loop and closed loop…

Q: What is positive feedback system?

A: The positive feedback system is a kind of the close loop system, where the output of the system is…

Q: 3)A unity feedback system is given below. Determine the gain K, so that the system will have a…

A: Note :- Here 2% criteria mentioned, it is not graded or marks. It is 2% tolerance for settling…

Q: Define, in words, sensitivity and describe the goal of feedback control system engineering as it…

Q: 1. Discuss the advantages and disadvantages of negative feedback system in details. Elaborate each…

A: The explanation is as follows.

Q: the unity feedback system given below, the damping ratio of the closed loop poles is given by a)…

Q: Q4 (a) The Nyquist stability criterion can be used to determine the stability of a closed- loop…

A: Control systems are represented by a transfer function. This can be written in both time domain and…

Q: Q2: Determine the stable range of the parameter (a) for the closed-loop unity feedback systems with…

Q: 2-Discuss briefly the effect of both types of feedback on input and output impedance

A: Brief description : Depending upon the application of the feedback we need to derive input and…

Q: 5) Explain the working diagram. characteristics equation for feedback control Es? + 12s + K = 0.…

A: Note : We are authorized to answer one question at a time, since you have not mentioned which…

Q: Discuss the effect of changing the value of the feedback resistor on the output voltage

Q: Consider the unity feedback system which employs rate feedback as shown in the figure. R 1 C K s(s +…

Q: Routh Hurwitz analysis of closed loop system with variable gain.

Q: Draw and label the block diagram of the feedback system which consist of reference signal, actuating…

A: Here, we have to draw a block diagram for the feedback system. We know that the feedback system is…

Q: An open loop Transfer function of unity feedback system is given by G(s)= 1/(s+2)^2 The closed…

A: Given, Open loop transfer function, G(s)=1s+22 Unity feedback system, H(s)=1

Q: Q.8 Open loop pole/zero plot of a unity feedback system are shown in figure below. Determine maximum…

A: Pole Zero graph is given as:

Q: A unit feedback system has (see picture below) If subjected to unit step input, determine: a) Damped…

Q: 5.Consider the feedback system shown in figure. Determine system parameters (a, K, z, p, Ko) to…

Q: Consider the unity feedback system which employs rate feedback as shown in the figure. R 1 K s(s+ a)…

Q: Consider the unity feedback system shown with proportional controller and find the angles of…

Q: A feedback system root locus graph shown in figure below. The system is type... ....

A: The given root locus is:

Q: 5. (a) Using the feedback system given as following figure, answer the following questions: 2K (s+…

Q: How does a positive feedback loop differ from a negative feedback loop?

A: Negative feedback : Negative feedback is used to increase the stability of the system . Noise…

Question

Given figure shows a unity feedback system. The ratio of time constants
for open loop and closed loop response are
R(s)
2
S+4
O 3:2
O 1:1
2:1
O 2:3
Which of the following transfer function will have the greatest maximum
overshoot?
O 36/(s^2+2s+36)
25/(s^2+2s+25)
16/(s*2+2s+16)
O 9/(s*2+2s+9)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A feedback system root locus graph shown in figure below. On the edge of stability, K= Root Locus 15 12 6. -9 -12 -15 -17 -15.3-13.6-11.9-10.2 -8.5 -6.8 -5.1-3.4 -1.7 0 1.7 3.4 5.1 6.8 8.5 10 Real Axis (seconds") Imaginary Axis (seconds)
HG(s) = QUESTION 6 s²+4s+5 Consider the root locus of a unity feedback system that has the open loop transfer function shown below. Find the break point. K(s+1) ² $3 HG(s) = AKI a... bmit. Click Save All Answers to save all answers.
seels e A unity feedback system has G(s) as shown below in figure, what is the range K for * ?stability K(1+0.25)(1 +0.0255) () = 51+ 0.001 ) + 0,005 5) 600
A unity feedback system has a forward path transfer function G(s)=16/(s2+8s). Find the value of delat time , rise time, percentage overshoot, peak time and settling time.
A feedback system signal flow graph diagram shown in figure below. The number of the forward path is -H2 GA )s(ر مل G3 G7 R1(s)< -1-1 G8 G6 G2 R2(s).
Consider the following feedback amplifier circuit. Assume lambda= 0, VDD RD2 R01 VinM₁ M₂ -Vout Select one: O a. none of these R₂ the open loop input resistance RinoL and the closed loop input resistances RincLare respectively: O b. RinoL = 1/gm and RincL= 1/gm(1+kA1) O C. RinoL = ∞o and Rincl= (1+ KA1) d. RinoLand RinCL = 00
An open loop system has a zero at -15 and poles at -3,-5 and -6. For a gain of 150, calculate the exact 180 degree frequency.
10- A unity feedback system has open-loop transfer function G(s)=2/ (S+4), the ratio of time constants of open-loop to closed loop response will be: a- 1:1 b-2:1 c- 3:2 d-2:3 11-First column elements of the Routh's tabulation are 3, 5,-0.75, 0.5,2. It means that there: a- is one root in the left half of s-plane b- are two roots in the left half of s-plane c- are two roots in the right half of s-plane d- is one root in the right half of s-plane 12-An effect of phase-lag compensation on system performance is that: a-for a given relative stability, the velocity error constant is increased b- for a given relative stability, the velocity error constant is decreased c- the bandwidth of the system is increased d- the time response is made faster 13-The phase lead compensation is used to: a- increase rise time and decrease overshoot b- decrease both rise time and overshoot c- increase both rise time and overshoot d-decrease rise time and increase overshoot 14-When phase-lag compensation is…
Q-4. How many op-amps are required to implement this equation? V1+ R2 V. =- A) 3 B) 4 C) 2 D) 1 Q- 5. For the following feedback circuit. Identify the type of feedback and find the closed loop gain. E A ► VOUT
An open loop system has a zero at -15 and poles at -3,-5 and -8. For a gain of 150, calculate the exact 0dB frequency
YOu are attempting question 2 out of 12 Consider the open loop transfer function of unity feedback system: K G(s) = ,t, 0.5 sec and =0.4 for dominant poles of closed %3D %3D s² +20s +101)( s+20) loop system. What is the compensator zero when pole is at -15. Answer Choices: a. z = -1 b. z = 0.0685 C. Z = 0.685 d. z=1.0685 Answer A D Submit fg fg 144 f6 4+ f5 & 7 % CO %24
Given figure shows a unity feedback system. The ratio of time constants for open loop and closed loop response are 2. S+4 (s) (s)) O 2:1 O 1:1 O 3:2 O 2:3