For the emitter follower in Fig. P7.135, the signal source is directly coupled to the transistor base. If the dc component of vsig is zero, find the dc emitter current. Assume β =100. Neglecting ro, find Rin, the voltage gain vo/vsig, the current gain io/ii, and the output resistance Rout.

Q: A 4-pole, simplex lap wound armature when driven at 600 rpm generates 120 V. If the flux per pole is...

A: In this question we need to find a number of armature conductor.

Q: Given a parallel plate capacitor where the medium between the 2 plates is pure vacuum, the cross sec...

A: We need to find capacitance and charge and flux density for given capacitor

Q: Calculate the value of current I1 and I2

A:    

Q: A hypothetical isotropic antenna is radiating in free-space. At a distance of 100 m from the antenna...

A:

Q: A 2-wire d.c. distributor 129 m long is uniformly loaded with 1.4 A/m. Resistance of single wire is ...

A:

Q: A 110-V rms, 60-Hz source is applied to a load impedance Z. The apparent power entering the load is ...

A:

Q: iii. A 4- pole 50 Hz turbo generator supplying 50% of its maximum power capability to 0.6 pu load. T...

A: power developed in synchronous motor=PMax×sinδwhere δ is power angle in electrical degrees Mechanica...

Q: Points A and G are located at (-1,2,1) and (2,1,1), respectively. a. Convert the coordinates of poin...

A:

Q: 2. 27Vdc and total current I, is 30mAdc. Calculate the following using Ohm's Law and Kirchhoff's Cur...

A:

Q: Find State diagram in signal flow and block diagram format mÿ(t) + bý(t) + ky(t) = u(t) x, (t) = y(t...

A: We need to find out signal flow graph and block diagram for given system

Q: The shaft power of a shunt motor is 7.8hp. It draws 50A from 120 V. The field winding draws 1.2 Amp....

A:

Q: 5. Which of the following are vectors? a. Temperature b. Time c. Force d. Electric Field

A: Vector : Vector quantity will have both magnitude and direction. Scalar : Scalar quantity will have ...

Q: b) A certain winding made up of copper has a resistance of 100 2 at room temperature. If resistance ...

A:

Q: A Darrallel resonant RL C circui't has R =15Kr,L =3mH, C=2OUF Determine: The resonant Frequency The ...

A: When components connected in parallel then voltage across the components remain the same but current...

Q: 2 resistors in series (R1 = 50 ohms; T1 = 375 degree K) and (R2 = 120 ohms; T2 = 425 degree K). Dete...

A:

Q: 1. Given:wye-wye(balanced) Three phase generator impedance per phase:0.6+0.10j Three phase load impe...

A: In this question,  Balance star connected source delivered the power to balance star load through tr...

Q: In circuit analysis, explain the meaning of getting negative values for the current & voltages, in t...

A:

Q: C2 C1 4 uF 1 uF C3 3 uF C4 2 uF C5 2 uF Assuming the dielectric of each capacitor is air and the net...

A:

Q: Given the ff: What is Vo? * What type of wave shaping circuit is given? Provide the complete descrip...

A: According to guidelines, we are allowed to solve only first 3 subparts. So the MULTISIM simulation s...

Q: RcE 100 N RB Vcc 10 V 10k! 5 V

A:

Q: A single phase motor is rated 5hp, 75% pf lag,220V. What is the approximate size of capacitor is nec...

A: It is given that:P=5HPP=5×746P=3.730 kWV=220 Vpower factor,cosϕ1=75%cosϕ1=0.75Required power factor,...

Q: 6. Find the total charge inside the volume indicated: Pu = 4xyz; 0 < p < 2, 0 < ¢ <;0<z< 3.

A:

Q: If a fault occurs in connections C5 (stuck-at-1) for the following logic circuit, the appropriate fa...

A: The above figure shows a logic circuit in which many gates are interconnected together. At C5 fault ...

Q: The core of a simple de motor is shown

A:

Q: A 30-kVA, 230-V, 50-Hz, star-connected, 3-phase salient-pole synchronous generator supplies load at ...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Q3: Obtain the equivalent resistance seen by the source and find the power delivered by the source f...

A:

Q: Two single transformers are connected in V (open delta) and serving a delta connected impedance load...

A: Given information:. Two single transformers are connected in V (open delta) and serving a delta conn...

Q: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A an...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Q: 3. The formula for differential volume in a spherical coordinate. a. r2 sin 0 dr d0 dø b. r? sin ф d...

A: The spherical coordinate system can be represented as, Spherical coordinates are (r, θ, φ)

Q: Q. When the LED’s in the given figure will be ON? Explain in detail. Circuit diagram is attached.

A: The red LED needs ground so the NOR output should be 0 to glow. Similarly the green LED needs positi...

Q: 22 ww IT 52 6Ω 120 L 30 V Z, = 60 L 30 %3D j4 -j3 Det: (a) IT & IL ww ell

A:

Q: Continuous Phase Frequency Shift Keying is a binary FSK. Select the correct response: True False

A: The solution is given below 

Q: A 3 stage amplifier in cascade has the following parameters. Stage 1 has a gain of 7 and noise facto...

A:

Q: A d.c. distributor is fed at both the ends. At feeding point A, the voltage is maintained at 235 V a...

A:

Q: What is the speed of an electromagnetic wave in free space?

A: Electromagnetic Waves: A alterrnating electric field produces a alternating magnetic field and vice ...

Q: 3. Given: 22 ww IT 62 120 L 30 V ZL = 60 L 30 j4 -j3 Det: (a) IT & L

A:

Q: For an envelope with +Vmax = +43 Vp and +Vmin = +9 Vp, determine the peak change in the amplitude of...

A:

Q: 9. Determine the charge and the voltage across each of the capacitor in the circuit shown below. Con...

A:

Q: what are 5 applications of thermodynamics and gases in electrical engineering?

A:

Q: What is the output and output and state equations that describe * ?this clocked sequential circuit B...

A:

Q: Rc 100 ) RB 10 v 10k 5

A:

Q: Ad.c. distributor is fed at both the ends. At feeding point A, the voltage is maintained at 235 v an...

A:

Q: 2.14. The normalized radiation intensity of an antenna is rotationally symmetric in ø, and it is rep...

A: Directivity of antenna: It is the power density of the antenna and its direction is a maximum 3-dime...

Q: Q5/ Determine the values of i3, v4, i5, andv6 in circuit shown in Figure + v1 12 2 18 2 a b - U4 + 1...

A:

Q: vi. The frequency of the power supplied from the synchronous generator is fixed: (a) Due to the AVR ...

A: As per bartleby guideline for  vi The power that is supplied by the synchronous generator depends on...

Q: An 8-QAM transmitter is identical to an 8-PSK transmitter. Select the correct response: True False

A: The solution is given below

Q: 1. If the (volt/DIV)=5 and the input (20v) plot and discus the result.

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: 10 channel of telephone (PCM/ TDM) system has sampling frequency is 8 kHz and 16 level quentizer fin...

A:

Q: For the following magnetic core with an air gap and dimensions as shown in the figure. The depth of ...

A:

Q: For an unmodulated carrier voltage of 15 Vp and a +2 V change in the amplitude of the envelope, dete...

A:

BJT (Bipolar Junction Transistor)

A BJT is a semiconductor device with 3 terminals that consist of a p-n junction diode that can amplify the signal or current. It is a current-controlled device. The three BJT terminals are base, collector, and emitter. The BJT works with the charge carrier, the two type of carriers in the BJT are holes and electrons, the charge carriers flow by the process of recombination. The signal to be amplifier is generally given as the input at the base terminal and an amplified form of it is available at the collector terminal.