1- e For the circuit shown in figure 2, use nodal analysis to find the power supplied by the source 20V. 20 For the circuit shown in figure 2, use nodal analysis to find the power supplied bythe source 20V.20V304024012V( +Figure 2

The branch currents and nodal voltages of a network can be estimated using Kirchhoff's circuit laws.…

Answered: For the circuit shown in figure 2, use…

Engineering

Electrical Engineering

For the circuit shown in figure 2, use nodal analysis to find the power supplied by the source 20V.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.8MCQ: An ac resistance is higher than a dc resistance. True False

See similar textbooks

Related questions

Q: Use Kirchhoff’s current law to determine the unknown currents in the circuit of this Figure.Assume…

A: Given circuit is = Given values are =

Q: Determine the current through, voltages across, and the power dissipated by the circuit using…

Q: Q) Using nodal analysis, find curent i, and the power dissipated in the 4-ohm resistor in the figure…

Q: Q3) For the circuit shown, find the condition for maximum power transfer to the load. Then, find the…

Q: o Inen nosever 18OV

A: From the above figure data is as follows; The maximum power transfer takes place from when a load…

Q: figure below is a dc model of a residential power distribution circuit. (a) Use the node-voltage…

Q: Find the value of RL for max power transfer to RL in the circuit shown below, and calculate the…

A: In this question we need to find a value of load resistance so that maximum power is transferred to…

Q: For the circuit shown, calculate v1 + ö2 - 24 V

A: In this question , we will find unknown voltages V1 using KVL.... Kirchoff voltage law states that…

Q: 9. Determine the currents I1, I2, and I3 USING KIRCHHOFF'S LAWS 2 ohm ↑ ↑ 3 ohm 3 ohm I1 12 13 6 V 6…

A: Given answers are wrong.

Q: A pumped storage scheme has an upper basin which is 250m above the lower basin. The volume of water…

A: Given : The distance between two basin d =250m Power is the amount of energy transferred per unit…

Q: 9. Determine the currents I1, I2, and 13 USING KIRCHHOFF'S LAWS 2 ohm 3 ohm 3 ohm I1 12 13 6 V 6 V 3…

A: Find currents I1, I2, I3 using kirchoff's law?

Q: 12 www 125V 24s2 í2 3 122 is 125V

A: Always power developed = power dissipation

Q: V, V2 162 Z 322 20A

Q: Using the equivalent circuit derived, determine the currents I1, I2,I3 and I4 in the original…

Q: 9. Refer to circuit shown below, Determine: (a) The equation for Kirchhoff's Current Law (b) The 3…

A: In this question, Write down the KCL and KVL equations Value of the currents

Q: Using nodal analysis, determine voltages V1, V2, and V3 for the circuit shown below

A: As V1 and V2 form a super-node in the circuit, write the expression for the nodal analysis.

Q: 1. For the network shown in figure, using hevenin's theorem determine the current flowing through…

Q: Q2) For the circuit shown, find the condition for maximum power transfer to the load. Then, find the…

Q: 4. Determine the Z, which will allow maximum power to be delivered to the load in the circuit of…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: 2Ω R 2 2 R -5 Ω) ЗА

A: We have analysed the circuit and found the currents through all the branches using kcl.

Q: 12.18 Determine the total resistance and the current flow for the circuit shown in the accompanying…

A: We can redraw the given circuit as here the equivalent resistance Requivalent=9+9+6=24Ω

Q: Using Thevenin's Theorem, solve the current at the 4-ohm resistor and find the power absorbed by…

A: In this question, Using Thevenin's Theorem, solve the current at the 4-ohm resistor find the power…

Q: Use source transformation method to find the current at the 2 ohm resistor. Show complete solution

A: In this question , we will find current in 2 ohm resistor using source transformation method...

Q: 43: Use nodal analysis to find the power supplied by the current sources. R2

Q: Example 1.12: Find the currents and voltages in the circuit shown below using Kirchhoff's law 8Ω 30…

A: Kirchoff's voltage law is an important method to solve big and complex circuits. According to KCL,…

Q: Use loop analysis to determine the loop currents I1, I2, and I3. Calculate the voltage Vo

A: From the given circuit, the loop equations will be

Q: Using node Voltage Methode Find I1, I2, I3 V1, V2, V3

A: In this question we will find voltage across Resistances and current...

Q: 3. Write the loop equations for the circuit shown in the Figure below and calculate the branch…

A: Given circuit shown

Q: 4. For the power system shown, find short circuit level and short circuit current at th F1 & F2…

A: This is power system which have 2 generator and two transformer Find the fault level and fualt…

Q: For R1=15, R2=20, R3=10, R4=8, R5=45, R6=21, V1=31 V and V2=17 V in the shown circuit, the variable…

A: Given circuit, R1=15R2=20R3=10R4=8R5=45R6=21V1=31V2=17i0=0

Q: Compute for the currents per node as indicated in the figure below. Use KCL and KVL equations. Then,…

Q: Determine the current flowing and the power dissipated across 4-2 resistor using Source…

A: The solution is given below

Q: Consider the following circuit. How much power flows through circuit of element D?

Q: Problem 2 For the circuit shown, use Nodal Analysis to determine the values of the voltages Va, Vý…

Q: Find I1, I2, I3 using supwemwah method

A: The solution can be achieved as follows.

Q: Write the Kirchhoff's voltage equations for the circuit shown in he Figure below and hence find…

Q: 5 Using current division rule, find the source voltage for the circuit shown in figure If Whose 2 =…

A: Network analysis

Q: Using Kirchhoff’s Law, determine the currents (I1, I2, I3, I4, and I5) and power delivered to the…

Q: For the circuit shown below, determine the voltages Vab and Vdc - Hint: First find the current lo,…

A: If n number of resistor having resistance R1,R2.....................Rn is connected in parallel then…

Q: network containing three equal sources. Using Kirchhoff’s Law, find the current flowing in each…

A: In this question we will find current using KCL....

Q: Can you show how to calculate I1, I2, I3, I4, I5 currents using KVL and KCL laws ? Vs = 10 V

Q: Using Thevenin's theorem, determine the amount of current flowing in the load RL = 10 kΩ in the

Q: 3. Write the loop equations for the circuit shown in the Figure below and calculate the branch…

A: In this question, Write the loop equations, And find the branch current ?

Q: Write the nodal equations for the node volatges V1, V2, V3 on the circuit shown below. Simplify as…

A: In the given question we need to find a nodal equation of the given circle. In the given circuit…

Q: Find the branch currents in the circuit in the figure using the ambient current method. (11 =? , 12…

A: 3Q) Given

Q: 2. For the de network of figure, calculate the following. i) the indicated currents I, ,I1 and I2…

Q: Determine the current through 492 resistor for the circuit shown .Using loop method. 12V 20 1₂ 1202…

Q: Using Nodal Analysis Method, evaluate the currents through the resistors of the circuit shown

Concept explainers

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).

Question

1- e For the circuit shown in figure 2, use nodal analysis to find the power supplied by the source 20V. 20

For the circuit shown in figure 2, use nodal analysis to find the power supplied by
the source 20V.
20V
30
40
2
40
12V( +
Figure 2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2. An inductive reactance of 8 0 is connected in parallel with a capacitive reactance of 18 N; this combination is then connected in series with a variable resistance. For what value of resistance will the power factor be 0.5, and what current will the circuit takes if the impressed voltage is 118 volts?
Problem 5 For two electrical system shown in Figure 5, use cyclic currents to derive a complete mathematical model for each of the electrical systems. Ri. Rz ca) Cz (6) ERZ RI
Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,677 ohms R2 = 1,966 ohms L1 = 3 Henry L2 = 1 Henry Vs = 5 Volts Frequency = 55 Hz What is the Total Impedance (Amplitude) in ohms?
Oman- All Docume.. G flux type sign boar sf Career Oport The power factor of purely resistance circuit is Zero O Leading O Lagging Unity
When a voltage of 100V at 50Hz is applied to a choking a coil A, the current taken is 8A and the power is 120W, when applied to a coil B, the current is 10A and the power is 120W. what power will be is 10A and the power is 120W. what power will be taken when 100V is applied to the two coils connected in series?
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. What is the minimum AC voltage rating of each capacitor? Answer is 1200 volts. What is the current flow through the circuit? And what is the minimum kVAR rating of each capacitor?
The currents i and it in the circuit in the figure are 8.0 A and - 4.0 A, respectively. Vis 200 V. (Figure 1) Figure Part A Submit Part B Find ig Express your answer with the appropriate units. Value Va Request Answer 392 P⁹ P10 P30. P16 . Pii n. ps . P4. P15 = 502 m Units Find the power dissipated in each resistor. Enter your answers separated by commas. 15 02 m for Part A for Part Indo for Part redo for Part A reset for Part A keyboard shortcuts for Part A help for Part A 1102 ww TZ vec X for Part B for Part B for Part B for Part B 30 Ω ww 16 02 w 100 40 1 of 1 Vndo for Parts redo for Part B reset for Part B keyboard shortcuts for Part B help for Part B W
For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals a-b b) When a 5000 resistor is connected to terminal a-b, find the voltage on the resistor wwwwwwmm c) It will be connected to a-b terminals and its voltage on 5000 load will be 132 kV rms. What should be the capacitive reactance value that will increase it? wwwwwwwww d) What happens to the short-circuit current when the a-b terminals are short-circuited? 2+1202 000 m da 127/6 kV rms ob 1.5 +/902 000 w 12725 kV ms
An ac resistance is higher than a dc resistance. True False
Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l33.2AI4RT3.582R116R210R3R420PTP1P2P3P4
Can you help with subparts 11a-11c Consider the electric circuit in the figure below with the following parameters:ε1= 6.00 V, ε2= 3.00 V, R1= 500 Ω, R3= 100 Ω. 11a. What is the potential at point B? 11b. Calculate the current i3. 11c. Calculate the current i1. This is not and will not be graded This not incomplete
3. From the figure, when the voltage V3 is 10 volts, the voltage VZ1 is 5 volts, the voltage VD8 is 0.7 volts, and the resistances R7, R8 and R9 are 10, 50 and 100 ohms, respectively. Show the method. Calculate and answer questions in the following blanks. R7 D8 Z1 7 V3 RB R9 Current flowing through R7 : Answer.. Freckles flowing through Z1 : Answerŋ Current flowing through R8 : Answer.. Freckles flowing through D8 : Answen Current flowing through R9 : Answer.. Supply current V3 : Answerj