Given an AC source having a voltage v(t)=14sin(158t + 16°) V, find the votage at t=130ms
Q: R L 3. Find the expression for the instantaneous values of the voltages across the resistance (VR),…
A: Given circuit, Where, i(t)=414sin2πft Af=50 HzR=100 ΩL=0.31831 H
Q: 4. Use the node voltage method to find the steady state expression v.(t) in the circuit below if Vg1…
A:
Q: The current and voltage in an AC circuit is given by v=120 sin (377t) V and i=5 sin (377t+90°) A¸…
A:
Q: A current of i(t) = 0.49 cos (18 t-57°) A is applied to an inductor L = 4 mH as shown. What is the…
A: The magnitude of phasor always represent in RMS value.
Q: Given an AC source having a voltage v(t)=18sin(173t + 30°) V, find the votage at t=130ms.
A: Substitute t= 0.13 sec in v(t) to find V(t) at t = 10m seconds .
Q: Calculate the voltage v,(t) using the Phasor Domain. (Do not forget to add the mutual effects). 2H>.…
A:
Q: (b) An AC circuits with 50 Hz voltage of 240V effective value is impressed on an inductance of…
A:
Q: Given an AC source having a voltage v(t)=5sin(178t + 43°) V, find the frequency of the voltage…
A:
Q: Given an AC source having a voltage v(t)=27sin(249t + 15°) V, find the period of the voltage…
A: Given sine wave equation is, Vt=27sin249t+15° V Consider the general form of the sine wave is,…
Q: Use phasor techniques to solve for the voltage v(t) shown in figure below. 10 cos 21 A 303 3H 1/3 F)
A: Considering the current source as the reference point for the phasor:
Q: Question No. 4: For the below circuit, assume that: V:(t) = 20 sin(wt+30°) V2(t) = 10 cos(wt+30°)…
A: In this question, Voltage equations are given. Write the phasor representation of the given…
Q: Understand ac power concepts, their relationships to one another, and how to calculate them in a…
A:
Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 95.34-ohm resistor,…
A:
Q: The current source in the circuit is given by v, (t) = 10 sin(2t + 30)V. Apply the phasor-domain…
A: In this question we will find voltage across inductor using phasor domain analysis technique...
Q: In a single graph, sketch v=100 cos(ωt+ϕ) versus ωt for ϕ=−60∘, −30∘, 0∘, 30∘, and 60∘.1. State…
A: (a) Referring to the given signal, the graph of the function with respect to the frequency component…
Q: v = 150/2 sin 500 t V 1 kQ2 ΚΩ L For the AC circuit as shown above if the
A: Given data, RMS voltage across resistor VR=120 V Given circuit diagram is,
Q: In the circuit shown in Figure 1, the source is V1=10 sin ( @t) V where @ = 2n x 200 rad/s. If the…
A:
Q: Using phasors, determine i(t) in the following equations: (a) 24 + 3í(1) = 4 cos(21 – 45°) di (b) 10…
A: Please refer the attached images for the complete answer..
Q: If the voltage v(t) 24 cos (377t + 75°) V is applied to a 6 Q resistor, %3D determine the a) phasor…
A: Given R = 6 ohm v(t) = 24 cos (377t + 75°) V a) phasor voltage = ? b) phasor current= ? c)…
Q: Figure Q2(b) shows the time domain circuit with the voltage source, v,(t) is 25 cos 100t V. The…
A: The solution is given below
Q: Graph in the complex plane and represent in the form x + iy: 15. 3 (cos 7 - i sin 7) 17. V8 (cos i7…
A:
Q: 20 1 mF is(t) v(t) L, 3 10 mH L23 2 mH
A: Phasor form
Q: 2. Find i,(t) if v,(t) = -20 sin(25t – 30°) V %3D
A: It is given that: Vst=-20sin25t-30° V
Q: Given an AC source having a voltage v(t)=28sin(305t + 30°) V, find the frequency of the voltage…
A: we need to find out frequency of the voltage waveform.
Q: i(t) 4 cos (100r – 20°) A( 1 mF 20 mH
A:
Q: Q-3 For the following pairs of voltages and currents, indicate whether the element involved is a…
A: In the question, Find the element of the given voltage and current equation. We are solving this…
Q: Alternating Current In Europe, the voltage of the alternating current coming through an electrical…
A: Here the value of voltage is given as v=-30sin(100πt) ..............(1) V is measured in volts ant t…
Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…
A: Given data, V=240 V, R=100 Ω, L=100 mH, C=100 μF, f=50 Hz Given circuit diagram,
Q: 21 Given the equation, ve = 42.1 V sine, What is the value of Vrms? O %3D 42.1 V 84.2 V 59.54 V…
A: In this question we need to choose a correct option
Q: L L= 40 mH %3D Nout Vin E R =125.6 Vin (+)= 3+ G0 cos (20 Tt+ 15) %3D + 40 sin (2000 TTt- 30) Find…
A: Let X and Y be two impedance connected in series and output is obtained across Y then according to…
Q: The voltage and current of an element are i(t) = 3.cos(1000t + 10°) V(t) = 6.cos(1000t – 80°) The…
A:
Q: 20. Consider the voltage phasor diagram of an AC circuit shown below. What is the value of the…
A: The solution is given below
Q: Electrical AC circuit is given in Fig.2. Please derive the expression of the equivalent impedance…
A: This problem belongs to circuit theory. It is based on the concept of capacitive and inductive…
Q: If a phasor representation of a current is given by I = 70.7 ∠45° A, it is equivalent to
A:
Q: The voltage and current of an element are i(t) = 3.cos(1000t + 10°) V(t) = 6.cos(1000t-80°) The…
A:
Q: An AC supply voltage is represented by v = 325 Sin wt. Three loads are connected in parallel across…
A:
Q: B: Find the waveform of the voltage V(t) in the circuit shown below given that: e(t)-2.5 sin(500t)…
A: The circuit is as shown below, Given, e(t) = 2.5sin(500t), i(t) = 1.414cos(1000t),
Q: If v,(t) = –10 sin(@t – 30°) V and v½(t) = 20 cos(wt + 45°) V, find v(t) = v;(t) + v½(t) %3D
A:
Q: Given the current i1(t) = 10 sin (20t), the corresponding phasor equivalent I1 is
A: Phasor equivalent contains magnitude in RMS and phase of the signal.
Q: A transmission line has a capacitance of 25 pF / ft. and an inductance of 0.15 µh / ft. Determine…
A:
Q: 1.) In a linear circuit, the voltage source is us = 12 sin(10°t+ 24)V (a) What is the angular…
A:
Q: Using a phasor graph find the voltage u(t) Exercise 2 İL(t) L the Given: i¿(t) = 5/2 sin(æx) A R =…
A: The current through inductor in phasor form is written as iL(t)=5*22∠0°=5∠0°A The inductive and…
Q: Find I,, It, Is, In, Is & Power at (lov) SourCe lov In
A: Given circuit shown
Q: 4 kn 10 kn -W- 2.5 nF 80 mH V, (t) Vs(t)=125cos(5,000t+15)mV 300 n 30 kn
A: From the Non Inverting OP-AMP
Q: Find the response of the system x,(t) if you know : x(t) = 10sin( wt + 60' ) = x,(t)+ x, (t) Where:…
A:
Q: b.) Given the following voltage and current: v(t) = 10 cos(377t + 30º) V i(t) = 5 sin(377t – 20º) A…
A:
Q: 7 Find the phasor form of the following functions: a. v(t) = 155 cos (377t – 25°) V b. v(t) = 5 sin…
A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…
Q: 5 cos 400t A V1 2 5 mH 1/800 F -(¹/8)U1
A: Average power: Average power is the total useful power of the circuit that is utilized by the ac…
Q: t= 0 Z, = 502 Vg=120V v, = 10°m/s 100m Determine R_ if V(t=3.8 µs, 1= 50m) = 62 (V).
A:
Q: Use the T-equivalent circuit for the magnetically coupled coils shown in Fig below to find the…
A: In this question, We need to determine the current I1 and I2 as shown in the circuit. Both circuit…
Q: Given the sinusoids v1(t) = 8cos (250t +15°) V and v2(t) = 6cos (250t – 45°) V, determine the time…
A: In this question we will find the time by which v2(t) is advanced or delayed with respect to…
Q: For the component shown with the given voltage and current reference directions, the voltage across…
A: Given:
Q: 4. Many engineers are working to develop photovoltaic power plants that provide ac power. A model of…
A: Average of the instantaneous power in one cycle is called average power. The complex power is…
Q: Consider the circuit shown below. 1) Determine the coupling coefficient 2) Calculate the energy…
A:
Q: The phasor current I, is 5445° A. 1. Find Ia. Ies and Vg. 2. If w = 800 rads/s, write the…
A:
Q: H.w/ Use the T-equivalent circuit for the magnetically coupled coils shown in Fig below to find the…
A: In this question, Use the T equivalent circuit for the magnetically coupled coils as shown in the…
Given an AC source having a voltage v(t)=14sin(158t + 16°) V, find the votage at t=130ms
Step by step
Solved in 2 steps with 2 images
- If the voltage and current in an AC circuit are given by v- 200 sin(wt+30) and i= 10 sin(wt-60) then the pf of the circuit is pf -The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the angular frequency of the ac source? What is the period of ac source? What is the circuit impedance? What is the power factor? What is the real power of the circuit? What is the rms value of the circuit current?an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf capacitor are connected in series. If the voltage connected to the circuit is 440v. How many degrees are the voltage and current out of phase with each other?
- An AC voltage sourced is connected to a series R= 250 ohm, L= 0.15H. The source has angular frequency of 600 rad/s. The voltage amplitude VL = 500V, what is the voltage amplitude for the source?Solve the following electric circuit given in the following figure by using echlon or reduced echlon form You may use KVL & KCL to form linear equations involving i1, i2, is 20 2 10 2 Q 80 V, 102 90 V P 152If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit be? Explain why. a) a pure resistor circuit b) a series or parallel R-L circuit c) a series or parallel R-C circuit d) a series L-C circuit
- The current through a 220 μF capacitor is given below. Use Ohm’s Law to find the voltage. Convert to polar form, find the impedance and complete the math, then convert back to the waveform at i1 = 1.5sin(2500t + 30°) mA and i2 = 4.7sin(200t – 40°) mADetermine the mesh currents I1 and I2 in phasor formA series resistance - capacitance ( R-C ) circuit is connected to a 230V, 60 - cycle source. If the power taken by the circuit is 4, 800W and the voltage drop across the resistor is 115V.Calculate the capacitance of the capacitor. 600.36 microfarad 1,500.05 microfarad 556.096 microfarad 250.94 microfarad
- WWW An Ac circuit with a Power Source has a resistor and an inductor connected in paralle!. The values are as follows: V=194 R = 104 XL = 81 What is the power factor? *****H.W 2 An AC circuit includes two sections AB and BC in series. The section AB consists of two branches in parallel. The first of these is formed of resistance of 60 2 in series with a capacitor of 50 mF, while the second consists of a resistance of 60 2 having an inductance of 250 mH. The section BC consists of a resistance of 100 N having an inductance of 300 mH. The frequency of the current is 50 Hz. The voltage across section AB is 500 V. What is the voltage across the section BC?write the phasor equivalents