For the 8051 microcontroller: i) What is meant by the stack? State the default address range is normally used for the stack and explain problems could occur if too many items are pushed onto it. ii) How can a larger stack be employed and indicate how this could be set using assembly language? iii) Explain what is meant by direct and indirect addressing. Give an example of each

For the 8051 microcontroller: i) What is meant by the stack? State the default address range is normally used for the stack and explain problems could occur if too many items are pushed onto it. ii) How can a larger stack be employed and indicate how this could be set using assembly language? iii) Explain what is meant by direct and indirect addressing. Give an example of each

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter4: Processor Technology And Architecture

Section: Chapter Questions

Problem 2PE: If a microprocessor has a cycle time of 0.5 nanoseconds, what’s the processor clock rate? If the...

See similar textbooks

Similar questions

If a microprocessor has a cycle time of 0.5 nanoseconds, what’s the processor clock rate? If the fetch cycle is 40% of the processor cycle time, what memory access speed is required to implement load operations with zero wait states and load operations with two wait states?
Draw pinouts of 8088 or 8086 microprocessor (µp). Also draw schematics of 8088/8086 µp buses with Latch(s) [IC: 74LS373] and Buffer(s) [IC: 74LS245]. Write purpose of using latch and buffer ICs with µp buses.
In a few words, explain what the stack pointer register is and what it accomplishes.
We can design stack architectures, accumulator architectures, or general-purpose register architectures. Explain the differences between these choices and give some situations where one might be better than another.
What is Stack Pointer in 8051 MC? Explain the operation Describe the instructions that affect Stack Pointer
Consider the following examples. Registers for stack segment and additional segment. The control flag register and the conditional flag register are two different types of flag registers. Subject The Embedded System is an introduction to embedded systems. There is a difference between a logical and a physical address. What is the 8086 microprocessor's minimum and maximum mode?
in 80886 microprocessor Write an ALP to evaluate x.(y +z) where x = 10H, y = 20H and z = 30H and store the result in a memory location 54000H.
Please provide a brief explanation of the stack pointer register and the role it plays.
REAL MODE MEMORY ADDRESSING Find the memory location addressed by the microprocessor, when operated in the real mode, for the following segment register and 80286 register combinations: a) DS=8EBC & DX=A3D7 b) CS=DCAF & IP=FAC8
Programs for zero-, one-, or two-address architectures are generally longer (have more instructions). Why?
Q1: Suppose the initial stack pointer of the interrupt stack is 0x81009A90, what is the value of SP after the interrupt handler has pushed the general purpose registers onto the interrupt stack? Q2: What is the value of the PC right before the general purpose registers have been pushed? Q3: After the RFI instruction has completed, what is the value of the PC? Q4: After the RFI instruction has completed, what is the value of the SP?
3. Show the bit allocation for flag register in 8086 microprocessor. Explain shortly the meanings of letters used for each flag statues in Debug.