Find the current taken by a 20μF capacitor when connected to a 220V, 50 Hz supply
Q: Draw the current waveform in the circuit below if the peak Voltage at the anode is 12V sinusoidal.…
A: The PUT is a type of thyristor that is triggered into conduction is voltage at anode exceeds voltage…
Q: An open loop control system results in -2t a response of € (sin5t+cos5t) for a unit impulse input.…
A: It is given that: xt=e-2tsin5t+cos5t
Q: Find the resonant freq. (in rad/s) and in Hz of the following parallelcircuit: 20μF capacitor in…
A: Given data: The capacitance, C1=20×10-6 F The inductance, L=1×10-3 H The resistance, R=7 Ω
Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…
A: Given data, Critical frequency fc=12.5 MHz. Angle of incidence i=650.
Q: 1. Find v, and va 10 Ω Μ 5Ω ΖΩ GA 4 Ω V2 Ο 34
A:
Q: Find the resistance of a helical coil as shown, where helix has a radius a, number of turns N, and…
A: Given, the rlradius of the helix, r=a Number of turns in helix, N axial length, l resistance of wire…
Q: The activation function in the example is assumed to be linear as f(x) = x. Repeat the example and…
A: We have to drawn update code functionthe given Activation Code function
Q: 2. Find the currents Is through Is and the voltage Vo 113 8 A ( 10Ω 20 Ω 12 30 Ω Ι 20 A ( 60 Ω
A:
Q: An electrical lamp is rated 120 volts, 500 watts. If the voltage applied across the lamp is twice…
A: Let us suppose that the base voltage is equal to the rated voltage and the base power is equal to…
Q: .Use Nodal analysis to find current flowing through all the branches in the following Circuit V₁ =…
A: In this question, We need to determine the current in the each branch using the nodal analysis. We…
Q: BASIC ELECTRICAL ENGINEERING (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO…
A: For calculating nortan equivalent short circuit the network between node a and b.the current flowing…
Q: Explain the environmental hazard of Nuclear power generation with neat diagram
A: Nuclear power plants use uranium as fuel. During the process of mining uranium released high amounts…
Q: In the system shown in the figure, r(t) = sin wt 16 s(s+4) r(t). c(t) The steady-state response c(t)…
A:
Q: Problem (Homework): A single phase full wave AC voltage controller supplies a resistive load. The…
A:
Q: 3V 5 V Figure 5 2V 4V
A: We need to find out the voltage for given circuit by using of KVL .
Q: 5.32 In the network as shown, with Is₁ = 5 A, IS2 = 10 A, VAB = 120 V, and with I₁ = 10 A, 152 = 5…
A: Given- Case (1): Is1=5 AIs2=10 AVAB=120 V Case (2): Is1=10 AIs2=5 AVAB=15 V To find- The value of…
Q: You acquire a 20 Hz analog signal from sensor. Now you need to digitalize it to process it on an on-…
A: . SOLUTION GIVEN f = 20 Hz ( Analog Signal from Sensor) LET…
Q: 10 10 μα R1 100 Ω | SNSPD L 100 nH R2 2ΜΩ S V 1. No photons have been incident on the detector for a…
A:
Q: Two balanced delta connected loads, with impedances 20cis(-60°) and 18cis45° respectively, are…
A:
Q: QUESTION 9 The output Lot Full Light will be energized when the accumulated count is: Ladder logic…
A: Given:
Q: 4. Find the IDFT of X[k] = [2, 4 + 4j, 14, 4 - 4j].
A:
Q: 1. As the potential across the resistor increased, the current through the resistor increased. If…
A: Given data: given that the potential across the register increased , the current through the…
Q: Briefly explain TNC-S earthing scheme as applied to earthing system design. (Hint: Support your…
A: Earthing is the process of connecting a power supply system's neutral location to the earth. The…
Q: H.W 1. a. Determine the thermal voltage for a diode at a temperature of 20°C. b. For the same diode…
A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…
Q: Find the transfer function, X2(s)/F(s) for the given translational mechanical system. (Non-anonymous…
A:
Q: Blank Use the Norton equiplent circuit to determine the power dissipated by 50.2. олог 25.12 wwwww…
A:
Q: Problem 3 Voltage in Mutual Inductance 4H K 8H m 6.12 3VⒸ Diz V Di, 1252 2452 316H, Diz Write the 3…
A: In this question, We need to determine the mesh current equations. In this circuit, mutual…
Q: Critical Damping A motor coil having an inductance of 8 H is in parallel with a 2 µF capacitor and a…
A: It is given that: L=8 HC=2 μF
Q: Find the transfer function, 02(s)/T(s) for the given rotational mechanical system. (Non-anonymous…
A:
Q: EX// Ageneration Stion of 10 MW supply region of two consumers A and B when the varation of the load…
A: Solution:
Q: Minimize the following boolean function- F(A, B, C, D) = Em(1, 3, 4, 6, 8, 9, 11, 13, 15) + Σd(0, 2,…
A: We need to find out simplified Boolean expression for given Function .
Q: (a) For the following network, derive an expression for the system reliability in terms of the…
A:
Q: G(f) = 3e jπ(3f) 4+π² (3f)²
A:
Q: For a certain source-free parallel RLC circuit, R = 1 ks, C = 3 µF, and Lis such that the circuit…
A:
Q: Separate the imaginary term: S=jw S2=w2
A: ffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffffff…
Q: Find the resistance of an annular wedge of conducting material, assuming the current flow is radial…
A: A form consisting of two circles is essentially what an annulus or the annular area is. It is a…
Q: 12VTE, M R₁ R₂ 5V ww FE₂ ww R3 ww R4 =RL R5 12V-TE3 R₁ = 1.0 k2 R₂ = 2.2 k R3 = 680 52 R4 R5 = = 470…
A:
Q: Given the equation above, why is the encircled term equated to zero for the function to be real?…
A: Given: Gω=LR2jωR1R2-R1R2LCω2+jωR1L+R2L
Q: 5.47 The circuit in Fig. 5.79 is for a difference amplifier. Find v, given that v₁ = 1 V and v₂ = 2…
A:
Q: Given an input square wave with +15V and -15V peaks, and bias voltage V of 3V. Diodes are ideal.…
A: Given: Input is of square wave with +15Volts and -15 Volts, V1=3 Volts, R=330 Ohms,
Q: In the circuit below, a constant voltage source of 8 V is applied at t = 0. Find all branch voltages…
A:
Q: Figure 1 shows a single line diagram of a part of the three-phase power system. The ratings of the…
A: Given We have to draw per unit equivalent circuit with base values Vbase,new =13.8 kV MVAbase, new…
Q: Homework: HVDC multiplier circuit has 5 stages, C = 0.12 uf, f = 1khz, V supply 50kv. I = 15mA. Find…
A:
Q: To sketch the characteristic curve of the diode you need to vary voltages on diode and measure…
A: The diode conducts only during the forward bias and, it will not operate during the reverse bias.…
Q: The circuit of Fig. 9.2 is modified substantially, with the resistor being re- placed with a 1 k2…
A: Given that, R=1kΩ L=7mH C=1nF Energy stored in capacitor=7.2mJ We have to calculate resonant…
Q: 3. Simplify the circuit below so you can use voltage division to find vx. w 4Ω 10 V www 3Ω 4Ω 12 Ω
A:
Q: 2. Determine the inverse Fourier transform of the following functions: a. y(0) = 1/(3 + jo) h…
A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…
Q: Which of the following represents the phasor form of a uniform plane wave travelling in Teflon (μ₁ =…
A:
Q: Question 2 Given v₁ = 10V, v2 = 14V and v3 = 12V, find in and the current-controlled voltage source…
A:
Q: Vin (+) tov 472 8200 1008 1205 2205 Using KCL, show that, at each node the total urrent flowing into…
A: According to Kirchhoff's Voltage Law(KVL), the voltage inside a closed loop will be equal to zero.…
Step by step
Solved in 2 steps
- Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
- What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwattA postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
- You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
- What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.