Find voltage gain, that is, Av = Vo1/Vi. hfe = 1600

Q: s to the nearest integer.

A: Current: I=dqdt Heat: H = I2Rt

Q: bit quantizer. Measure quantization SNR (dB), fc

A: Given signal as, xt=4 cos3000πt+2 sin4000πt, Samples= 6.

Q: a) Calculate the line currents, the power consumed (consider the internal resistance of the coil)…

A: As per Bartleby policy we can answer only one question at a time. Please repost it for other…

Q: A 11 Hp, 4-pole, 60Hz, 3-phase induction motor is taking 10,87 watts from the line. Core loss is 347…

A:

Q: For the circuit shown in figure   Calculate (a) the power factor (b) the average power delivered…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Calculate the equivalent impedance when 2₁ = 1 j2 &22=V2L45°2 A) 2₁ 22 Zeq 3 13 Zeq Z₁ 22

A:

Q: A DC motor has the following parameters: K₁ K₁-0.2 N-m/A, c-5x10 N-m-s/rad, R.-0.8ohm. (a) Assuming…

A: KT=Kb=0.2 N-m/Ac=5×10-4 N-m-s/radRa=0.8 ohmaAssuming steady state response, the no-load…

Q: = 240020° + 4. 1672 - 36. 86° (6 +j30) = 240020° +4. 1672- 36. 86° x 30.59278. 69° = 2494.97…

A: Given here a calculation part and asked to explain the calculation part. given V1 = 2400∠0° +…

Q: Q2) Determine the back e.m.f at this load of series motor has a series field resistance of (0.301 2)…

A:

Q: = If (IB = 18μA, Ic = 1.8 mA, VCE = 6v, VBB 8v) design a Base Bias circuit and ensure that the…

A: The required DC bias resistor can be calculated by using DC analysis of the amplifier circuit

Q: 6- The weekend was boring, (I didn't/ don't) do anything useful.

A:

Q: Find the values of v and i. v=-0.6 Vi=4.2A

A:

Q: Determine the approximate value of VDs of Figure 56. 18 V *** -94 6.71 V 5.94 V 4.48 M 3,92 V 750 k…

A:

Q: 3056+(8318 5. Simplify Z=(- +2318) - (1651-1356)

A:

Q: 01/1 Start/0 10/1 Down/0 Up/1 10/1 01/1 Left/1 Right/1 01/1 Stop/0 10/1 X₁X₂Z₂ State/Z₁ 00/09

A: Flip- flop is the electronic circuit. it is used to store the data in binary data. Basic flip flop…

Q: Q2: For the ideal op-amp shown in figure (2). Find: 1. The voltage gain A, = V₂/V₁? 2. The input…

A:

Q: A 3-phase load consists of three similar inductive coils, each of resistance 50 Ω and inductance 0.3…

A: (i) Star-connected The given load is a three-phase balanced load. When the load is star connected,…

Q: what is the kVA rating of the synchronous motor

A: Three Phase Synchronous machine- This Synchronous machine comprises of rotor and stator as it basic…

Q: In the network shown, what is the value of le in mA?

A:

Q: 0.1 vo 40 92 ww + is 20 Ω 50 µF 100 mH If is= 10cost(30t+20°) A, what is the value of vo(t)? USE…

A:

Q: Question 2: The following circuit is a square-Wave generator, Determine the Values of Rand R, Such…

A: The square wave generator This type generator is defined as an oscillator.  The square wave…

Q: a VI. 102 R. 2 d , (b) Si 20V 비아 R2 202 e 교육 C

A:

Q: 20 502 m SMF 2H ↓ + ilt) A) Find the Second order differental equation respective to the Capacitor…

A:

Q: EXAMPLE : Consider an OFDM system with total bandwidth B = 1 MHz assum- ing ß=&= 0. A single-carrier…

A: Consider an OFDM system with total bandwidth B = 1 MHz assuming = 80. A single-carrier system would…

Q: Modulator: High level AM Series modulator +Voc Audio modulating signal Qemitter follower RFC Q₁…

A: AM modulator- AM modulator is a modulator which is used used for the superimposition of low…

Q: The normalized signal m₂ (t) has a bandwidth of 10 KHz, and its power content is 0.5 Watts. The…

A: Modulation:- Modulation is the technique in which characteristics of the carrier is changed…

Q: A 1,300 kVA, 14kV, 3-phase Y-connected synchronous motor has a resistance of 4 ohms and a reactance…

A: A synchronous motor is one in which the rotor tends to rotate at the same speed as the rotating…

Q: sin 2t sin 5t S 1/1² ( x + + 3 2 s Option 1 s4 Option 4 None of the choices S s+7 10 58s² + 441 20…

A: laplace transform of given funtion is given as

Q: R₁ L₂ R₂ + с 100- Figure 3 L₁ Vo

A:

Q: A 10 KVA, 2400/240V, single phase transformer has the following resistances and leakage reactance Rp…

A: Transformer: It is static device and used for step up and step down the voltage level without change…

Q: (a) Use a 500nF capacitor to design a band reject filter as shown in Figure 1. The filter has a…

A: It is given that: C=500nFf=5kHzQ=4

Q: Use the analytical method, design a lossless L-section network to match a load impedance of 30+j15Q…

A: L-section  matching network:- This network consists one reactive element which is in series and also…

Q: A 1,200 kVA, 13kV, 3-phase Y-connected synchronous motor has a resistance of 3.59 ohms and a…

A: In this question we need to find a induced emf of motor at when fully loaded at 0.86 power factor…

Q: modulated signal that is passed through a white Gaussian noise channel is demodulated?

A: An additive white gaussian channel is that channel in which white noise gets added(superimposed)…

Q: . Using K- Map, simplify the following Boolean expression:

A: Code convertors- These code converters are used for conversion of one type of binary code to…

Q: (a) A Moore sequential circuit has one input X and one output Z. The output Z = 1 if and only if the…

A: (a) A Moore sequential circuit has one input X and one output Z. The output Z = 1 if and only if the…

Q: 6. A 5,000-kVA, 3-phase transformer, 6.6/33-kV, NY, has a no-load loss of 15 kV and a full-load loss…

A: In this question 3 phase transformer delta -star is given....We have to find out primary voltage…

Q: RB 1kQ2 IB V BE +Vcc=20V • Rc = 4.7 ΚΩ Ic IE RE= 10 kn -VEE -20V

A: given here a circuit and asked to check the approximation can be used or not. we know that VBE  =…

Q: Electrical Engineering 5. The following figure shows a resist pattern on top of a silicon dioxide…

A: Given: The following figure shows a resist pattern on top of a silicon dioxide film 1 µm thick. To…

Q: A series RC with R = 83-Ω and C =1-F connected across a 100 VDC source for a LONG TIME, what is the…

A:

Q: 1- Hi, we -------- Muna and Nuha. What is your name? a- are b- is c-am

A:

Q: A press's machine cycle is as follows: Lowering the ram: the ram is lowered when 0 The safety screen…

A: Here we discuss about ASM chart.

Q: Q2/ give an example of the following: 1. (Can) to express ability. 2. An offer by using (shall). 3.…

A: 1. Only he can do this assignment. 2. I shall go to his invitation.

Q: Q4-Chose the correct form of the verb (only 6) E. w year. 4-1 (speak/ am speaking) three languages,…

A: Given   Few multiple choice questions

Q: age was 11) What the voltage drop over three conductors (with resistance of 0.2 ohms per 50m)…

A:

Q: 4s + 12 s² + 8s + 10 4e-4t Option 4 4e¹t+ 4tet O Option 2 +4te-4t 4e4t - 4tet Option 1 None of the…

A:

Q: the equivalent Impedance. 201 Езмн 400 не 5m H

A: In this question we will find equivalent impedance of given circuit....

Q: A charge feels a 2.89 x 10-7 N force when it moves 288 m/s perpendicular (90°) to a magnetic field…

A: Given: Force on charge, F=2.89×10-7 N Velocity, v=288 m/s Magnetic field, B=2.77×10-5 T Angle…

Q: 3- A: Corona can be affected by some factors, list them stively

A: NOTE- According to the policy we can answer only the first question, kindly post other question as…

Q: -Find the value of (a) so that the given two vectors are orthogonal. u=-4i-8j+ak. v = 2 +4 j+5k .

A:

Power Amplifier

The power amplifier is an electronic amplifier designed to maximize the signal strength of a given input. The input signal strength is enhanced to a high enough level to drive output devices such as speakers, headphones, RF (Radio frequency) transmitters, etc. Unlike voltage / current amplifiers, the power amplifier is designed to drive core loads directly and is used as a storage block in the amplifier series.

Maximum Efficiency Criterion

In every field of engineering, there is a tremendous use of the machine and all those machines are equipped for their popular work efficiency so it very much important for operation engineers to monitor the efficiency of the machine, planning engineers to check out the efficiency of the machine before installing the machine and design engineers to design machine for higher efficiency than and then the utility will procure their products that will ultimately lead to profit and loss of the company. It indicates the importance of efficiency right from the initial stage as manufacturing units, intermediate stage as planning coordinators, and end-users stage as a utility.